厚片

The object of projectile design is analyzed, and the layer-TOPSIS method is provided for the evaluation of total effectiveness by taking the layer concept into the TOPSIS method. In the calculation of object weights, the grade calculation method is suggested, which has less dependence on the subjectivity of decision-maker and can take account of both sensitivity and allowableness of objects, the geometric-arithmetic method is provided for grade weight calculation and methods for sensitive weight and allowable weight are given. Of modes in system analyzing, the penetration model of target with spherical-fragment is carried out based on the theory of Dynamic Spherical Cavity Expansion, and it is a supplement of the models for calculation the damage of the fragmentation warhead to target.

对弹丸设计进行了目标分析；通过在TOPSIS方法中引入层次结构的概念，提出了适用于弹丸总体效能评价的层次TOPSIS评价方法；在指标权重计算中，提出了对决策者主观依赖较少的能反映指标的敏感性和相容性的分级权重计算方法；在分级权重计算中，分别给出了等比-等差权值计算方法和敏感-相容权值计算方法；在系统分析的模型中，对破片战斗部的威力计算中的模型进行了补充，在空穴膨胀理论的基础上提出了球形破片侵彻有限厚靶板的侵彻计算模型。

According to experts, wood veneer in the production of solid wood will be cut to about 2 mm thick pieces of wood, with a special adhesive, attached to the furniture surface, and then by painting, UV baked, characterized by a smooth touch, knock on wood buckle with a finger thick plate has a sense of clarity but the irregular surface of wood, in the plate corners can be vaguely seen around 1 mm veneer.

专家介绍，实木贴面在制作中将实木切成约2毫米厚的木片，经特殊粘连，贴在家具表面，再经上漆，紫外线烘烤而成，特点为触摸光滑，用手指扣敲木板有厚实感，表面木纹清晰但不规则，在板块转角处可隐约看见1毫米左右的木皮。

For accurancy test, we use metal coupon as standard gauge block from Greateck Automation, 75% area is 1.1mm thickness, 25% area is 0.9mm thickness.

对于准确度实验，我们使用金属片作为标准测试片(从马来西亚GREATECH购买)75%部分是1.1MM厚，25%是0.9MM厚。

Among them,12 ears used epiderm had continous dilatation for 3～6 months,and no constrictive or atretic condition occured;7 ears used intermediate split thickness skin graft had no dilatation after operation,and no scars in donor;4 ears used skin flap had no dilatation after operation,and no constrictive or atretic condition in external auditory canal.

内容提要采用皮片和皮瓣为23耳行外耳道成形术，其中采用表层皮片12耳，术后持续扩张3～6月，未发生狭窄或闭锁；采用中厚皮片7耳，术后不扩张，供皮区无瘢痕增生；采用皮瓣4耳，术后未扩张，外耳道无狭窄或闭锁。

Methods The hyperpigmented intermediate-spl it-thickness skin grafts of 16 patients' face and cervicum 1 year after operation was harvested and the normal skins around the recipient site and the donor site were used as controls.

取患者自愿捐赠面颈部自体中厚皮片移植术后1 年的色素沉着皮片16 例，以自体移植皮片受区周围及原供区皮肤作为对照。

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80～100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100～300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能，且合金内的V元素会向表面富集，因此，钛合金真空热处理和表面涂层的烧结温度不能过高，即应低于其相转变点；通过对生物活性梯度涂层的组成和结构的设计，分析和计算了梯度涂层内的应力大小和分布，结果表明：对于本研究，当成分分布系数n=1.5时，可以获得较合理的涂层力学性能，即在沉积开始时，采用富含BG颗粒的悬浮液，以便在钛合金侧获得同底层BG有良好过渡的富BG涂层；梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定，改变成分分布系数，只能改变涂层内应力变化的趋势；涂层的厚薄不影响涂层内的应力分布规律，但涂层越薄，涂层内的应力变化越快，但这并不意味着涂层越厚越好，因为涂层越厚，涂层允许的变形越小，对于应用于弯曲受力部位的涂层而言，涂层应薄一点为好(50μm)；而对于仅纯受剪切应力的部位，如牙根种植体，涂层可适当加厚(80～100μm)；通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现，它们在水溶液体系中很难发生电沉积；在无水乙醇溶液中，HA颗粒带正电，可在阴极钛合金片上发生均匀的电泳沉积，而BG颗粒则带负电荷；利用复分解反应法，可以制得100～300nm的HA，通过诱导HA在BG颗粒表面结晶，可对BG颗粒进行表面包覆，获得了被HA包覆的BG颗粒，改变了BG颗粒表面的带电特性，使BG和HA颗粒在无水乙醇中均带上正电荷，从而实现了HA和BG颗粒在阴极上的共沉积。

According to the practical situation that the plates of mat or pile梞at foundation are thicker and thicker, the thick梡late theory and fitful eight joint element are used in this paper. By these means, the unregular plates and plates of which thidkness is not same can be calculated.

根据高层建筑片筏和桩筏基础的筏板厚度通常较大的实际情况，本文在筏板的有限元分析中采用了中厚板理论和与之相适应的八节点等参单元，并可用来分析不等厚的筏板和异形筏板。

The research results indicate that if high explosive projectile explodes near or in front of the thick steel tube in some short distance, the generated fragments' impactions will cause clear damages to the steel tube.

研究结果表明，杀爆战斗部在厚壁钢管侧方或前方近处爆炸，形成的破片对厚壁钢管有较为明显的破坏效应。

A concentrated hue in the second thickness was found in CARAT ceramic which had high ability of opaque and had a stable hue of ceramic in comparison with other opaques.

结果试片明度随不透明层的增厚呈增亮趋势，并趋向稳定在某一厚度值而不再增加，该厚度值在不同品牌间有所不同，其中PCARAT系列明度变化最小；而样本色度也随不透明层的增厚逐渐稳定，到达一特定厚度时可完全遮盖底层金属色。

Is one: the petrochemical, chemical, metallurgical, mechanical, electrical, pharmaceutical, light industry and the nuclear industry and other professional services industries, the production of material specifications, heat-resistant steel, resistance Steel mill heat-resistant alloy steel, rare earth wear-resistant steel, high-pressure high-temperature nickel chromium alloy steel: Steel Casting products, high temperatures centrifugal cast pipe casting, centrifugal cast pipe (casting thickness: 5 mm ---- 60mm, outside Drive: 50 mm ---- 1600mm, single-tube products such as super-6 m diameter size of the cast pipe products) tube, cracking furnace tube, and into the furnace, the furnace tube radiation, radiation control, the loser of the ash, the reaction of various Furnace roll, roll bottom, the furnace roll, sank roll, roll stability, and various types of precision casting fixture, heat-resistant steel castings, and Steel Plant for Hot Piercing Plug casting, casting industrial furnace, heat treatment furnace industrial castings , Heat-resistant castings, wear-resistant steel castings, various types of chemical process pumps, plastic alloy centrifugal pump fluoride, fluoride alloy pump, stainless steel pumps, valves, pipe, steel-lined composite of various pieces, all kinds of PTFE Plastic pipe, fin tube heat exchanger, paper, chemicals, light industrial and textile enterprises such as air-conditioning GL Ⅱ type, U-radiators, welding a variety of stainless steel, alloy steel, carbon steel, high-frequency finned tube , Studded tube, sawtooth-shaped fin, and other products of the manufacturing enterprises.

靖江市舒尔机械制造有限公司是一家为：石化、化工、冶金、机械、电力、制药、轻工和核工业等行业服务的专业公司，生产各种材质规格的，耐热钢、耐磨钢耐热合金钢、稀土耐磨合金钢、高温承压高镍铬合金钢：特钢铸造制品、耐高温离心铸管铸件，离心铸管（铸造壁厚：5mm----60mm、外径：50mm----1600mm，单管制品长6m等超大径的铸管制品尺寸）炉管、裂解炉管、转化炉管、辐射炉管、辐射管、输灰管、反应管、各种炉辊、炉底辊、炉内辊、沉没辊、稳定辊、及各类精密铸造工装夹具，耐热钢铸件，钢管厂用热轧穿孔顶头铸件、工业炉用铸件，热处理工业炉用铸件，耐热铸件，耐磨钢铸件，各类化工流程泵，氟塑料合金离心泵，氟合金泵，不锈钢泵、阀门、管件、各种钢衬复合管件，各类聚四氟乙烯塑料管件，翅片管换热器、造纸、化工、轻纺等企业的空调GLⅡ型，U型散热器、焊接各种规格的不锈钢、合金钢、碳钢等，高频翅片管、钉头管、锯齿形翅片管等产品的生产企业。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了