变化系数

3In the normal space tensile,after controling the influence of density, the variation ofmicrofibril angle had a decisive effect on L MOE and longitudinal tensile strength of D333A wood microtome section; the Correlation coefficient between microfibril angle and L MOE became significant at 0.05 level for D1123A wood microtome section; the Correlation coefficients were all unsignificant between microfibril angle and L MOE and between microfibril angle and longitu- dinal tensile strength to D1223A wood microtome section.

正常间距拉伸中，控制密度的影响后，微纤丝角的变化对D333A组微切片纵向MOE和抗拉强度的变化起着决定性作用；对D1123A组微切片纵向MOE的相关系数达到0.05水平上显著；对D1223A组微切片纵向MOE和抗拉强度都成负相关关系，但都达不到显著水平。

As compared with the traditional irrigation-traditional fertilization, the following results of the improved optimized irrigation-optimized fertilization were obtained: significantly higher nitrogen use efficiency; the like tiller number per unit area, percentage of the tiller ear number/the tiller number, the ear number per unit area, the greatly reduced grain number per ear, and significantly heavier weight of 1, 000 grains; a trifle taller plants; shorter base internode length, a bit more weight per unit internode length, longer internode length under ear; almost the same LAI values in middle and later stages; coincident process of dry matter accumulation from straight growth onwards, a little more dry matter accumulation amount from earing to maturity; a little longer flag leaf, 2〓 leaf, 3〓 leaf (but the three leaves were shorter than those of the optimized irrigation-traditional fertilization) and shorter 4〓 leaf from top, a bit reduced total area of these leaves; almost the same leaf thickness, mean canopy leaf tilt angle, light extinction coefficient , ratio of light penetration in the upper, middle and lower parts of the wheat canopy, and fair plant type; almost the same senescence process of flag leaf; and increased root amount in 0-120cm soil layer and smaller rate of progressive decrease of the root length density and root weight density with soil getting deep, which can strengthen the resistance to adverse conditions such as water stress in the later stage.

在优化水肥条件下，冬小麦总分蘖数、成穗率及单位面积穗数与传统水肥比较接近，但穗粒数显著减少，千粒重显著提高；株高稍有增加；基部节间长度缩短，充实度略微增高，穗下节间增长；中后期LAI与传统水肥的LAI值基本吻合；起身至成熟干物质积累量动态变化过程与传统水肥十分接近，但抽穗至成熟所形成的干物质量增加；上三叶变长（但上三叶长度增加幅度小于优化灌溉-传统施肥处理），倒4叶变短，总叶面积略有减少；叶片厚度、冠层平均叶倾角、消光系数、冠层各层的透光率与传统水肥差异很小，株型较好；旗叶叶绿素含量动态变化与传统水肥十分接近；0-120cm土层的总根量明显增加，上层根群和深层根群的差异最小，有利于提高小麦后期的抗逆力。

The calculation of carbon stock changes for the purpose of accounting for harvested wood products, if so elected, on land that is to be accounted for under either reforested land or elected forest management land shall be based on the total increment of carbon stock growth in the eligible forest minus any changes in soil carbon, minus carbon stocks left over from timber harvest activities, minus carbon stocks from any wood residues from wood mills, minus carbon stocks from wood products used for the purposes of paper, wood chips or other short-lived wood products, minus a carbon release estimate of harvested wood products produced and then destroyed during the commitment period, times a conversion factor from carbon to carbon dioxide equivalent.

如经选定，为了对伐木制品进行核算，对再造林土地上或选定的森林管理土地上碳储存变化的计算应基于以下方式：符合资格的森林中碳储存的增量总额减去土壤碳的任何变化量，减去伐木活动余下的碳储存，减去木材厂木渣的碳储存，减去用于造纸的木材产品、木屑或其他短生命周期木制品的碳储存，减去在承诺期生产但后又破坏的伐木产品的估计碳释放量，乘以从碳到二氧化碳的换算系数。

In this thesis, the phase diagram of Zn-Al binary system on 10~69.5 w% was reinvestigated by using differential scanning calorimeter, X-ray diffraction and pushrod dilatometer. The process of isothermal transformation during the aging of high-Aluminum-Zinc-based alloy was studied by using differential scanning calorimetry, and the aging behavior of the alloy was analyzed at the aspect of thermal analysis kinetics. The change of microstructure which the alloy was being heated was observed on high-temperature metallurgical microscope. The microstructure and wear-friction properties were compared among the alloys treated with several different heat treatment processes, and a model for heat treatment processes was proposed based on artificial neural network,so as to predict the relationship between friction coefficient and parameters of aging treatment such as aging temperature and time.

本文采用高温X射线衍射、示差扫描量热分析、热膨胀等方法重新测定含锌量范围为10％～69.5％的Zn-Al系二元相图，利用示差扫描量热分析法，研究高铝锌基合金时效等温转变过程，并从热分析动力学的角度分析高铝锌基合金合金时效行为；使用高温金相显微镜观察合金加热时的组织变化；比较几种不同热处理工艺对高铝锌基合金显微组织与耐磨性能的影响并利用人工神经网络建立高铝锌基合金热处理工艺模型，预测合金摩擦系数随时效温度及时间变化规律。

There is excellent agreement between theory and data for the field of ME coefficients.

分析表明由磁场和频率变化导致的ME系数变化的实验值与理论值符合的很好。

The calculation results show that the temperature of the valve cone changes periodically, leading to thermal stress changes periodically, which is the main reason of the valve cone pit corrosion; the operating temperature of the valve can be reduced by using the higher thermal conductivity materials; at the Same time, 3-D FEM provides a good theoretical basis in the process of the design and improvement for the parts of ICE.

计算结果表明：气门锥面处周期性的温度变化，会导致周期性变化的热应力，是导致气门锥面疲劳点蚀的主要原因；采用较高导热系数的材料可降低气门的工作温度；同时，三维有限元法能为内燃机零部件的进一步设计改进提供很好的理论依据。

Physical model of computer box is established and through analyzing the changing curves of change of electromagnetic field with time and change of coupling coefficient with frequency, the coupling regulation of electromagnetic on computer box is obtained. It is as follows: electromagnetic pulse has a great effect on components of computer box through apertures and slots, the coupling energy in the box increases first and then decreases. The existence of components decreases the shielding effectiveness and resonant frequency.

建立计算机机箱的物理模型，通过分析机箱内的电磁场随时间的变化曲线和耦合系数随频率的变化曲线，得到电磁脉冲对计算机机箱的耦合规律：电磁脉冲可以通过孔缝进入机箱内部，对机箱内元件的瞬间影响较大；机箱内的耦合能量是先增加后减小；元件的存在使得机箱的屏蔽效能降低，谐振频率下降。

Power reflecting characteristic of a microwave drying chamber was investigated under the uniformly spread loading condition, i.e., with plane loads.

对均匀平铺的典型载荷条件下微波干燥室的反射特性进行了研究。干燥室的功率反射系数随微波干燥室内载荷情况的变化而变化。

Analysis is made on variable property of air-conditioning load, study is made on energy regulation method and COP varied regularity with rotating speed of engine-driven air-conditioning system, interpret the unit load distribution.

对空调负荷的变化特性进行了分析，研究了发动机驱动空调的能量调节方法及性能系数随转速的变化规律，对机组的负载匹配进行了说明。

The variation of freezing rate and thawing rate in the process of repeatedly freezing and thawing explained by the variation of the thermal conductivity.

利用导热系数在冻融过程中的变化解释冻结速率和融化速率在冻融过程中的变化。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。