受压

In this paper, the construction technique of mixed backfill such as inspection, spread , and grinding etc.

分析了沥青混合料摊铺特征和碾压规律，以及不同摊铺方向和不同碾压振动方向时路面的受力状况，指出了摊铺方向和碾压振动方向对沥青路面路用性能的影响。

With the electrical connections at the top and bottom side of the wafer-level IC packaging Lead-frame structure and composition of the surface-mount semiconductor package structure Multi-layer printed circuit board Antifuse and its formation method and with the anti-fuse non-volatile memory device unit cell Tandem electric signal processing circuit and electronic device Light-emitting diode packaging structure and encapsulation method Electronic Packaging Structure Flip-chip high-speed optoelectronic components and structure Pairs of piezoelectric friction side by side to promote the three-step device and scanning probe microscope Light-emitting diode and its manufacturing method, the production base of light-emitting diode method Three or four parallel advance of stepping piezoelectric device and scanning probe microscope lens body Silicon substrate and its manufacturing method Semiconductor device and voltage-divider A polysilicon layer and the microcrystalline silicon layer of the double-substrate active layer structure, methods and devices The edge of the thickness of silicon controlled Of a lateral semiconductor devices and high-voltage devices With a vertical-channel transistors semiconductor device Of a memory array and for the manufacture of a memory array method Read-only memory cell array structure Active-matrix substrate and display device High-voltage semiconductor integrated circuit devices, dielectric isolated type semiconductor device Image sensing devices Lens module and its manufacturing methods Solid-state imaging device and camera Injection angle for the trench isolation Organic Light-Emitting Display Device Organic light-emitting display device Bipolar transistor structure of the surface passivation Double-triggered silicon-controlled rectifier HFET Metal-oxide semiconductor transistors Self-aligned trench accumulation mode field effect transistor structure Thin-film transistors and Display Devices TFT Lead Diode Low-frequency, low noise, low-flashing diode Used for thin-film solar cells trap light structure Transparent sun solar cells Quaternary semiconductor heterojunction photovoltaic cells heat Si nano-pillar array heterojunction thin-film solar cells GaN-based micro-composite solar cells isotope Optical sensor Semiconductor by optical components Imaging Detector Transparent conductive oxide coating Silicon-based high-performance dual-junction solar cells Thin-film solar cells Alien LED Devices

非专业，不在行，求高手帮忙。谢谢！具有顶部及底部侧电连接的晶片级集成电路封装导线架结构及其构成的表面黏着型半导体封装结构多层印刷电路板反熔丝及其形成方法和具有该反熔丝的非易失性存储器件的单位单元串联用电式信号处理电路及电子装置发光二极管的封装结构及其封装方法电子封装结构高速光电组件及其芯片倒装结构双压电体并排推动的三摩擦力步进器与扫描探针显微镜发光二极管及其制作方法、发光二极管的底座的制作方法三或四压电体并行推进的步进器及其扫描探针显微镜镜体硅衬底及其制造方法半导体装置与分压电路具多晶硅层及微晶硅层的双底材主动层结构、方法及装置硅晶片的受控边缘厚度一种半导体横向器件和高压器件具有垂直沟道晶体管的半导体器件一种记忆体阵列及其用于制造一记忆体阵列的方法只读内存单元阵列结构有源矩阵基板和显示装置高耐压半导体集成电路装置、电介质分离型半导体装置图像感测装置透镜模块及其制造方法固态成像装置和照相机用于沟道隔离的斜角注入有机电致发光显示装置有机发光显示装置双极晶体管的表面钝化结构双触发型可控硅整流器异质结场效应晶体管金属氧化物半导体晶体管自对准沟槽累加模式场效应晶体管结构薄膜晶体管及显示器件薄膜晶体管无铅二极管低频、低噪音、低闪烁的二极管用于薄膜太阳电池的陷光结构透明遮阳太阳能电池片四元半导体的异质结热光伏电池硅基纳米柱阵列异质结薄膜太阳能电池氮化镓太阳能同位素复合型微电池光学传感器半导体受光元件成像探测器透明导电氧化物涂层硅基高效双结太阳能电池薄膜太阳能电池异形LED器件

Experiment shows that both the dry plate pressure drop and the wet plate pressure drop increase with the increase of the kinetic energy factor in plate hole but have no influence of the height of cap. The wet plate pressure drop linearly ascends as the clear liquid height increases. Liquid lift-up increases at first then decreases with the increasing of the kinetic energy factor in plate hole, increases with the clear liquid height increasing and the height of cap decreasing, but as the kinetic energy factor in plate hole increased, the influence of height of cap will gradually decreased.

实验表明干板压降、湿板压降均随板孔动能因子的增大而增大，不受罩体高度变化的影响，湿板压降随清液层高度的增大而增大，成正比关系；液体提升量随板孔动能因子的增大先增大后减小，随清液层高度的增大而增大，随罩体高度的增大而减小，但随板孔动能因子的增加，罩体高度的影响逐渐变小；漏液量随板孔动能因子的增大迅速减小，随清液层高度的增大而增大，但接近漏液点时清液层高度的影响不明显。

Because of the arch effect, the local bearing strength and the tributary area of locally bleared masonry under load_bearing wall between windows are different from the common masonry, and the calculation formula is put forward and has been revised.

根据混合结构承重窗间墙窗过梁下的局压砌体的内拱效应、局压强度、受荷面积不同于一般楼盖梁端局压砌体的特点，对其承载力计算公式提出探讨并作修正，较好地反映实际情况，同时需作进一步试验和研

The homodynamic studied on dogs in narcotics show that the mean artery pressure ;ventricular pressure maximal change rate decrease, the left ventricular press ; ventricular pressure maximal change rate ; Coronary blood flow; cardiac output increased after treatment of HISI while left ventricular end diastolic pressure decreased in dogs.

对麻醉犬血流动力学的考查表明，静脉注射苦碟子氯化钠注射液使受试犬平均动脉压、左室内压正向最大变化速率降低，左室内压负向最大变化速率-dp／dt_(max升高，左室舒张末期压降低，左室内压，心输出量及冠脉输出量增加。

Hydraulic cylinder driving plate is adopted, thus the glass is stressed evenly and the pressing is made even, ensuring the pressing quality and greatly improving the rate of qualified hollow glass products.

采用液压缸驱动板压压实，玻璃受力、压合均匀，保证了压合质量，使中空玻璃产品合格率大大提高。

On the foundation of understanding the structures and operating principles of filter press, the design calculation of the main structures was analysed, including the filter board and draw-plate and so on, and the improvement design of the control system and filter mechanism was accomplished in this thesis.

论文在了解压滤机的结构和工作原理的基础上，分析了压滤机主要结构的设计计算，包括压滤机滤板和拉板的受力等，完成了对压滤机控制系统和过滤机构的改进和设计。

It analyzes the effects of the pollution severity and the altitude or atmospheric pressure on the flashover voltage or the flashover gradient. It is shown that FOV is determined by the configuration, and the insul...

结果表明：合成绝缘子的污闪电压与伞裙结构有密切关系；在同样的最短干弧距离下，简单伞形结构的合成绝缘子具有更高的污闪电压和污闪梯度，对于伞形结构复杂的合成绝缘子，虽然其爬电距离提高了，但其污闪电压没有明显提高；高海拔下合成绝缘子的气压影响特征指数n大于瓷和玻璃绝缘子，并受伞裙结构形式、污秽程度的影响，且随着污秽程度增加，n逐渐减小，此外，染污方法和方式对n也有一定影响但不明显。

Crimping toe transfer trip-free design, not the slightest temperature, the effect of pressure, do provide a very stable pressure focus.

鞋头压着行程免调设计，丝毫不受温、压差之影响，确实提供极稳定之压着力。

A new anchorage system for girder to obtain pretension stress at section top-edge in middle of span is shown. Based on the research of bi-prestressing beams inside test-room and the test of the prestress bar character, method for calculating the full size gird and choosing section are proposed. A new-style corrugated pipe which is shown in the paper is used, to solve the transformation of compressed thread bar and the contradiction between loss of friction resistance and pumping in pipe.

本文通过大量的试验及研究分析，提出了双预应力梁跨中上缘获得预拉应力的新的传力锚固体系；通过对室内双预应力混凝土小梁的研究，检测了预压钢筋的受力性能和预压过程中的某些影响参数；提出了足尺梁计算方法和截面、跨径选择方法；研制了新型哑铃型波纹管，很好地解决了预压钢筋变形、摩阻损失和管道压浆之间的矛盾；通过对30？

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。