双管系统

The key part of light alarm circuit of the system is the flashing tube and the life level of the main charge and discharge capacitance. Thus ,in this design, adopted autotransformer step-up type, two-level filter and double flashing tube, in order to light the burden of the main charge and discharge capacitance, reduce the heat productivity and extend the life level of the capacitance.

在系统的光报警电路中关键部件是频闪管和主充放电容的寿命，因此在电路设计中采用自耦变压器升压方式和双级滤波、双频闪管等独特的电路结构，减轻主充放电容的负担，减少发热量，延长电容使用寿命。

Based on the analysis to crankshaft-working system and turning/feed system for cold pilger mill and radio of two turning angles, the system is designed with computer.

本文通过对双回转送进二辊冷轧管机的曲轴机架与回转系统进行分析，以保证工作行程和轧件两次回转角分配比为设计前提，按照回转凸轮轮廓曲线的两过渡段的峰值加速度相等的设计准则，计算曲轴-机架与回转系统，实现了系统的最优化的设计。

The axial stress in tubes when the load transferring from outmost tube to inner tube is observed as well.

然后对双壁碳纳米管有限系统内管从外管中拉出时受到的轴向力进行了分析。

This system uses the deuterium lamp as its blazed lamp-house, and makes mechanical turnplate in use of modulating light signal with two frequencies, which is drived by in-phase electromotor with constant velocity. A potomultiplier tube is used to conversion optical signal to electric signal. Using Lock-In Amplifiers to realize magnifying the metrical signal using difference method with two different frequencies. We also analyze its principle of each part of the apparatus and design the realization circuits of each part. The data analysis and the in-phase electromotor control circuits are fulfilled by SCM; the single chip control systems hardware interface and software design are given.

该系统的光路部分使用氘灯作为激发光源，用同步电机恒速驱动的机械盘调制出双频光信号，利用一个光电倍增管进行光电信号转换；信号处理部分采用锁相放大器实现信号双频差分处理，分析了其各组成部分的原理，设计了各部分的具体实现电路；使用单片机进行数据差分处理和电机控制，给出了单片机控制处理系统的硬件接口电路和软件设计。

Major products of electron industry have bipolar digital IC, small exterior plastic sealing IC, single slice IC, integrated function module, thin and thick module composed IC, integration pressure sensor, semiconductor plastic down-lead frame, bipolar electrostatic induction transistor BSIT, power commutation diode SBD, microwave scanning frequency test system, ultrahigh frequency test system, waveguide coaxial system and satellite communications aerial etc.

电子行业主要产品有双极型数字集成电路、小外型塑封集成电路、单片集成电路、集成化功能模块、薄厚膜混合集成电路、集成压力传感器、半导体塑料引线框架、双极静电感应晶体管 BSIT 、功率肖特基整流二级管 SBD 、微波扫频测试系统、超高频测试系统、波导同轴系统、卫星通讯天线等。

A method for measuring the size of the dispersed spot of star sensor optical lens is presented. A measurement system consisting of a collimator, a rotary table and a CCD cameral was implemented to measure dispersed spot. After a image is acquired, a method of bibubic interpolation pixel subdivision is used to pick up the gray value of the image, and the size of dispersed spot is calculated by Rayleigh criterion.

提出了一种星敏感器光学系统弥散斑尺寸的测试方法，主要是利用平行光管、转台和CCD显微摄像系统组成弥散斑测量系统，采集图像后，采用双三次插值像元细分，提取图像中灰度值，依据瑞利判据计算弥散斑尺寸。

According to capability of the circuit of DC motor, build the model of DC motor; designed the speed-current double closed loop system based on the model of DC motor; analyzed the method to solve the problem of discontinuousness of current.

二、根据直流电机回路，建立电动机的数学模型；针对该电动机模型，选用速度——电流双闭环控制系统，建立双闭环系统的控制方框图；分析晶闸管相控整流方式中出现电流断续现象的解决方法。

Through the SPCE061A programming, this design requests us use the single chip microcomputer, PLC or other components to control the LED digital tube and the double color LED lamp on the traffic light control panel, enable the system to have the following functions: The four intersections of the crossroad all have double color LED (gives out red light and green light, superimposes for yellow light) to demonstrate the condition of every channel on the intersections; Each intersection has two digital tubes to demonstrate current traffic light countdown; use the button or other way to simulate the counting of the traffic flow volume.

设计要求通过SPCE061A的编程，使用单片机、PLC或其他器件来控制交通灯控制板上的LED数码管以及双色LED灯，使系统具有以下功能：十字路口的四个路口都有双色 LED （发红、绿光，叠加为黄色光）显示各路口的各条通道状态；每个路口有两位数码管显示当前红绿灯的倒计时；可利用按键或其它的方式模拟对车流量的计数；有四种工作状态：正常工作状态、紧急工作状态、设置状态和查询状态；红绿灯变换时有语音提示；查询时，可语音播报当前路况。

On the basis of research of Bend Pipe machine's principle and Numericl Control system, by a...

通过对弯管工艺的分析，本文在研究弯管机工作原理和控制系统的基础上，以面向对象编程技术为手段，设计和开发出了基于工业PC和WINDOWS 98的双模数控弯管机数控系统，通过调试已成功应用于STAR-03W数控弯管机上：同时，也对在WINDOWS 98平台下开发数控系统所存在的实时性问题提出了解决方法。

This paper analyzes the difference between new two-pipe heating system and traditional heating system, puts forword the way of determining mean friction resistance of new two-pipe heating system.

免费论文，内容包括自然循环作用压力水力平衡恒温阀预设值不平衡率双管计量计量供热供热供热系统问题分析

In the United States, chronic alcoholism and hepatitis C are the most common ones.

在美国，慢性酒精中毒，肝炎是最常见的。

If you have any questions, you can contact me anytime.

如果有任何问题，你可以随时联系我。