取样位置

The results suggest that natural TL of the three samples with known depth positions had depth distribution such as meteoritic cosmogenic nuclides, which was smaller with increasing distance from the current surface, indicating the conditions of cosmic ray exposure of the Jilin chondrite.

对3个已知取样深度和3个未知取样部位的吉林陨石样品的热释光研究表明，其自然热释光值具有宇宙成因核素含量相似的性质即深度分布效应，随着样品距离表面位置的增大而降低，这表征了母体暴露期间宇宙射线的分布状况。

Comparing with the previous stimulus-response method with only one sample port, the new method has the advantages of more reliable, simpler algorithm and more flexible for position of the sample ports.

与一点取样的动态响应曲线法相比，新的两点动态法具有数学模型的边界条件简单，对取样点的放置位置比较灵活，结果可靠等优点。

Results In different seasons cooling conditions,a different location on the same sterilization 5Qiangjia base fur fural content different.

5羟甲基糠醛检测取样位置在灭菌车次上层中央位置；夏季高温季节要注意灭菌后降温。

Heat flows derived from garnet, chromite/chromium-spinel and pyroxene of xenoliths, xenocrysts in Mengyin and Fuxian kimberlites are higher than 40mW/m〓 calculated from the pyroxene inclusions in diamonds, and the range of pressure is 20～40kb (equivalent to 65～130km). Metasomatism (as indicated by yimengite and lindsleyite in Mengyin) is very strong in this depth range. Lherzolite, wehrlite, and diamond-free high-Ca harzburigite around the world are derived from this depth also. The observation suggests that the low-Ca harzburigitic environment for diamond stability had been changed significantly when the kimberlitic magmas erupted. This resulted from fluid interaction with harzburigite. The geotherm of the Cenozoic lithospheric mantle beneath Eastern-North China platform is higher than oceanic one. The temperature from the interior of the Tan-Lu faults is higher than that from apart off the fault.

除金刚石中的辉石温压投点落于40m W/m〓占地温线上外，捕虏体及捕虏晶中石榴石，铬尖晶石及单斜辉石的投点均偏离该地温线，显示较高的地温特点，而且捕虏体及捕虏晶的压力范围多在20-40kb(相当于65-130km)间，该深度范围内地幔的交代作用特别发育，如蒙阴大量发育的沂蒙矿、钛钾铬石等就发育于该深度范围，世界范围内不含金刚石的高钙方辉橄榄岩、二辉橄榄岩、异剥橄榄岩也分布于该区中，一方面表明捕虏体的主要取样位置已不在金刚石稳定区中，另一方面也表明金刚石稳定的橄榄岩环境，在金伯利岩侵位并捕虏他们时已发现了明显的改造，这种改造作用主要是通过长期的熔流体与先存的橄榄岩相互作用的结果。

We selected the 2nd and the 3rd generation yeast with powerful vitality from the yeast mud fermented in tanks in working field as the ideal species source separated from yeast monoplast in beer and the ways to obtain them were as follows: 24 hours after deoxidisation of diacetyl to threshold value and decrease of its temperature to 5℃ was the best time for selection and sample－extraction location was at the nozzle of pressure－discharge pipes.

摘 要：从生产现场大罐发酵的酵母泥中选取第2～3代生命力强的酵母作为啤酒酵母单细胞分离的理想种源，选取的最好时间为双乙酰还原至阈值后降温至5℃，并让其停留24h时取样位置为排压酵母的管口，最后将所得菌种进行初选、复选或模拟生产恒温培养鉴定，选出优良菌株。

The process of establishing neural network is as follows: two-layer neuronic network configuration is selected, S-type active function is used, input parameter of network are selected for thickness, preheat temperature, heat input and sampling point, output parameter of network is selected for fracture toughness property CTOD, learning algorithm of network is used for back-propagation algorithm.

本文选择了2层神经元的神经网络结构，采用S型激活函数，将板厚、预热温度、线能量、取样位置作为神经网络的输入，将环焊接头的裂纹尖端张开位移CTOD值作为网络的输出，通过BP算法的网络学习，采用VC语言建立了X70管线钢环焊接头CTOD与环焊工艺之间的神经网络。

The process of establishing neural network is as follows: input parameters of network are selected from thickness, preheat temperature, heat input, welding position and sampling point, output parameter of network is impact ductility CVN, two-layer neuronic network configuration, S-type active function and back-propagation learning algorithm are selected.

文章摘要：采用VC语言实现了X70管线钢环焊接头冲击韧性与环焊工艺之间神经网络结构的建立过程，将壁厚、预热温度、线能量、焊接位置、取样位置作为结构的输入，将环焊接头的CVN值作为结构的输出，选择了具有2层神经元的神经网络结构和S型激活函数及BP学习算法。

It is recommended to start development of offshore drill ship. It is preferred to modify the petroleum exploration drill ship into NGH drill ship. Turbine rotating will be considered to counteract the ocean tides to obtain dynamic balance so as to ensure the stability of the NGH sampling operation.

并建议开展海洋钻井船的研制工作，可优先考虑将石油勘探钻井船改装成天然气水合物勘探钻井船；同时还要保证其取样位置的稳定性，可采取动平衡原理，通过涡轮旋转来抵消海流的作用。

Structure pattern and sampling position of the water vapor sample device poke head should guarantee the water and the steam sample taken out have enough representation,and should frequently be kept in good running status (including sample water temperature,water volume and chiller cooling capacity),meeting the needs which the measuring appliance continuously supervises.

10.10 水汽取样装置探头的结构型式和取样点位置应保证取出的水、汽样品具有足够的代表性，并应经常保持良好的运行状态（包括取样水温、水量及冷却器的冷却能力），以满足仪表连续监督的需要。

In the application of the stimulus-response method, the sampling position on the column, the algorithms proposed for parameter evaluation and the effect of measurement error are discussed in detail.

文中具体讨论了取样位置，数值解法及测量误差对参数估值的影响。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。