变化点

The spacing triangulation was achieved by restricting the angle between two adjacent triangle's normals, which can decrease or increase the data efficiently, varying with the surface's curvatures, added to the optimizing local triangulation, and uniform and smooth triangulation are obtained.

该方法从插值曲面的形状变化来考虑，根据空间离散点曲面的曲率变化有效地剔除或增加离散点，实现了离散点曲面的疏密三角网格划分。

Results showed that the change of photosynthesis of the first whorl of leaves was similar generally between the stock and the cion, changing from leaf discolor, grey green, stable to senescent stages, and that the max net photosynthetic rate P(superscript max, photosynthetic saturated light intensity and chlorophyll content of the leaves changed continuously with the phenophases, which rose rapidly and then dropped slowly after the peak, whereas the change of their light compensation point was just the opposite.

结果表明，橡胶树籽苗芽接苗砧木和接穗第1蓬叶的光合特性变化规律基本相似，从变色期、淡绿期、稳定期，到衰老期，其叶片的表观量子效率、最大净光合速率P(下标 max、光饱和点和叶绿素含量等均随着物候期变化而不断变化，变化趋势为先迅速升高，达到最高值后缓慢下降；光补偿点的变化趋势则相反。

Firstly, This paper processes geometry filtration based on character of orbit's apogee and perigee after orbit model is analyzed and based. Secondly Space Debris is separated into two kinds, coplanar and not coplanar according as location interrelation of target and debris. In Dynamic filtration's processing, considering prediction time limit and orbit perturbation, secular effects which have increaser effect is considered so that some need catching danger time point is appeased, some law about time when target and debris pass intersectant line each other is inferred, when debris and object are in different plane and some similar law also is inferred otherwise. The time list is arithmetical progression. These laws can improve calculation efficiency remarkably; Lastly orbit predict is a course approaching least distance. Danger time point in the last step become beginning time point from which debris and object's position and velocity are calculated by SXP4 Model which is an analytic model.By result, determine that relative movement trend is closer or apart, farther calculate the interval apart from time when predictive least relative distance occurs. Least relative distance and time when least distance occurs is calculated finally. It is a fast approach course adopting varied interval.

本文在分析、建立轨道摄动计算模型的基础上，首先采用基于轨道远、近地点特征对大量编目在册的空间碎片进行初步几何静态筛选，然后根据碎片与目标轨道面的相对位置特点把碎片分为异面与准共面两种情况以进行动态筛选，在筛选过程中考虑到预报时限长度和轨道摄动影响，引入了轨道摄动中具有积累效应的长期项以满足危险时间点的捕捉要求，利用了长期项摄动变化线性的特点导出了碎片与目标异面情况下各自过交线的时间序列成准等差数列的规律性和准共面情况下类似的规律性，从而显著地提高了前期轨道筛选的计算效率；最后对剩余危险碎片和目标飞行器利用SXP4轨道预报模型在前期轨道筛选的基础上以各个危险探测时间点为预报的时间起点，并根据预报计算结果，分析目标和碎片在该时间点的运动趋势是相互远离还是相互接近，推出预计最小相对距离发生时刻相对此刻的时间长度，得到其随时间变化的局部最小相对距离以及危险距离发生的时刻和相对速度，这是一个采用变时间步长、快速逼近最小相对距离的过程。

Aimed at the characteristic of multiple types of faults possibly happened in nuclear power plant, large scale of training sample, and requirement of quick and accurate diagnosing, after the analysis of large sample number generated by large fault type exceeds limitation of 64K paragraph in DOS and large number of local minmum in error surface, measurements of same format of data file, Win95/NT operating system platform, resetting weight learning rate, dynamic training set in quick learning algorithm and improvement on quick learning algorithm using homotopy method which can avoid local minmum points in error surface have been adopted to ensure quickly and effective process of the course of neural network's training and testing.

针对核动力装置可能发生的故障种类多，训练样本规模大，故障诊断需要快速准确的特点等，分析了样本多和故障种类多产生的训练样本量超出DOS段大小和网络误差曲面上局部极小值多的情况，采取了使用相同格式数据文件、Win95/NT操作系统平台，对快速学习算法采用重置神经网络权值学习率和动态训练集、并采用能够有效克服网络误差曲面上局部极小点的同伦方法对学习算法进行改进等措施保证神经网络训练测试过程的快速、有效地进行；针对装置发生的故障须快速、准确诊断的需要，分析了故障的产生对装置参数变化的影响及操纵员对故障诊断的基础，在核动力装置发生故障时参数曲线的变化量与正常运行时参数曲线的变化量存在明显差异的基础上，提出采用参数曲线的变化量作为神经网络的输入，并围绕参数变化量的方法采用二次曲线拟合滤波求变化量和阈值技术来保证神经网络得到精确的装置参数变化量，从而得到准确的诊断结果。

It is shown that the electron density of each lattice point is the same although the electron state density varies with the lattice point.And the chemical potential is equal to the atomic energy level as well.

计算结果表明，虽然各态的电子态密度随格点位置变化而变化，但在任意温度情形下，各格点处的电子密度是相同的，纳米晶体颗粒电子的化学势等于格点原子能级。

Angular spectral is spectral value map formed by estimating semblable coefficients of fast and slow shear wave or the variation of amplitude ratio of fast and slow shear wave with times and angles at a specified space point based on semblable theory of fast and slow shear wave, the angle value of this space point at a given time can be got by picking the maximum of angular spectral; the study reveals that fast and slow shear wave with different polarization direction should be separated using different rotation formula, eight formulas of separating fast and slow shear wave using clockwise rotation and counterclockwise rotation have been derived, and gained energy assignment rule and phase coincidence rule, in real data estimation, the rotation formula used for separating fast and slow shear wave can be uniquely determined on the two discriminating rules. On the basis of semblable theory of fast and slow shear wave, the delay time corresponding to the maximum of semblable coefficients at a specified point in a given time window is the delay time of fast and slow shear wave, delay time section of fast and slow shear wave can be got by moving space point and smoothing time window. The vertical variation values of delay time of fast and slow shear wave reflect the effect degree of vertical fractured reservoir on fast and slow shear wave which is defined as anisotropic coefficient, and section map of anisotropic coefficient can be obtained.

角度谱就是利用快慢横波的相似性原理，在某一空间点求出快慢横波的相似系数或快慢横波的振幅比值随着时间和角度的变化而形成的谱值图，拾取其极大值就得到该空间点某一时间的角度值；在研究中发现分离不同偏振方向的快慢横波应该采用不同的旋转公式，推导出了利用顺时针旋转和逆时针旋转分离快慢横波的八个公式，并给出了能量分配准则和相位一致性准则两个判别准则，在实际计算中利用这两个判别准则能唯一地确定分离快慢横波的旋转公式；根据快慢横波的相似性原理，在某一给定点和给定时窗内最大相似系数对应的延迟时间就是快慢横波的延迟时间，随着空间点的移动和时窗的滑动就可以得到快慢横波延迟时间的剖面图；快慢横波延迟时间与慢横波传播时间的比值定义为裂缝密度，并求出了裂缝密度剖面图；快慢横波延迟时间纵向上的变化值的大小反映了纵向上裂隙层对快慢横波影响的大小，定义为各向异性系数，并求出了各向异性系数的剖面图。

Only when the flow rate of steam is more than this point, can back pressure turbine be used.

从经济的角度而言，以蒸汽流量为判据，两种设备的应用有一个经济出力分界点，只有当蒸汽流量大于该分界点时，采用背压汽轮机才是有利的，且该经济分界点随着电力价格和电热比价的变化而变化。

This system mainly contains the front-end pulse interception and back-end software analysis. In the first part, we used a non-invasive infrared measurement method based on the dual channel simultaneous measurement technique. We measured the photo-plethysmograph from the subject's fingers and toes simultaneously, then used an analog circuit and central control unit to process the signals. Finally, the digital volume pulse data is processed by a personal computer. Because the characteristic points of digital volume pulse always occur in sharp variations, this paper proposes two algorithms to solve this problem. First, we find the pacemaker and percussion wave peak from transient slope variation, and then locate the dicrotic notch and dicrotic wave peak by using the wavelet transformation algorithm. When we analyze the data, we use the Visual Basic graphical user interface, which together with the Matlab is the core of the system.

本系统主要包含前端脉波撷取及后端软体分析两部分，其中前端脉波撷取部份是以非侵入式的红外线量测方式，双通道同步量测受测者手指与脚趾的光容积变化描记图，同时将此讯号经类比处理电路及中央控制单元输出成为数位容积波，再传送至个人电脑中；而在后端软体分析部份，因数位容积波之特徵点皆出现於波形中急剧变化的部份，故本论文以瞬间斜率变化量来定位脉波讯号中的起搏点及主波峰顶点，并利用小波转换演算法（wavelet transformation algorithm）来分析重搏切迹与重搏波顶点；程式撰写主要以Matlab为核心，结合Visual Basic的图形化使用者操作介面，增加系统与使用者间的亲和力。

In this paper, we analyzed the firing results in one 57H Gun with six different ignition al structure such as igniter in bottom, centre ignition tube closed by computer typing paper,and so on at conventional and low temperture condition.

密实火药床的点传火技术研究李锋，张振铎（华东工学院工程热物理系南京210014）关键词：点传火，燃烧，装药一、引宫火炮在不同环境下射击的弹道性能变化很大，一般线膛炮在十50&C—一40&C范围内，胜压变化40％以上，初速变化10％左右。

The power of motor is positive proportion to square root of equality of square pure torque .the pure torque is combined by suspension point torque and balancing weight torque ,so the change of suspension point's motion law and balancing weight offset angle can causes pure torque variation .especially, the suspension motion law is decided by configuration curve of hinder heaven sheave .so the paper has emphatically studied and analysis the law that the configuration curve of hinder heaven sheave brings the change of pumping unit energy-saving .

电机功率与减速器曲柄轴净扭矩均方根成正比，减速器曲柄轴净扭矩是由悬点载荷产生的扭矩和平衡重产生的平衡力矩合成的；改变悬点运动规律和平衡重的滞后角可以引起净扭矩的变化，其中悬点运动规律是由后天轮曲线决定的，因此，本文依据此原理着重研究分析了后天轮曲线影响抽油及节能的变化规律。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。