及电路

The instrument consists of highly sensitive pressure sensor, mechanical system which can produce positive and negative pressure and its control circuits, pressure measurement and conditioning circuits, the interface with PC compatible computer and analogue signal conversion circuits. This instrument can realize the idea of measuring blood viscosity during collecting blood.

该仪器包括高灵敏度传感器；可产生正负压力的机械系统及与其相关的控制电路：压力测量及转换、匹配电路：与计算机信息交换系统、控制接口及模拟信号转换电路等。

In this paper the commutate circuit principle and work process of the commutate circuit, the composing and work principle of frequency conversion circuit, main switch element IGBT structure feature turn on and turn-off process dynamic and static switch feature and the work principle of invert were analyzed .

本论文分析了整流电路及相控电路的原理和工作过程；变频电路的组成和工作原理；主开关器件IGBT的结构特点、导通及关断过程、动态静态开关特性；逆变电路的工作原理。

The thesis contains five chapters. The first chapter summarizes the development and research of switched reluctance drive, discusses the main research direction, and explains the main work in this paper. In chapter 2, hardware system which includes the design of power converter and various control circuit is discussed. TMS320LF2407 DSP is used to design the hardware circuits of SRM control system, and design details including the current detection, position sensing, fault protection, speed detecting, keyboard and display etc. are provided. Because of the full use of the abundant peripheral resources of DSP, it comes to the aim simplifying the circuit structure and heightening the reliability. In chapter 3, the application of neural network on SRM control system is introduced, a new the application of neural network and the method of sampling is proposed and a simulation system based on Matlab/Simulink is established. Chapter 4 discusses the routine designing issue. Because the modularized programming method is adopted, and multi-interrupt processing technique is used, operation efficiency of the control software is highly raised. At last, the foregoing SRM control system is tested. Speed adjustment is realized, and other targets on the research and design of SRM control system are reached, which establishes a good foundation for further research.

本文共分五章，第一章概述了开关磁阻电机调速系统(Switched Reluctance Drive，简称SRD)及其发展和研究现状，论述了其主要研究方向，并说明了本文的主要工作；接下来的一章主要讨论了SRM的硬件系统，主要包括功率变换器的设计和各种控制电路的设计，本文以TMS320LF2407为核心设计了开关磁阻电机控制系统硬件电路，给出了包括电流检测、位置检测、故障保护、测速电路及键盘和显示电路等部分电路的详细设计，充分利用了DSP的丰富外设资源，达到了简化电路结构、提高运行可靠性的目的；第三章介绍了人工神经网络在开关磁阻电机控制系统中的应用，提出了一种新的应用方式(利用GPFN神经网络调节PI参数)以及如何采取样本，搭建了基于Matlab/Simulink的仿真系统；在第四章中，讨论了开关磁阻电机控制软件的设计，采用模块化编程方法，采用基于多中断的控制程序，提高了控制软件的效率；最后，对所设计的开关磁阻电机控制系统进行了实验，实现了电机调速，达到了开关磁阻电机控制系统研究和设计的预期目标，为更近一步研究打下了基础。

By the research of the RLC series circuit, RLC Parallel circuit, and the starat of Fourier Series, get the further understanding and grasp the characteristics of the resonant of RLC circuit. Even more, on the basis of the RLC series resonance, the other circuit structures selected frequency wave frequency analysis of the election.

本实验通过对RLC串联电路、并联电路及方波的傅立叶级数展开的实验现象的测量及研究，进一步了解和掌握RLC谐振电路的特点，并在RLC串联谐振的基础上，搭建选频电路对方波进行选频分析。

A time-shared control circuit points to multiplexer, applies the control signal and switches and repeats to output the input signal by the predetermined cycle order. A comparator compares the voltages of the output signal from the multiplexer and the reference voltage and outputs a dimorphic signal representing the comparative result. A time-share controlled circuit applies the control signals, controls the action of the multiplexer and the latch circuit to lead the respective voltage comparative result to be maintained in the latch circuits.

分时控制电路(5)对多路调制器(4)，使用控制信号(Sc1)，以所定周期顺序切换反复输出所输入的信号(St1)-(St4)，比较器(3)对从多路调制器(4)输出的信号的电压和基准电压进行电压比较，输出表示该比较结果的二态信号，分时控制电路(5)使用控制信号(Sc1)及(Sc2)，控制多路调制器(4)及闩锁电路(LT1)-(LT4)的动作，使得信号(St1)-(St4)的各电压比较结果分别保持在闩锁电路(LT1)-(LT4)中。

This product is applicable to coal mine where has explosible dangerous gas and coal dust,It is used for controlling direct starting stop and reversion of three-phase squierrel cage type asynchronous motor whose rated current up to 400A in system of AC50Hz rated voltage 1140V or 660V, Meanwhile it protects the electromotor and relative circuit, The starter can be combined with firedamp sensor and used to test the consistency of mining working area,the starter will trip when it exceed the limit ;adopt intrinsic safety type circuit for the control circuit; possess the function of local control and remote control by single set and multi sets procedure control; display working voltage current and gas consistency can remember fault parameter

该产品适用于具有爆炸性危险气体和煤尘的矿井中，在交流50Hz，额定电压为1140V或660V ，控制额定电流只400A的三相鼠笼式异步电动机的直接起动，停止及反转，同时对电动机及有关电路进行保护，起动器可与甲烷传感器相连接用于检测才掘工作面的甲烷浓度，当其超限时起动器跳闸；控制电路采用本安型电路；具备单台就地控制与远方控制及多台程序控制功能，能显示工作电压、电流、瓦斯浓度，并能记忆故障参数。

First, it analyses all-around design of the electronic computer-based interlocking system and each module, then from introducing CAN bus, it lucubrates design of the censorial module's software and hardware which is based on CAN bus of signal lamp's stimulant state, then the hardware's circuit of the entire system's censorial module is made up of opsonic circuit, collecting circuit, microcontrolled circuit,circuit of communication, interrupt circuit of overcurrenting and reset circuit.

首先对全电子计算机联锁系统的总体设计及各个执行模块进行全面的分析和研究，然后通过介绍CAN总线技术，着重研究了基于CAN总线的信号灯模拟状态监测模块的软硬件设计，其中整个系统监测模块的硬件电路主要由硬件调理电路、采集电路、微控制电路、通信电路、高过流中断电路、复位电路等部分组成。

First it analyses all-around design of the electronic computer-based interlocking system and each module then from introducing CAN bus it lucubrates design of the censorial module's software and hardware which is based on CAN bus of signal lamp's stimulant state then the hardware's circuit of the entire system's censorial module is made up of opsonic circuit collecting circuit microcontrolled circuitcircuit of communication interrupt circuit of overcurrenting and reset circuit.

首先对全电子计算机联锁系统的总体设计及各个执行模块进行全面的分析和研究，然后通过介绍 CAN总线技术，着重研究了基于 CAN总线的信号灯模拟状态监测模块的软硬件设计，其中整个系统监测模块的硬件电路主要由硬件调理电路、采集电路、微控制电路、通信电路、高过流中断电路、复位电路等部分组成。

First, it analyses all-around design of the electronic computer-based interlocking system and each module, then from introducing CAN bus, it lucubrates design of the censorial module%26rsquo;s software and hardware which is based on CAN bus of signal lamp%26rsquo;s stimulant state, then the hardware%26rsquo;s circuit of the entire system%26rsquo;s censorial module is made up of opsonic circuit, collecting circuit, microcontrolled circuit,circuit of communication, interrupt circuit of overcurrenting and reset circuit.

首先对全电子计算机联锁系统的总体设计及各个执行模块进行全面的分析和研究，然后通过介绍CAN总线技术，着重研究了基于CAN总线的信号灯模拟状态监测模块的软硬件设计，其中整个系统监测模块的硬件电路主要由硬件调理电路、采集电路、微控制电路、通信电路、高过流中断电路、复位电路等部分组成。

This paper discusses some kinds of function circuits to receiver for moblie telephone,incuding antenna circuit、low noise amplifier circuit and mixing circuit,the emaphsis are put on their performance indexes、characteristics and applications.

本文讨论了移动电话接收机功能电路中常见的几种天线电路、低噪声放大电路及混频电路，重点放在它们的性能指标、特性及应用方面。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。