参数变化

Under dry and hydrothermal conditions, systematic experiments were conducted on constitutive parameters of frictional sliding of gabbro gouge. We obtained the coefficient of friction and velocity dependence as functions of temperature up to 615 C, with normal stresses of 200 MPa and 300 MPa.

在干燥和热水条件下对辉长岩摩擦本构参数进行了系统的实验研究，分别得到正压力200MPa和300 MPa条件下的摩擦强度和速度依赖性参数随温度的变化。

It is found that the offset of weight function should change with the Peclet number, and that both the parameter q of radial basis functions and the size of the support domain have a greater influence on the calculation results than the RBF parameter a and the quantity of Gauss integral points.

结果表明：权函数的偏置量需要随着对流强弱而变化，径向基函数参数q、支持域尺寸对计算结果的影响比较大，RBF参数a、Gauss积分子域数对计算结果的影响相对较小。

Then the pile-soil stress characteristics and stabilizing mechanism of the composite foundation are fully discussed. Based on the close analysis of the influence factors of the vertical bearing capacity, circular aperture extension theory is employed to establish the computing formulas for the pile vertical stress and the foundation vertical bearing capacity, respectively. Moreover, with analyzing the features of the calculation parameters such as materials of gunite mortar, jet pressure, diameter of the jet pipe, pile length, pile layout, a design theory for chemical churning pile composite foundation is proposed. Then, the variation of the pipe deformation with loads, the deformation coordination of pile and soil are studied. And methods to decide pile-soil stress ratio and the compressive modulus are developed. Meanwhile, the corresponding design method and the design parameters are proposed. In addition, studies for construction technique and quality detection of the chemical churning pile composite foundation are presented.

在此基础上深入探讨了旋喷桩的桩土受力特性及其复合地基的加固机理，从影响旋喷桩复合地基竖向承载力的因素入手，基于圆孔扩张理论给出了桩体竖向应力及旋喷桩复合地基的竖向承载力计算公式；通过对喷射浆液、喷射压力选取、喷射直径估算、桩长及桩位设计等各种计算参数的深入分析和研究，提出了一套相应的旋喷桩复合地基设计计算方法；通过计算分析，深入探讨了旋喷桩复合地基变形随荷载变化规律、桩和桩间土变形协调关系、桩土应力比及复合地基压缩模量的确定，并提出相应的设计方法和修正参数；此外，结合工程应用，对旋喷桩复合地基的施工技术及其现场质量检测方法进行了较全面的探讨。

The priorities are the diversification characteristics of each targetin the subsequent water flooding. According to diversification characteristics of these targets,the paper studies how the heterogeneousness, water flooded condition, interconnectingcondition of zone;key measures injector parameters affect these targets from polymer floodingmechanism. Based on influence equations, production target prediction models are built usingHall curve theory, relative permeability curve, relations of water saturation and relativepermeability and material balance equation. Parameters of models are calculated by the way ofcomputer program and so that a simple, fast way have been gained to predict production targetof polymer subsequent flooding.

针对这些指标的变化特点，从聚合物驱油机理上分析其油层非均质性、油层水淹状况、油层连通状况、主要措施及注入参数等因素对这些指标的影响，在分流方程的基础上，利用霍尔曲线原理、相对渗透率曲线、含水饱和度与相对渗透率之间的关系以及物质平衡方程建立起开发指标预测模型，结合数学方法对模型参数进行计算，形成简便、快速、实用的聚合物驱后续水驱阶段开发指标预测方法。

After simplification of the Jou model,a diffusion dynamic equation, which was characterized with hyperbolic type, was obtained, then simulative analysis for three combined dimensionless parameters was done to research various diffusion behavior resulted from the change of model parameters.

经过对Jou模型的简化处理，得到了双曲型的扩散动力学方程，通过对模型中3个组合参数的仿真分析，研究了参数的变化可能导致的不同的扩散行为。

The input impedance and mutual coupling characteristic are analyzed and compared with those of side-fed patches.

分析了阻抗和散射参数在谐振频率附近的变化情况，以及馈电点宽度对这些特性参数的影响。

It indicts that fuzzy PID controller is better in transient response and higher in accuracy. It has a very good response characteristic to the input of jump and the input of slope, and it has better adaptability and stronger robustness when the system parameters have changed.

分析结果表明，参数自整定的模糊PID控制器具有很好的暂态响应性能和稳态性能，对阶跃输入和斜坡输入都具有较好的响应特性，对系统参数的变化具有较强的适应性和鲁棒性。

Energy cycle diagnosis of two versions of GOALS model which have participated in the Coupled Model Intercomparison Project shows: the favourable effect of the introduction of the diurnal cycle of solar radiation between the two model versions becomes obvious with respect to local contributions to energy cycle parameters.

对GOALS模式参加了CMIP计划的两个版本的能量循环诊断分析表明：辐射日变化参数化方案的引入对能量循环各参数的局地贡献有着明显的有利影响。

The one order differential model and convolutional model of impedance formula of amplitude versus offset inversion were established. Impedance inversion formula from AVO was derived based on Bayesian framework. Methods of using Huber function as prior model parameter distribution and covariance matrix from well log as constrains were developed. The P-wave impedance, S-wave impedance and density were calculated by the conjugate gradient algorithm.

为此建立了振幅随偏移距变化波阻抗反演公式的一阶差分模型及褶积模型，推导了基于贝叶斯理论的AVO波阻抗反演公式，给出了采用Huber分布作为模型参数的先验分布及测井数据的参数协方差矩阵作为约束条件的实现方法，并利用共轭梯度法计算了纵、横波阻抗及密度。

The purpose of this study is to investigate the changes of EMG parameter both in isotonic and isometric exercise, and to study the relations among EMG parameters between athletes of different events.

研究目的：探讨动力性与静力性肌肉收缩时EMG各参数的变化特征及疲劳时各指标的差异，比较不同项目运动员肌肉收缩特征对EMG参数的影响及与该项目的关系。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。