参数

The result shows that the real accuracy of VLBI and GPS geocentric coordinates is within 1cm, and the scale deflection of VLBI and GPS techniques is very little, the result using seven-parameter model to process coordinate transformation is better.

分别采用七参数和九参数模型对VLBI数据和GPS数据进行坐标转换，结果表明，VLBI与GPS的符合精度小于1dm，两种技术所获得的坐标在尺度上的差异很小，七参数的转换结果更优。

In this paper, on full automatic production condition, parameters of on-line sand testing system and double-disk cooler were optimized, and moulding-sand parameters of clay content, permeability, compactibility, and so on, were adjusted and optimized, and moulding-sand property parameters' control on full automatic production condition was also involved. The results can supply some reference for other similar production.

本文着重介绍了全自动生产条件下在线型砂性能检测控制仪、双盘冷却器控制参数的优化，结合生产铸件对型砂性能的实际要求，对型砂含泥量、透气性、紧实率等参数进行的调整和优化，以及全自动生产条件下砂处理工艺参数的控制范围和控制方法，本文可为相似生产条件下砂处理系统的调试和型砂性能控制提供一些参考。

Based on the theory study, a directional drilling guidance system is developed for practical require, its working flow as follows: before construction, design the best track practically, and save in the system. During drilling, the system measures well oblique angle and azimuth to watch well track. Drill driver compares designing well track with measuring track showing on display unit, controls joy stick experientially, adjusts drill direction, finally realizes directional drill.

在理论研究的基础上，结合实际需要，研究设计了一种定向钻井导航系统，使用该系统进行定向穿越施工的工作过程如下：在施工前，根据实际情况，先设计一条最佳穿越路线，存入系统；在钻进中，系统通过对井轨的井斜、方位等参数的测量，对其进行实时监测；地面的司钻手通过对显示仪所显示的实际井轨参数及设计井轨参数进行比较，根据经验操纵操作杆，调整钻机前进方向，以达到对钻进过程的控制，最终实现定向钻井。

The relations of parametric equations with the route coordinates and the part coordinates are found out according to the curve model,the parametric equations of middle and side stakes in circular curve and easement curve are derived,thence the value of parameters is obtained,the solution procedure is got.

根据曲线模型，找出线路控制坐标系与局部坐标系坐标之间的参数方程关系，推出了缓和曲线及圆曲线中边桩坐标的参数方程，代入已知量求得参数的值，给出了求解步骤。

The effect of single factor indicated that lower concentration of tea polyphenols and oxidant, temperature, ester proportion and pH value, shorter reaction time were favorable to the formation and accumulation of TFs, higher concentration of tea polyphenols, temperature, ester proportion and pH value, longer reaction time were favorable to the formation and accumulation of TRs.

借助参数模型研究各参数因子对TFs和TRs形成的影响，结果表明：茶多酚浓度、温度、酯比例及pH值对TFs和TRs形成与积累均有显著影响，反应时间对TFs影响显著，氧化剂对TRs影响显著；单因素效应显示：较低的茶多酚和氧化剂浓度、适当的低温和较短的时间、低的酯比例和pH较有利于TFs形成与积累，而有利于TRs形成与积累的参数则相反。

Adhibiting the nerve cell and qurdratic capability target, by the self-adapting self-studying consistent and better abiding of the nerve cell ,the thesis realizes the conforming of the parameter not depending the canal mathematics ,furthermore the parameter can self-adjust for the information of the canal.Combining the BP nets and the routine PID controller, and adhibiting the linear optimization target function, the thesis realizes the conforming of the parameter not depending the canal mathematics, furthermore the parameter can self-adjust for the information of the canal. Using the MATLAB the thesis simulates and acquires some significative effects.

在传统PID渠道控制中引入了神经元和二次型性能指标，利用神经元自适应、自学习、并行处理及较强的容错能力，实现了PID控制中参数的整定不依赖于渠道数学模型，且PID参数能根据渠道的适时信息在线调整以满足适时控制的要求将BP网络与常规PID控制结合，并引入了最优化目标函数，利用BP网络来实现PID控制器参数的在线整定，将其运用于渠系等体积控制，并利用MATLAB软件进行了数值模拟仿真，取得了一些有意义的成果和较为满意的结果。

After analyzing the process of computing the linear spectrum frequencies , this dissertation gives one new method: first computing the intervals containing LSFs, then exactly searching LSFs by successive bisections and interpolations.

针对线谱参数，通过分析参数求解过程，本文提出先求参数所在区间、再用二分法进一步精确的算法。

The reservoir rock types in the region of interest are grain limestone, algal limestone, cryptite, siltstone, muddy limestone and mudstone. The thesis identified as a result of changes in the deposition causing the heterogeneity in plane, and then the geological oil reserves have been calculated in accordance with the areal heterogeneity.3、Based on the data of core analysis, bore logging, array induction imaging log and FMI, porosity and permeability model were built using regression analysis. Through testing 45 rock samples, a, b, m, n value were obtained and used to calculate single-layer oil saturation value using the Archie formula. According to the theory of laterolog and inductolog, resistivity ratio and cross plot were used to identification effective thickness. Effective thickness was identified delicately in 103 wells. Based on the over work, active porosity and oil saturation was calculated accurately.4、According to observation of 100 pieces of the thin slices, cast thin slices and 383m core in three wells, the chief diagenesis in this area were compaction, cementation, denudation and cataclasis. Cementation and denudation were universally influenced active porosity this area. The intergranular pores, residual pores and secondary pores were formed in thin carbonated reservoir of lacustrine facies.5、The influence of reservoir heterogeneity to reservoir calculation was analyzed systematically using actual data. And the conclusions were as follows:①The principal reason leading to oil distribution unequal is interior structural feature of reservoir in structural hydrocarbon reservoir.

确定了由于沉积微相的变化而导致的平面非均质性，进而在平面上按照平面非均质单元计算了石油地质储量。3、利用岩心分析、常规测井曲线与阵列感应、成像测井资料相结合，分岩性利用回归分析方法建立了储层孔隙度、渗透率模型；通过对45块岩样进行岩电试验，获取了a、b、m、n值，利用阿尔奇公式计算了各单层含油饱和度值；根据侧向电阻率和感应电阻率串并联特性，利用电阻率比值法与常规交会图法相结合重建了有效厚度图版，对全区103口井目的层段进行了有效厚度精细划分，通过以上工作，准确求取了储量计算单元内有效厚度参数、有效孔隙度参数以及含油饱和度参数。4、通过对研究区3口井383m岩心观察，100余块薄片、铸体薄片镜下鉴定得出：油泉子油田上、下油砂山组储层主要成岩作用是压实作用、胶结作用、溶蚀作用和破裂作用，其中溶蚀作用、胶结作用最普遍，这两种作用对有效孔隙度影响最大，以上成岩作用形成了原生粒间孔、粒间残余孔和次生孔隙(如粒间溶孔、粒内溶孔、铸模孔、晶间孔等)为主的薄层湖相碳酸盐岩储层。5、利用实际资料，系统分析了油藏非均质对储量计算的影响，认为：①对于构造油气藏而言，油气藏构造及断裂特征是造成油气分布不均的首要原因，储集条件相同的条件下，构造高部位有利于储存油气，油气在垂向的重力分异体现了油气藏内部构造的不均一特征。

Stability of solutions of the cavitated bifurcation equation is discussed in each region by using the minimal potential principle, and the catastrophic phenomenon of cavity formation is explained. 2. In Chapter 4, problems of cavitated bifurcation for two spheres, which are composed of two different kinds of imperfect compressible hyper-elastic materials, were examined, respectively. The parametric analytic solutions of the radially deformed function and the parametric cavitated bifurcation solutions are all obtained for the two spheres.

利用奇点理论给出了空穴分岔方程在分岔点的等价正规形，将缺陷参数分成若干个区域，证明了当缺陷参数属于某些区域时，具有缺陷的超弹性材料球体发生空穴分岔时的临界载荷比无缺陷的小；并利用最小势能原理讨论了空穴分岔方程的解在各个参数区域内的稳定性，解释了空穴生成的突变现象。

Source images with wavelet are decomposed, and corner information can be detected in the two approximate sub-images on the wavelet coarsest level. The initial registration parameters are achieved through affine transform model. The optical flow is iteratively refined to get the coarse registration parameters. The process will continue until the final and accurate matching parameters are obtained.

首先对源图像进行小波分解，在小波金字塔最顶层的低频近似子图像上进行角点检测，通过仿射变换模型得到初始配准参数；然后将这一参数逐层进行迭代精炼，直至达到金宇塔最底层，得到最终精确的配准参数。

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。