参数方程

The database consists of nodimensional data of load carring capacities, maximum pressures and their positions, flow factors, and power loss factors by solving full 2D Reynolds equation including oil feed features of 360°, 180°partial groove, and single oil hole, corresponding to a series of power law index, length/diameter, groove width/length, hole diameter/length, hole diameter/bearing diameter, eccentricity, angle between the attitude angle line and centre line of oil groove/hole, rotary, squezze, and oil feed pressure factors.

数据库中的数据通过求解全二维Reynolds方程和热平衡方程获得。数据库由对应于360°全油槽，180°半油槽和单孔的三类轴承的一系列的幂率指数，宽径比、槽宽／轴瓦宽、油孔直径／轴瓦宽、油孔直径／轴承直径、偏心率、偏位线与油槽中心线之间的夹角、挤压因子、旋转因子、进油压力因子的一系列的轴承无量纲的特性参数组成：油膜承载力、最大油膜压力及位置、流量系数和消耗功系数。

In this paper,the raft is approximated by a thin plate with regular shape at first.Then the floating raft system is divided into several subsystems,such as plate raft,elastic foundation,etc,which are respectively modeled by four-parameter net method.After that,dynamic absorber and active absorber are put into a uniform frame to obtain the model of plate raft subsystem coupling with them.At last,according to the force and velocity relationship among each subsystem\'s interfaces,the entire plate floating raft system is modeled by subsystem structural admittance synthesis method.As the main structure of floating raft system is elastic,it is inevitably to study the optimization of actuators\' mounting positions before designing control law.In this paper,two new criterions are proposed for it.

本文首先将浮筏的中间筏架用一个规则形状的薄板近似；然后再将浮筏系统分解成若干个子系统，如板式筏架子系统、弹性基础子系统等，运用四端参数网络建立了它们的动力学传递方程，传递特性由导纳矩阵描述；接着，将动力吸振器和主动吸振器的(来源：ABC90论文00网www.abclunwen.com)分析统一于一个框架内，获得了与吸振器耦合的板式筏架子系统的动力学传递特性；最后，根据各子系统在各界面上的作用力和速度的相互关系，通过子系统结构导纳综合方法获得了整个板式浮筏系统的动力学传递方程，并在此基础上获得了系统的力传递函数模型。

To more briefly calculate the accurate solution of the hangingpoint motion parameters of the beampumping unit,the walking beam's swing equation according to the geometry relationship and movement characteristic of the four pitmen mechanism in the beampumping unit is found.

根据游梁式抽油机四连杆机构的几何关系和运动特点，建立了游梁的摆动方程，并由该方程得出了游梁摆角变化规律以及悬点运动的位移、速度和加速度的计算公式，从而给出了求游梁式抽油机悬点运动参数精确解的一种计算方法。

To make the transition curve in the process of gear modeling be more reasonable, the parameterized 3D model of involute cylindrical spur gears with whole profile was made with Pro/Engineer software, based on the study of equations of the dual-arc rack cutter＇ s profile curves and the cut gear＇ s tooth profile curves.

为了使齿轮建模时过渡曲线部分更符合工程实际，在对双圆弧齿条型刀具轮廓曲线方程和齿轮的廊线方程研究的基础上，利用Pro/Engineer软件建立了可变位的渐开线完整齿廊直齿圆柱齿轮的三维参数化模型，并对齿廊曲线连续性进行了分析。

Limits to the minimum spot size, imposed by space-charge effect, emittance and spherical and chromatic aberrations of the lens, are investigated by means of a five-order radial trajectory equation, the K~V envelope equation and an analytical method.

理论上，利用推导的非线性轨迹方程、K-V包络方程及解析方法研究了空间电荷效应、发射度、透镜球面像差和色散像差对最小焦斑直径的限制并对聚焦实验布局和参数进行了优化选择。

With the consideration of various factors affecting on the screening effect,a screening model for drilling fluid shale shaker had been established.

利用流体力学的基本原理，对钻井筛筛面上钻井液的流动特点进行了研究；在综合考虑有关参数对钻井筛筛分影响的基础上，建立了钻井筛的筛分模型，给出影响钻井筛处理量有关因素之间的定量关系；运用平均值法对筛分方程的求解进行了探讨；应用有限差分方法建立了筛分方程的仿真模型，并编写了钻井筛处理量的计算机仿真程序。

The results indicated that a dependable kinetic model could be obtained by modifying the Temkin equation by considering the H2 and NH3 adsorption factors. Activation energy for the ammonia synthesis reaction was obtained as 90.2 kJmol^(-1) after linear fitting the kinetic and thermodynamic parameters k, K(subscript H2) and K(subscript NH3) with the Arrhenius and Van't Hoff equation, which was much lower than that over iron-based catalyst, which indicated that the activation energy barrier of N2 dissociative adsorption on Ru was far lower than that on either the conventional magnetite-based catalyst or wustite-based catalyst; the hydrogen adsorption heat was 76.2 kJ mol^(-1), indicating that the adsorption of hydrogen on the Ba-Ru-K/AC catalyst was so strong that it inhibitied the dissociative adsorption of nitrogen.

结果表明，在Temkin方程中加入H2和NH3的吸附项能够获得可靠的动力学模型，用Arrhenius和Van't Hoff方程对动力学和热力学参数k、K(下标 H2)和K(下标 NH3)进行线性拟合，得到氨合成反应的活化能为90.2 kJmol^(-1)，远低于铁基催化剂，说明Ru上N2的解离吸附活化能垒远低于传统磁铁矿基催化剂和维氏体基催化剂。H2的吸附热为76.2 kJmol^(-1)，证明Ba-Ru-K/AC催化剂上H2的吸附较强烈，对N2的吸附有强烈的抑制作用。

Based on the elastic theory of large deflection and by taking into account the variation of the axial force and its effects on bending deformation of the drillstring in vertical section ,the vibration of the drillstring induced by fluctuating weight on bit is described by a parametrically excited system.

基于弹性大变形理论，考虑到轴力沿钻柱轴线的变化及其对钻柱弯曲变形的影响等因素，将受自重作用的铅垂井段钻柱在波动钻压激励下的振动转化为一个参数激励系统，用 Galerkin方法首次得到了描述此系统的 Mathieu方程，并通过将方程的解展成富里叶级数的方法，得到了该振动系统的动力分岔值曲线及其所包围的动力不稳定区。

Using the method of strained parameters for the two types of the parametrically excited systems including nonlinear and/or linear coupling term, the stability regions were derived.

船舶顶浪情况下，采用约束参数法分别对非线性耦合和线性耦合的方程进行了稳定性分析，得到稳定区域传递曲线方程。

A numerical solution of the isothermal EHL problem for finite line contacts has been pressnted which is convergence in moderate load and material parameters.

二。用差分格式离散二维Reynolds方程，通过间接求解的方法，推出了中等载荷和材料参数下收敛的等温有限长线接触弹流数值计算方法，有效地克服了等温有限长线接触Reynolds方程的强各向异性所产生的数值计算易发散问题。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。