参数变化

Based on these data,AOT and Angstrom parameters were retrieved.

利用这些数据，反演了气溶胶光学厚度和相应的Angstrom参数，分析了光学厚度和Angstrom参数的日变化和逐日变化，并讨论了这些变化的原因。

Based on these data,AOT and Angstrom parameters were retrieved.Through analyzing the variation of AOT and Angstrom parameters,the reason which cause the variation was discussed.

利用这些数据，反演了气溶胶光学厚度和相应的Angstrom参数，分析了光学厚度和Angstrom参数的日变化和逐日变化，并讨论了这些变化的原因。

This approach not only inherits the advantages of absolute density based algorithms which can discover arbitrary shape clusters and are insensitive to noises , but also efficiently solves the following common problems: clustering results are very sensitive to the user-deflned parameters, reasonable parameters are hard to be determined, and high density clusters are contained fully in coterminous low density clusters. With this approach, incremental clustering can also be supported effectively by defining the affected sets and seed sets of the updating objects in this approach.

聚类算法的有效性问题主要表现在三个方面：其一，聚类算法大多要求用户输入一定的参数，例如希望产生的簇的数目，而这些参数通常难以确定，特别是针对高维空间中稀疏分布的实际应用数据集，用户几乎无法给出合适的算法参数，因此非专业用户需要与数据分析专家密切配合才能保证获得理想的聚类结果，导致算法的使用极为不便；其二，聚类结果对于输入的参数值过于敏感J，往往参数值的一些轻微变化却产生聚类结果的很大差异；其三，对于高维的实际应用数据集，其数据分布往往是稀疏的、杂乱的，很难为算法选择全局的参数进行准确的聚类分析，使得聚类的质量难以保证。

Through the flue gas and air characteristic analysis in supercharged boiler,the results showed that the value of parameters would increase with the increase of fuel consumption.And volume heat load of the furnace, fuel consumption, heat change between flue gas and convective heating surface and evaporation value would increase with the increase of compression ratio.The heat calculation would be different because of dissimilar thermal calculation in the turbo-compressor when the boiler load was changed.As the boiler load increased,heat loss in the turbo-compressor would increase and the efficiency of the boiler would decrease.The results of the boiler start-up simulation showed that the time of start-up would decrease with the increase of flue consumption ,but instantaneous pressure amplitude would increase.Steam water"s dymamic diversification would be more complex than flue gas"s,and dynamic characters of their parameters would be changed due to different boiler load and disturbance variable,which was shown by results of the simulation when boiler load was changed.

通过分析增压锅炉内的空气、烟气参数特性，发现随着锅炉负荷的增加，空气和烟气的各项参数值都相应的增加；炉膛容积热负荷、锅炉的燃料负荷随着增压比的提高成比例增加；随着增压比的增大，烟气与对流受热面的换热增加，蒸发量随之增加；由于涡轮增压机组在不同负荷下的热力计算不同而造成增压锅炉在不同负荷下的热平衡计算的不同；锅炉增压机组的总的热损失随着锅炉负荷的增加而增加，而增压锅炉的热效率随着锅炉负荷的增加而减少；锅炉启动模拟仿真结果中发现，锅炉启动时燃料量增加，锅炉的启动时间就会减少，但是瞬时升压速度会增加；而动态负荷变化模拟仿真结果中发现，锅炉汽水侧的变化相比烟气侧更为复杂，且在不同负荷和不同扰动量下，烟气侧和汽水侧的重要参数动态特性是不同的。

First, the conception of wet compression is defined. A calculation method of moist air and wet gas thermodynamics properties is set up, which treat them as real gas and can give out the results of any water-air/gas ratio. Second, the thesis build the simulation model of water injection between compressor stages of a single shaft gas turbine, based on which the stable analysis is processed and the characteristics of key performance parameters are given out, such as the variation of air flow, pressure ratio, turbine inlet temperature with the water quantities. Results showed that enhancement of power output is outstanding.

文中定义了湿压缩概念，研究适用于计算机计算的湿空气，湿燃气等实际气体的热物性计算方法，利用此法可较准确地计算任意水气比下湿空气，湿燃气的各热物性参数，建立并推导单轴燃气轮机级间喷水热力循环的数学模型，用此模型进行稳态循环分析，并得出级间喷水时燃气轮机各主要性能参数的变化规律，如随喷水量变化，空气流量、压比、燃气初温等的变化规律。

In the parameterized design of the hot wind furnace, the number of rows and columns of pipe bundle were always varied with design parameters, it was difficult to generate 3D parametric model of hot wind furnace.

在间接加热式热风炉的参数化设计中，蛇型管束的行数和列数随着设计参数的变化而变化，使得间接加热式热风炉三维参数化建模比较困难。

1 Bring displacement impact analysis for the orthogonal law surrounding rock mechanics parameters and initial tests to stress Quzhi changes will lead to varying degrees of influence displacement volume changes, we can make this change, as the parameters for the impact of displacement.

2.1 巷道位移影响度分析的正交试验法围岩力学参数和初始地应力取值的变化将会导致巷道位移量不同程度的变化，我们可以把这一变化，看作是各参数对位移的影响度。

A detailed model of non-linear parametric excitation vibration coupling the stay cable and the girder, in which the static sag as well as the geometric non-linearity are considered, is proposed in this paper. Based on several numeric examples investigated by the Galerkin method composed with the integration strategy, several kinds of factors effecting stay cable parameter vibration are studied. Another parameter vibration model by the axial excitation is presented and the corresponding nonlinear equations are derived. The smallest excitation amplitude,the transient state and steady state resonance amplitudes, and the changing characteristics of the axial force are obtained by using harmonic balance method. According to numerical examples calculated by numerical integration method, the effects of the inner damping of the stay cables are investigated.

本文创新地提出了斜拉桥拉索-桥面耦合参数振动模型，推导了索-桥耦合非线性参数振动方程组，联合Galerkin法及数值积分方法，对各种特性的拉索进行了数值求解，得出了影响拉索参数振动的各种因素；提出了斜拉索受轴向端激励参数振动模型，导出了模型的非线性振动方程，使用谐波平衡法得出了产生参数振动需要的最小激励幅值、共振时瞬态及稳态的振动幅值及索拉力的变化特性，并用数值积分方法对实际斜拉桥拉索进行了计算，分析了拉索阻尼对参数振动的影响。

The uncertainties of re serves calculation parameters, such as reservoir volume, porosity, fluid interface, hydrocarbon saturation and volume factor, are evaluated and given a possible variation range respectively, by analyzing their geological origins. The uncertainly variations of reserves calculation parameters are represented in geological modeling, and the OIIP evaluation is made by a combination of geological models with Monte Carlo simulations.

通过分析影响储层体积、孔隙度、流体界面、含烃饱和度以及体积系数等储量计算参数不确定性的地质成因，对各参数的不确定性进行评价并给出可能存在的变化范围；在地质建模中体现储量计算参数的不确定性变化；基于地质模型并结合Monte Carlo模拟方法进行地质储量评价。

Identification and selection of dominant vibration-modes contributory to wind-induced vibration response for large-span space lattice structures;2. The wind-induced vibration response of single-layer cylindrical shells is analyzed by frequency domain method in this paper.

运用频域分析法对单层筒壳进行风振动力响应分析，在基本参数(阻尼比参数、地貌参数、几何参数、支座高度参数)的常用变化范围内，进行大量的算例计算，然后对所得的计算结果进行统计分析，考察各参数对单层筒壳的风振响应及风振系数的影响，在此基础上提出单层筒壳抗风设计的实用方法。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。