及电路

Secondly, the thesis analyzes the design principle of hardware system, and descries the architecture of the solution. It analyzes how to implement AD converter, IDT72V3690 circuit, FPGA chip EP1C2214 design, including RAIDO disk control and application of embedded microprocessor LPC2214.Thirdly, the thesis descripts the design and realization of embedded software of LPC2214. First of all, it brings out the thinking of software layer, and designs the software architecture.

其次，叙述了基于USB总线硬件系统的体系结构及设计原理；详细介绍了如何实现AD转换电路抗干扰以及如何采用嵌入式处理器LPC2214、高速缓存IDT72V3690电路、FPGA芯片EP1C2214等电路设计实现简易RAID0存储阵列；重点叙述了FPGA设计ATA控制器和RAIDO逻辑的过程，介绍了FPGA内部逻辑是如何工作，将数据有序高效地并行存储到磁盘中去的。

The main products of tai wei is single and double-pole toggle switch,which can be used as single or double throw switching button in both transient or delay circuit.

太玮toowei生产单及到双及的摇头开关，可插入单掷和双掷瞬时或延时电路按钮和钮子类型开关，品种多样，既美观又耐用，包括电路配置，交流直流接线端选项，按钮开关自选颜色。

So, the teacher will teach students how to learn to use the comparatively advanced auxiliary software of computer, and Information of Science and Technology equipment come exercise to design higher level, such as use computer auxiliary printed circuit baseplate, use extending and networking and looking for the materials about electronic element, and use ' the fictitious instrument ' to assess circuit that students design,etc., enable students to have the society that planned to face future science and technology which fill one.

因此，老师会教授学生学会使用较为先进的电脑辅助软件，及资讯科技设备来设计较高层次的习作，如使用电脑辅助印刷电路底板、使用亘联网寻找有关电子元件的资料，及使用「虚拟仪器」来评估学生所设计的电路等，使学生能够有充份的准备去面对未来科技的社会。

Then the paper presents a novel-working mode of Boost-Forward single-stage Power Factor Correctors based on the analysis. And get the principle of the conduction mode and the method to control the voltage of the buck capacitor after the analysis of the boundary mode of the PFC converter and the DC-DC converter.

在此基础上，本文首次提出了一种全新的临界工作模式下的单级功率因数校正电路，在对PFC变换器及DC/DC变换器工作在连续及不连续的边界条件进行了讨论后，得出了电路工作状态的精确解并提出了控制储能电容电压的临界点工作方式。

The equations for two-conductor coupled-line Marchand baluns are derived. The analysis and systematic design procedure for multi-conductor coupled-line Marchand baluns are also presented, and verified with a few fabricated multi-conductor coupled-line Marchand baluns. Two MMIC broadband diode frequency doublers using multi-conductor coupled-line Marchand baluns are implemented to demonstrate the design procedure of multi-conductor coupled-line Marchand baluns. The MMICs achieve miniature chip areas with broadband performances in millimeter-wave regime.

二金属耦合线马逊平衡不平衡转换器的方程式推导及多金属耦合线马逊平衡不平衡转换器的分析及系统化设计流程也在此论文中被提出，并且用许多实际制作的平衡不平衡转换器做验证，此外，两个微波单晶积体电路的宽频二极体倍频器包含多金属耦合线马逊平衡不平衡转换器也用来验证此多金属耦合线马逊平衡不平衡转换器的系统化设计流程，这两个微波单晶积体电路在毫米波的频段内都达到微小的晶片面积与宽频的响应。

Various harmonic current detecting motheds in common use are analyzed. These detecting methods are aimed at three-phase circuit, and can not apply directly to single-phase circuit and four-phase circuit, have certain defect in general application.

本文分析了目前常用的谐波电流检测方法，这些检测方法多着眼于三相电路，不能直接应用于单相电路及四相电路，在应用的通用性上存在一定的缺陷。

To achieve the circuit capacity of maximal power transmission and least return loss, impedance matching networks are generally inserted in the input and output ports,compnter simulation solves the problem of how to settle the impedance matching network composition and component parameters in high efficiency.

射频电路设计中为了达到最大功率传输、减少回波损耗等电路性能，一般在输入和输出端加入阻抗匹配网络来加以改善，计算机仿真高效地解决了确定阻抗匹配网络结构及各元件参数的问题，通过ADS仿真确定了射频电路中匹配网络的元件最佳参数。

There is a mounting hole on the bottom of the shell, Anion generating circuits packed together with carbon fiber bundle forms the anionic pulse generator which is inserted into the mounting hole and placed in the middle of the lamp shell.

负离子节能灯，包括灯头、灯壳、灯管、灯电路、负离子发生电路及碳纤维束，灯壳底座设有安装孔，负离自发生电路与碳纤维束封装于一体组成负离子发生器—整体插合于安装孔并置于灯壳外灯管中间。

Secondly, whole-chip ESD protection net is put forward. Input protection circuits, output protection circuits and circuits between high-voltage ground and low-voltage ground are decided on the base of structure and process of PDP drive chip. Moreover, the design of low-voltage VDD-to-VSS ESD protection circuits is detailed and the circuit is simulated with HSpice. Finally, the characteristic of high-voltage device after avalanche breakdown is simulated and analyzed with Tuprem-4 and MEDICI, and it is concluded that high-voltage device can stand high voltage and large current, so the low-voltage VDD-to-VSS ESD protection circuits can be applied to high-voltage VDD-to-VSS ESD protection.

随后提出PDP驱动芯片全芯片ESD保护网络的方案，并根据PDP驱动芯片的结构和制造工艺，介绍了输入部分、输出部分及高低压接口部分的ESD保护电路，然后重点分析了低压电源和地之间ESD保护电路的设计并用Hspice进行了模拟，最后使用Tuprem-4和MEDICI模拟了高压器件在雪崩击穿之后的电压电流和电场分布特性，得出高压器件本身可以承受一定的ESD脉冲，从而将低压电源和地之间的ESD保护电路应用到高压电源和地之间。

This article angle has analyzed the higher professional technical education from CBE/DACUM "the electrical control technology" the curriculum ability localization, according to the higher professional technical education "the electrical control technology" the curriculum ability localization, point out the insufficiency and flaw existed in commonly used control electric appliance choice, electrical pilot wire road map, electricity control system installment, wiring craft, electrical control line fault diagnosis system approach, new starting velocity modulation equipment and control circuit, control circuit and main circuit aspect and so on.

摘要本文从CBE/DACUM角度分析了高职&电气控制技术&课程的能力定位，根据高职&电气控制技术&课程的能力定位，指出了现行高职&电气控制技术&教材在常用控制电器选择、电气控制线路图、电气控制系统安装、接线工艺、电气控制线路故障诊断的系统方法、新型起动调速设备及控制电路、控制电路与主电路的连接等方面存在的不足和缺陷。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。