双轴

The result shows: the maximum of the exchange bias field moves towardsthe easy axis with increasing the biquadratic coupling field or bilinear coupling field;additionally, the oscillations of the curves for the angular dependence of exchangebias field become weak and gradually resembles the sine function with increasing thebiquadratic coupling field.

结果发现：双线性耦合或双二次耦合的增加都可使交换偏置场的最大值位置向易轴方向靠近，并且双二次耦合的增加使交换偏置场随外磁场的角度变化曲线的振荡也随之减弱，变为类似于正弦函数的图象。

Based on traditional magnet circuit anglicizing way and permanent magnet drawing and by using traditional BLONDEL theory, A model for electromagnetic calculation and formulas for voltage are obtained by dealing with the d- axis and q-axis electromagnetic coupling of the double- winding armature reaction.

并在常规稀土永磁同步发电机的磁路分析和永磁体图解法的基础上，利用传统的双反应理论，通过对双绕组电枢反应的d-q轴电磁解耦，推导出双电压复合励磁稀土永磁同步发电机的电磁设计数学模型。

On the basis of twin-roll thin strip continuous casting experiments and solidification structure characteristic analysis of thin strip and combining with the simulation results of effects of technological parameters, the forming mechanism of solidification structure zone (especially equiaxed crystal zone) on 1Crl8Ni9Ti stainless steel twin-roll thin strip was investigated.

在双辊薄带连铸实验和薄带凝固组织特征分析的基础上，结合对薄带凝固组织区的模拟预测结果，研究了1Cr18Ni9Ti不锈钢双辊薄带凝固组织区的形成机理。结果表明：1Cr18Ni9Ti不锈钢双辊薄带凝固组织中的等轴晶区不但在凝固类型为半固态时形成，在轧制或理想型时也能形成。其形成机理为，熔池中悬浮游离晶体的沉积、聚集以及在枝晶生长前沿的长大和薄带离开二铸辊最小间隙后，薄带/空气界面换热系数骤然降低抑制了柱状枝品的生长，并促使薄带中部未凝固熔体中游离晶体的择优长大

Taking HPAM solutions as an example, the unsteady flow of power-law fluid in eccentric annuli with the inner cylinder reciprocating axially is calculated; the distribution of velocity, flow rate and stability parameter is obtained; taking HEC solutions as another example, the flow of second order fluid in eccentric annuli with the inner cylinder moving axially is calculated too; the distribution of velocity and stress is obtained; the effect of eccentricity and axial movement on stress distribution on the outwall of the inner cylinder is analysed.

在理论上，分别用二阶流体和幂律流体模型描述聚合物驱油井产出液的非Newton流变性；分别建立了双极坐标系下二阶流体和幂律流体在内管做轴向往复运动的偏心环空中非定常流的控制方程及边界条件和初始条件方程；建立了幂律流体在内管做轴向往复运动的偏心环空中流动的稳定性参数和流体在内管壁上的压力分布计算公式；建立了二阶流体在内管做轴向运动的偏心环空中流动的流体在内管壁上的压力分布计算公式。

Disclosed is a leaky-wave dual polarized slot type antenna, including: first and second feeding circuit sections comprised of N-first strip lines and N-second strip lines with a loop every first period along the X-axis on the first dielectric layer and a second period along the Y-axis, in which the N-first strip lines and the N-second strip lines are parallel to each other being alternate, and each length of Ls1 and Ls2 for the first period satisfies the equation of , first and second multi-channel dividers formed at once and the other sides of the first dielectric layer, to connect the N-first strip lines and the N-second strip lines parallel with each other; and first and second central ports formed in the opposite direction of the cavity, each of the feeding circuit sections being connected to the first and second multi-channel dividers; and first and second slot sections being formed by patterning the second shielding layer, in which M-first and M-second slots are arrayed along the direction of the X-axis and each of the first and second slots forms N-row first and N-row second slot arrays, respectively, which cross the first and second strip lines for each, the first slot and the second slot being orthogonal to each other.

公开了一种漏泄波双偏振槽型天线，包括：第一和第二馈电回路部分，其具有沿着X轴在第一介电层每第一周期以及沿着Y轴的第二周期形成具有环路的N第一带状线和N第二带状线，其中N第一带状线和N第二带状线彼此平行并交替，并且对第一周期的各Ls1和Ls2的长度满足等式，第一和第二多通道分配器寻形成在第一介电层的一侧和另外一侧上，以连接彼此平行的N第一带状线和N第二带状线；以及形成在腔的相对方向中的第一和第二中心端口，每个馈电回路部分连接到第一和第二多通道分配器；以及第一和第二槽部分，所述第一和第二槽部分通过对第二屏蔽层形成模式而形成，其中M第一和M第二槽沿着X轴的方向安置，各第一和第二槽分别形成N行第一和N行第二槽阵列，其对每个横过第一和第二带状线，第一槽和第二槽彼此正交。

A Study on Fraunhofer Double-Slit Diffraction by Applying Simulation Technology;2. Based on Kirchhoffs theory,the approximate intensity formulas of double-slit diffraction of Gaussian Beam is derived under paraxial approximation with power series expansion methods.

依据基尔霍夫衍射理论，利用幂级数展开的方法推导出旁轴条件下高斯光束双缝衍射的近似光强计算公式，并通过数值计算对双缝衍射的基本特性进行了讨论，得出了与其他文献一致的结论，得出了高斯光束下的双缝衍射极小值点比平行光束双缝衍射的极小值点向外移，观察屏中心光能变小；光强分布可由激光斑在衍射屏处的参数调制的结论。

The aerostatic bearing levitates the actuating rod with four radial air inlets on each side. The frictionless aerostatic guide can improve the actuating rod is electromagnetically driven by a fixed solenoid and a actuating solenoid. Through adjusting the axial position of the actuating solenoid, the actuating stroke can be fine regulated.

双列径向供气之气静压轴承提供致动轴作径向的支撑，其低摩擦之特性有助於提升定位精度，致动轴两端外侧设有固定线圈与致动线圈，调整致动线圈轴向位置可以改变致动器最大行动范围。

Instant noodles and rice industries; steamed stainless steel mesh belt, all kinds of oil-boxes, hanging drying box, noodle cutter, noodle Salisbury, Fulcrum, molding boxes. 3, all kinds of frozen foods, vegetables dehydration lines of stainless steel conveyor equipment chain, mesh belt, such as Fulcrum. 4, production and sales of imports, domestic food use of various models of PVC, PE, PU belt. 5, glass annealing furnace Net industry belt, mesh belt furnace DECORATED, Bottle Nets lost belt, mosaic mesh belt, specifications have crankshaft-type, direct-axis type, diamond-shaped, double-stranded helix.

同时生产饼干机械，喷蛋机乙型网带及肉食输送乙型网带，进口机器超薄节能网带。2、方便面及米粉行业；蒸熟不锈钢网带，各种油盒、烘干吊盒、面刀、面梳、支轴、成型盒等。3、各种冷冻食品、蔬菜脱水流水线设备用不锈钢输送链条、网带、支轴等。4、生产销售进口、国产各种型号食品用PVC、PE、PU皮带。5、玻璃行业退火炉网带、烤花炉网带、输瓶机网带、马赛克网带，规格有曲轴型、直轴型、菱形、双股螺旋型。

Excellent Throttling Performance- The splined ball to shaft connection, splined shaft to actuator connection, double power-end bushing assemblies, and trunnion guiding, all provide improved dynamic control.

节流性能优异，球的花键轴连接，花键轴连接器，双电源端套管集会，耳轴的指导，所有提供更好的动态控制。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 10 30.7 79.3 5.26 10.65 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ...

载荷钢球圈列数 DN值预压预压方法预压负荷 1row 2.50圈 70000 有定位置预压 1535 导轨型号丝杠轴加工方式球保持器轴的花键部分中空轴滚珠精密无无无轴承支撑座固定侧的推荐方式轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球 BK30，BK35，FK30 BF30， BF35， FF30 双螺帽右螺纹，左螺纹，左右螺纹无。。。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。