反曲线

The result of processing dual laterolog successive curve indicate that the inversion method performance well.

通过实际多口井连续曲线的反演处理表明，本文提出的反演方法合理而且有效。

In this paper, the 3D finite element method (3D-FEM) is employed to calculate the responses of the dual-laterolog in the high angle deviated wells. Moreover, under the consideration of the impracticability of the strict 3D inversion of the electrical logging, one method named the fast deconvolution, is given to correct the electrical logs which is calibrated by the forward method, 3D-FEM.

在考虑常规双侧向测井和正演数值模拟计算的基础上，利用三维有限元素法（3D-FEM）进行大斜度井中双侧向测井响应的数值模拟求解，并以不同倾角为条件验证了方法的有效性；进一步针对目前严格的电测井三维反演处理的不现实性，应用严格正演刻度下的快速反褶积处理方法进行定向井的电测井曲线校正。

This paper discusses the ptecision analysis, caiculation methods and advantages of telemeter curve widely used in optical sights foranti-tank and anti-armoured weapon systems.

本文介绍广泛应用于反坦克反装甲直射武器系统的测瞄合一光学瞄准镜卡距曲线测距精度的分析与计算方法及其优越性。

On the basis of the analysis of the transient negative current, a compensated voltage can be generated with multiplying the rms value of the negative sequence transient current of the feeder by a settable compensated reactance, then combined with the magnitude of the zero-sequence voltage to consist of the compounded compensated voltage, which can be utilized to revise the characteristics of the inverse time-delay.

其基本保护采用零序过电压保护，动作时间采用反时限特性；在分析接地故障负序暂态电流分布特点的基础上，利用线路负序电流暂态有效值与一个可整定的补偿电抗相乘，形成补偿电压，并与零序电压幅值合成复合补偿电压，利用该电压对基本的反时限动作特性曲线进行修正，使零序过电压保护具有选择性。

The inverse time delay characteristic is adopted by the basic zero-sequence over-voltage protection. On the basis of the analysis of the transient negative current, a compensated voltage can be generated with multiplying the rms value of the negative sequence transient current of the feeder by a settable compensated reactance, then combined with the magnitude of the zero-sequence voltage to consist of the compounded compensated voltage, which can be utilized to revise the characteristics of the inverse time-delay.

其基本保护采用零序过电压保护，动作时间采用反时限特性；在分析接地故障负序暂态电流分布特点的基础上，利用线路负序电流暂态有效值与一个可整定的补偿电抗相乘，形成补偿电压，并与零序电压幅值合成复合补偿电压，利用该电压对基本的反时限动作特性曲线进行修正，使零序过电压保护具有选择性。

Based on Wu's general three-dimensional turbomachine flow theory, the flow field matrix line relaxation computer program was established for flow along the relative stream surface S2, employing non-orthogonal curvilinear coordinates and non-orthogonal velocity components.

针对叶轮机械S_2流面反问题的计算，介绍了使用任意非正交曲线座标和非正交速度分量的S_2流面反问题流场线松弛解法计算机程序。并对该程序与目前一般常用的速度推广法程序和矩阵直接解法程序的不同之处，作了简要的比较和评论。

The mc2155 carrying pMind-glmU-AS was induced by different concentration of tetracycline, and GlmU protein was detected in the mc2155 carrying pMind-glmU-AS by Western blotting. The results showed that tetracycline of 20ng/ml has obviously inhibited the growth rate of mc2155 carrying pMind-glmU-AS, but the amount of GlmU protein did not change compared to that of uninduced mc2155 carrying pMind-glmU-AS.

glmU反义RNA的诱导表达与GlmU蛋白的检测分别用5 ng/ml、10 ng/ml和20 ng/ml的四环素诱导携带pMind-glmU-AS表达载体的mc~2155菌株表达反义RNA，绘制细菌生长曲线，结果表明20 ng/ml浓度的四环素可抑制mc~2155/pMind-glmU-AS的生长，但Western Blotting分析结果显示经四环素诱导和未诱导的mc~2155/pMind-glmU-AS中，GlmU蛋白表达量无明显的变化。

Note: for curve 6;is the sameas Type M; for curve 1~5, the roted current can be setting according to the user's manual

注：曲线6时同M；曲线1～5时，反时限动作电流和定时限动作电流可分别整定

Then the digital simulation of open-loop impedance control is accomplished, using the impedance curve with this quality factor.

本文运用仿真结果验证了求出的基波阻抗曲线，根据动模实验的结果对本曲线进行反推拟合，推出TCSC动模实验系统中电抗器支路的等效品质因数约为1.9左右。

The author explicates some developing aspects in the field of IC industry as suggested areas of future work. The original points of this dissertation are as following: 1. In this dissertation, we got the quality learning curve of China's IC manufacturers by regression. On the base of questionnaire, we later explained the reason of the reverse S type quality learning curve and the tendency of change in quality learning curve. 2. The evolution of technical unit of China's IC industry is calculated in this dissertation. We also explained the reason of technical unit splitting in the way of economic and technology. 3. In this dissertation, we described the environment difference in capital, technology transfer, human resource and market in USA, Japan, Korea, Taiwan and China, and gave some suggestions on the government's role in the development of China's IC industry.. 4. In this dissertation, we established an SD model of China's IC industry, and by using this model, we got some suggestions for future development in China's IC industry.

本文的主要创新之处在于：（1）用回归分析方法实证研究了我国集成电路企业的质量学习曲线，并在调查分析的基础上，对反S型质量学习曲线的历史成因和未来走势进行了研究；（2）对世界及我国集成电路产业技术单元的变化趋势进行了定量研究，从经济和技术角度解释了当前集成电路产业技术单元细化的原因；（3）从资金、技术、人才、市场角度系统总结研究了发达国家在集成电路产业发展环境建设中的成功经验，并结合我国集成电路产业发展的实际情况，对我国集成电路产业发展的政府行为提出了一些建议；（4）建立了狭义集成电路产业、材料业、设备业发展的系统动态模型，并利用该模型对不同投资结构下我国集成电路产业系统未来的演变进行了模拟研究，这一研究结果可以为我国集成电路产业今后发展提供一定的决策依据。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新