反应方式

The bane argues to know data Endanger an effect healthily:NONE The environment influence:NONE The physics and chemistry bane:NONE Special bane:The AZO-FREE passes the ICP method analysis test to have no related of lead over 100 ppms, Ge over 5 ppms 9.5 a fires and the explosion danger The order:Obsolescent Combustible extreme limit(the air lie quality:Vol%):non-combustible product Apply to extinguish fire:The water,water sprays fog,carbon dioxide,the stem powder to extinguish fire a ,foam to extinguish fire The special sex protection equipments of the fire fighter:Need to go together with to take the goggle and anti-virus mask Very the rules a fire and the explosion danger:When the temperature hoick, the product meeting because of hot bulge cold but cause to open 9.6 Respond sex Stability:Under the normal regulations condition stability Environment should avert from:The water immerse,affect by damp and cold,clear fire perhaps the temperature is high in 500 ℃s Incompatibility:Have no Dangerous of decline a solution an outcome:Have no Dangerous polymer reaction:Will not take place 9.7 health dangers Dangerous way:Inhale, take, the skin and eyes get in touch with solid perhaps dust-The physics contact may result in allergic sex respond.

危害辩识资料健康危害效应：NONE 环境影响：NONE 物理性及化学性危害：NONE 特殊危害：AZO-FREE 通过ICP方法分析测试无相关之铅超过100ppm，镉超过5ppm 9.5火灾和爆炸危险闪点：不适用可燃极限：不燃物品适用灭火剂：水、水喷雾、二氧化碳、干粉灭火剂、泡沫灭火剂消防人员之特别性防护设备：需配带护目镜和防毒面具非常规火灾和爆炸危险：当温度急剧上升时，产品会由于热胀冷缩而导致开裂 9.6 反应性稳定性：在常规条件下稳定应避开的环境：水浸、受潮、明火或者温度高于500℃不相容性：无危险的降解产物：无危险的聚合物反应：不会发生 9.7健康危险危险方式：吸入，摄取，皮肤和眼睛接触固体或者灰尘----物理接触可能造成过敏性反应。

In this work, a series of antimicrobial agents containing the hydantoin structure such as AM, BM and AM-AN, were synthesized by changing the reaction conditions such as temperature, time, concentration of initiator and so on, and the N-halamine structure which possessed the ability of durable antimicrobial, was transformed through a chlorination process.

本文设计合成了一系列含乙内酰脲结构的再生抗菌剂。通过改变合成反应的条件，如反应温度、反应时间、引发剂浓度、加料方式等，制备了再生型抗菌剂前体AM、BM和AM-AN共聚物。

The effects of feeding way of phosphorus pentoxide, ratio of C8H174OH to P2O5, reaction temperature and time on the synthesized isooctanol polyethenoxy ether phosphate were investigated. Its optimum synthesis technology conditions were as follows: feeding at batches while stirring tempestuously at 45℃, the ratio of nC8H17(EO4OH:n(P2O5)=2:1, esterifying at 70℃ for 4h, and add given volume of water at 70℃ for hydrolysing 2h.

研究五氧化磷的投料方式、反应物的用量比、反应温度和反应时间等因素对合成的异辛醇聚氧乙烯醚C8H17(EO4OH磷酸酯性能的影响，得到优化的异辛醇聚氧乙烯醚磷酸酯的合成工艺条件：在强烈搅拌下，分批投入P2O5，加料时的温度不超过45℃，nC8：H17(EO4OH：n(P2O5)=2：1，酯化温度为70℃，酯化时间为4h，在温度70℃时加入定量的水再水解2h。

Effects of ratio of sodium allylate to epichlorohydrin, reaction temperature and time and way of adding materials on the yield of allyl glycidyl ether were investigated.

讨论了原料摩尔比、反应温度、反应时间、投料方式等因素对反应收率的影响。

The sodium dithiobenzoic acid was oxidized with potassium ferricyanide to obtain di disulfide.The influences of raw materials mole ratio,stirring method and reaction time on the yield were studied with orthogonal test.

用铁氰化钾溶液氧化二硫代苯甲酸钠，得双二硫代苯甲酰，采用正交实验探讨了4，4'-偶氮双(4-氰基戊酸)与双二硫代苯甲酰反应的投料比、搅拌方式、反应时间对反应收率的影响。

Polyester polyol which was used for polyurethane hot melt adhesives was synthesized by the condensation polymerization of adipic acid and ethanediol, butanediol, hexanediol.

以己二酸、乙二醇、丁二醇、己二醇为原料进行酯化、缩聚反应，以钛酸丁酯为催化剂，采用阶梯式升温方式，合成了聚氨酯热熔胶用已二酸系聚酯多元醇；考察了醇酸摩尔比、催化剂种类和用量以及反应条件对酯化、缩聚反应的影响。

Fe2O3 acts as an activator more than a catalyst in the desulfurization reaction with lime. Fe2O3 acts as the "activation center" around which CaO particles are sulfurized. The new dispersal formation mode of product differs from the compact layer that used to be. And the pore structure of product layer on the surface of lime particles is optimized, which makes SO2 penetrate into core parts of lime more easily. As a result, the desulfurization reaction is developed deeper into the core parts of absorbent.

氧化铁所起的是改变石灰颗粒表层产物生成方式的活化作用，使反应生成物不会形成一个致密的外壳，而以氧化铁为活性中心进行硫化反应，形成了分散的硫酸钙产物堆积，改善了硫化过程中的表面孔隙结构，减少了石灰颗粒表面硫化产物层对反应气体向石灰颗粒内部扩散的阻力。

Fe2O3 acts as an activator more than a catalyst in the desulfurization reaction with lime. Fe2O3 acts as the "activation center" around which CaO particles are sulfurized. The new dispersal formation mode of product differs from the compact layer that used to be. And the pore structure of product layer on the surface of lime particles is optimized, which makes SO2 penetrate into core parts of lime more easily. As a result, the desulfurization reaction is developed deeper into the core parts of absorbent.

氧化铁所起的是改变石灰颗粒表层產物生成方式的活化作用，使反应生成物不会形成一个致密的外壳，而以氧化铁为活性中心进行硫化反应，形成了分散的硫酸钙產物堆积，改善了硫化过程中的表面孔隙结构，减少了石灰颗粒表面硫化產物层对反应气体向石灰颗粒內部扩散的阻力。

The Mg1.0AlO catalyst prepared by back-titration shows relatively high activity and stability, the conversion of acetone maintains at 65% even after 85 h at 573 K.

实验结果表明，以反滴沉淀方式制备的Mg1.0AlO催化剂具有较高的反应活性和稳定性，在反应温度为573K条件下，反应85h后丙酮的转化率仍可以达到65%。

The synthesis process of silica using waterglass and sulpHuric acid as materials was studied systematicly. The results show that reacting temperature, reacting time, sulphuric acid concentration, reactive stiring rate, modulus of waterglass,adding salting agent,alkali concentration,the total volume of acid and alkali added , different methods of adding materials may have influence on the specific surface area or dibutylphthalate absorption number of silica in different degree.

本文系统地研究了以水玻璃溶液和硫酸为原料合成沉淀法白炭黑的工艺，研究发现：反应温度、反应时间、硫酸浓度、反应搅拌速度、水玻璃模数、添加盐析剂、底碱浓度、酸碱加入的总量、加料方式对白炭黑的比表面积或DBP吸收值有不同程度的影响。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。