参数曲线

An exstensive research on the calculation formulas for the abutment cone slope on skewed bridges is conclucted.Calculation formulas of key parameters on slope curve are derived through analytic calculation of ellipse curve at slope bottom.The values of parameters are discussed and various forms of cone slope and curve at slope bottom are detailed.

以斜交桥梁桥台锥坡为锥坡的一般形式展开较深入的研究，通过对坡脚椭圆曲线的解析计算，推导得出坡脚曲线各控制参数的计算公式，并对其取值进行讨论，详细说明了锥坡和坡脚曲线的各种形式；进而推导了斜交锥坡的体积、护坡体积、表面积和基础体积的计算公式。

Experiments of flow conductivity closure stress of typical propping agent are done, propping agent short-term flow conductivity alteration index is defined, by this, the relation between fissure short-term flow conductivity and closure stress, it is close to exponential relation. 4. Establishing the mathematical simulator of hydraulic fractured well's production in a steady state, finding the relation curve between dimensionless flow conductivity and fracture penetration coefficient by means of calculation and analyses, it is the basis of hydraulic fracture. 5. Expatiating the importance of optimized hydraulic fracturing design in reservoir engineering, advancing the optimizing design method, fracture dimension can be calculated easily when the physical parameters are known. 6. Production rate decline standard curve of vertical fractured wells is achieved by mathematical simulation, when the flow pressure is certain , by asymptotic analyze, this decline curve is close to exponential relation.

完成了国内外典型支撑剂的导流能力闭合应力影响实验，在数据分析中定义了支撑剂短期导流能力变异系数，并由此发现裂缝短期导流能力随闭合应力变化的近似符合指数关系式； 4 建立了一种水力压裂井稳态产能的数学模拟器，计算分析找到了最优无量纲导流能力与裂缝穿透比之间的新型关系曲线，它是水力压裂优化设计的基础； 5 阐述了水力压裂油藏工程优化设计的重要性，提出了优化设计方法，在已知支撑剂物性参数条件下可简洁计算最优裂缝尺寸； 6 数学模拟给出了垂直裂缝井产量递减标准曲线，在井底定压条件下通过渐近分析表明，该递减曲线满足指数关系式。

So supported by well core experimentation, the *** analyzed the logging response feature and mechanism of thin bed, and point out that many factors can affect the logging response of the reservoir, the main factor which mostly influence the logging response is the thickness of thin layer, and the content of carbonite have a great influence on the response of 3-porosity logging.we make use of core experimentation, combined with logging material, firstly the *** do the lithology correction and thinckness correction for resistivity curves, and based on the content of mud that derived from the core experimentation, the *** present the thickness correction model of gamma-ray logging and self-potential logging, and choose the appropriate ways to compute the carbonate content and using the value of mixed frame in order to correct the influence from the carbonite, based on this, the *** gives a effective methods to correct the thickness influence for 3-porosity logging.

本文首先以岩心实验结果为依据，对研究区薄层的测井响应特征和机理进行了分析，指出多种地质因素影响着储层的测井响应特征，而层厚是影响测井响应最主要的因素，且碳酸岩含量对三孔隙度测井的影响很大。利用岩心实验分析资料，结合测井资料，首先对电阻率测井曲线进行了岩性的校正和层厚校正；利用岩心分析泥质含量，研究了自然伽马和自然电位的层厚校正方法，并建立了层厚校正模型；在有效计算储层碳酸岩含量和混合骨架参数值的基础上，研究了针对碳酸岩含量对测井曲线的影响进行校正的方法，进而提出了一套对三孔隙度测井曲线的薄层层厚影响的校正模型。

Based on Bezier curve continuance of first－order and second－order derivative, the characteristic vector equation of two Bezier curve is presented in point of intersection. The algorithm is not only of high accuracy with all of the interpolated points being on the curve theoretically, but also of very high speed in the real－time interpolation processes. The interpolation velocity does not change and the segment tolerance of interpolation can be control by selecting the parameter in cerement rationally every time.

为保证两段Bezier曲线在连接点处一阶导数、二阶导数连续，导出了两段Bezier曲线特征向量应满足的关系方程，Bezier插补法不仅在理论上可使所有的插补点落在曲线上，而且实时插曲补速度高，每次插补时可合理地选择参数增量，能使插补速度保证不变，也可控制弓高误差。

An image conic can be the projection of either a planar conic or silhouette of a conicoid. We show that at least three images, taken from the same position with different camera orientations, of two planar conics, or two conicoids, or one conic and one conicoid, are needed for the calibration, and a closed-form solution can be obtained. Our new conic based calibration technique requires no knowledge of camera's orientations, and relies solely on image correspondences.

在不同的方位拍摄三幅或三幅以上图像，每幅图像至少包含两个空间平面二次曲线、或两个二次曲面、或一个平面二次曲线与一个二次曲面的投影，利用图像之间的二次曲线对应关系，可以确定摄像机的内参数矩阵，同时可以获得摄像机不同方位之间的旋转矩阵。

Many subdivision schemes have been proposed in the recent three decades, however, most of them are not capable of both reproducing families of curves widely used in Computer Graphics such as conics, and controlling the shape of the limit curve by a tension parameter.

近三十年来已有多种细分方法被相继提出，然而大多数细分方法不能既生成在计算机图形学中广泛应用的特殊曲线，例如圆弧曲线，又存在一个松弛参数能够调整极限曲线的形状。

From the mechanics analysis, the relationships between the configure parameters (such as the wheel parameters and the position of mass center) and the mobility performane indexes (such as the wheel sinkage, motion resistance and drawbar pull) are obtained. The design principles of the wheel parameters, position of mass center and the wheel space are given. It is demonstrated that the mass center is crucial to the mobility performance of the lunar rover.

通过对移动性能的分析，得到了构型参数和地形参数与下陷量、运动阻力、牵引力等性能参数间的关系曲线，给出了月球车车轮、质心位置和轮距等构型参数的设计原则，论证了质心对于月球车移动性能的重要性。

Estimations of effective parameter in heterogeneous media: Firstly, we clarify the concept of the effective parameter and address the problems of parameter estimation by traditional pumping test. Secondly, we present two estimation approaches (i.e., distance-drawdown and spatial moment analyses) for Seff and Teff, which are consistent with Theis' homogeneous aquifer assumption.

本文探讨的内容主要分两大部分：(1)空间异质性孔隙介质有效参数的推估方法：主要探讨内容包括重新思考有效参数的定义及其观念，探讨传统抽水试验推估异质性含水层有效参数的一些问题，其次提出估计异质性地下水系统有效参数两个合理方法：泄降-距离曲线分析和泄降分布的空间矩分析，并以数值实例解释其合理性，文中藉由分析数值模拟的结果探讨说明该问题。

A new mathematical model with only three parameters is proposed to describe the whole TEG.

提出了一个新的三参数的数学模型表达血栓弹力图，研究了模型参数变化对模型曲线的影响及模型参数与血栓弹力图临床参数间的对应关系，给出了模型参数确切的生理、病理意义。

The paper investigates both block-type pilot linear minimum mean square error algorithm and IEEE802.16 OFDM channel estimation analysis. Simulation results confirm the block-type pilot structure is more suitable for IEEE802.16 system. An optimal pilot setting algorithm, based on space frequency domain, is explored and the pilot chart is presented. The proposed algorithm finds its application in MIMO-OFDM. Simulation results show the algorithm presents a good approximation to the perfect channel state information curve, with about 2dB difference in SNR. The simulation results also demonstrate the algorithm achieves fairly high stability in the environment of fast fading, performance of the proposed algorithm is better that of pilot training channel estimation.3. Taking into account the characteristics of IEEE802.16 OFDM system, OFDM system simulation platform is constructed in Matlab, exploiting simulink as a tool. OFDM modulation and demodulation simulation system are configured on LabVIEW platform. All the system signal processing is simulated, including defining system parameters, designing modulation model, and verifying all the proposed algorithms under different environments, such as white Gaussian noise, multi-path fading, with or without guard interval etc. Bit error performance is evaluated. The research provides valid theoretical basis for practical OFDM system performance evaluation.4. Taking advantage of software radio, the paper designs a hardware platform with both 256-IFFT/FFT and 512-IFFT/FFT OFDM schemes co-existing in one platform. You can predetermine one from the two schemes to carry out almost the same model function with different system performance and parameter setting.5. Referring to IEEE802.16 standard, the paper proposes a design method for generating signals and frames suitable for laboratory investigations implemented in laboratory environment.6. Based on 6701evm digital evaluation card, combined with analogy front-end, the paper designs a DSP software model to deal with baseband signal processing. An overall OFDM scheme, with modulation and demodulation function, is accomplished.

讨论分析了MIMO-OFDM中一种基于空频域的最优导频设置算法，给出了导频图案，通过仿真实验表明，该算法与理想的信道状态信息曲线非常接近，信噪比差距约在2dB左右，并且在快衰落条件下具有较好的稳定性，其性能要优于基于前导训练的信道估计方法。3、根据IEEE802.16OFDM系统特点，论文分别在Matlab中应用Simulink工具构建OFDM系统仿真平台、在LabVIEW平台上实现了OFDM调制解调仿真系统，模拟了整个系统的信号流程，进行了OFDM仿真系统参数的选择和调制模块的仿真设计、论证各算法性能，并根据各种不同的条件：例如高斯噪声、多径衰落、有无保护间隔等，对系统的误码特性进行了评估，为正确评价实际OFDM系统的性能提供了有效的理论依据。4、论文以软件无线电思想作为指导，提出了以256点IFFT／FFT为核心和以512点IFFT／FFT为核心的两种OFDM算法模式并存于同一个硬件平台、且可预选的方案，它们在参数选取和性能指标上有所差异，均实现了相似的模块和功能。5、论文参考IEEE 802.16无线网络标准的参数设置，针对本设计系统的应用环境和系统硬件的性能速率，提出了一种应用于实验室环境的信号结构、帧格式等参数设计。6、论文基于TI公司的6701evm数字评估板卡，结合模拟前端搭建数字中频平台，设计了基带处理的DSP软件模块并进行系统调试，基本实现了一套完整的OFDM调制解调方案。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。