参数化
- 与 参数化 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The results showed:(1) Through glycosylated orthogonal test, When the substrate concentration is 1:2, glycosylated temperature is 60℃, the enzyme dosage is 0.5%and glycosylated time is 6 hours, glycosylating was at best, and the sugar concentration was 33%(2) through fermentation orthogonal test, when adding the yeast is 2.0%, proportion of Rhodiola and glutinous rice is 1:1, the temperature is 28℃, and fermentation time is seven days, alcoholicity of the wine was the highest and sensory evaluation was the best..
本文立足加工高品质的红景天糯米保健酒,主要对糖化条件,发酵工艺参数的确定,后发酵温度的确定,稳定性试验,膜过滤试验条件,营养成分分析等方面进行系统的研究,结果表明:(1)通过糖化正交试验,在底物浓度1∶2、糖化温度60℃、酶用量0.5%、糖化6h时糖化效果最好,糖液浓度33%;(2)通过发酵正交试验,在酵母添加量2.0%、红景天糯米比1∶1、发酵温度28℃、发酵时间7天生成的酒度最高,感官评价最好;(3)通过后发酵试验,选择10~15℃温度下后发酵,酒体澄清,感官评价最好;(4)从对红景天糯米酒稳定性分析中得知:酒体在低于-6℃时略有絮状物出现,酒体混浊沉淀的主要原因可能是蛋白质。
-
Only one parameter is introduced to describe the plasticization effect, and it can be easily estimated by thermodynamic theory about the glass transition temperature depression.
对橡胶态适用的自由体积参数在此模型中保持有效,所引入的表达溶剂可塑化效应的唯一参数β可以通过计算玻璃化温度来确定。
-
The effects of technical parameters of laser surface alloying processing on the qualities of the alloyed layer of rocker arm used in motor were investigated with orthogonal test,and the factors and their levels were analyzed.
采用正交试验,对激光表面合金化工艺参数进行了优化,分析了各工艺参数对气门摇臂合金化层质量的影响。
-
In order to fully refect the geo-tech basic mechanics behaviors and to rationally explain the strain localization, this paper establishes the theory framework of gradient-dependent plastic model based on the theory framework of gradient-dependent plastic mechanics and in considering the plastic strain's gradient-dependence in double yield function, offers a kind of possible concrete pattern of the generalized plas...
为了较全面地反映岩土的基本力学性质,同时合理解释应变局部化现象,本文基于广义塑性力学的理论框架,在双重屈服函数中考虑了塑性应变的梯度依赖,建立了广义塑性梯度模型的理论框架,并给出了广义塑性梯度模型的一种可能的具体形式,分析了该模型的各个模型参数,尤其是其中的&局部化参数&的物理意义和可能对其产生影响的因素。
-
The method is based on a variable structure to control the SVC, wherein, the variable structure control method comprises two aspects of the unbalanced load equalization compensation and the parameter control of a PI controller, wherein, the unbalanced load equalization compensation adopts the SVC compensation susceptance computational method which is based on the synchronous rotation reference coordinate transformation of a virtual symmetrical three-phase system; meanwhile, in the stabilization control of the system voltage, the ant colony algorithm optimization method is adopted to real time adjust and to optimize the parameter kp and ki of the PI controller.
本发明公开了一种静止无功补偿器的不平衡补偿和蚁群优化方法,基于变结构对静止无功补偿器SVC进行控制,其中变结构控制方法包括不平衡负荷平衡化补偿和PI控制器的参数控制两个方面,其中不平衡负荷平衡化补偿采用基于虚拟对称三相系统的同步旋转参考坐标变换的SVC补偿电纳计算方法;同时在系统电压稳定控制时,采用蚁群算法优化方法,对PI控制器的参数kp、ki进行实时调整、寻优。
-
The operating main points and parameters of potato steaming-gelatinizing , liquefying , saccharifying and fermentating are introduced emphatically , the operating points and parameters of preparations of mulberry leaf juice are introduced.
重点介绍了马铃薯的蒸煮糊化、液化、糖化、发酵等工序的操作要点和工艺参数,介绍了桑叶汁制备的操作要点和工艺参数。
-
A multi-distance measurements method is employed in this paper. A single parameter fitting method and a double parameters (reduced scattering coefficient and amplitude factor) fitting method on the basis of the least square Newton fitting algorithm is used to derive the optical parameters respectively. For the finite-thickness homogenous tissue, it can be concluded that the rest terms in expressions of diffusion reflectance and transmittance for the corresponding tissue geometries that subtract the exponential term contained source-detector distance depend on the detected position weakly.
在多程测量的基础上,使用单参数最小二乘牛顿法拟合方法和双参数(约化散射系数、幅度因子)最小二乘牛顿法拟合方法,得到有限厚均匀组织的反射率分布和透射率分布公式中除去包含测量位置的指数项的其它部分对测量位置皆具有弱依赖性的结论,并对拟合结果进行了分析讨论;而对于有限厚平板状双层组织,可根据对反射测量结果及透射测量结果进行拟合所得的约化散射系数间的差异及常数因子的正负判断双层组织的可能结构分布。
-
At first, we made up an appropriate configuration of design and determined which factors might have effect on slim products. Then we determined control factors and standards of control factors that were set according to the standard of Dr. Taguchi's experimental orthogonal array. With the bigger the better of orthogonal array, L9(3^4), we conducted confirmation procedure on operating factors by use of cypress essential oil on slim cosmetics. The experiment was used to obtain best combination of parameters by S/N ratio and characterizations that were based on the data constructed by Taguchi Methods.
首先,决定配方中的控制因子以及控制因子的水准,依照田口方法中直交表的设定,配合实验之望大特性,利用L9(3^4)直交表所建立的数据资料别以S/N比及品质特性两方面进行最佳化参数组合之求取,並依照所决定出之最佳化参数进行確认,最后再以变异分析来確认重要因子的存在性。
-
The calculation of parameter m_0,that is the amount of CO_2 absorbed by unit volume of concrete completely carbonated,was proposed by the analysis of concrete hydration process and carbonation mechanism,and the simplification formula of fly ash concrete applied in practice was suggested.The calculation of another important parameter D_e,that is the effective diffusion coefficient,was also proposed on the basis of the mechanism gas diffusion in concrete.
通过对混凝土水化过程、碳化机理的深入分析,提出了模型参数——完全碳化时单位体积混凝土吸收二氧化碳的量m_0的计算方法,并给出了工程中常用粉煤灰混凝土的简化实用公式;基于气体在混凝土中扩散机理的分析,给出了另一个重要的模型参数——二氧化碳在混凝土中有效扩散系数D_e的计算公式。
-
The effects of blade stiffness mistuning on the natural frequencies and mode shapes in the frequency veering region were studied based on the lumped parameter model of a bladed disk. A parameter L was introduced to define the severity of mode localization.
基于叶盘集中参数模型,分析了叶片刚度失谐对频率转向区内的系统固有频率及叶片模态振型的影响,提出了一个描述模态局部化程度的参数,仿真研究了频率转向特征对失谐叶盘模态局部化程度的作用规律。
- 推荐网络例句
-
For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether
年美国个人破产法的一个改动使得破产登记急速下降,而后引起了信用卡大规模的亏损。
-
Eph. 4:23 And that you be renewed in the spirit of your mind
弗四23 而在你们心思的灵里得以更新
-
Lao Qiu is the Chairman of China Qiuyang Translation Group and the head master of the Confucius School. He has committed himself to the research and promotion of the classics of China.
老秋先生为中国秋阳翻译集团的董事长和孔子商学院的院长,致力于国学的研究和推广。