厚度

The liquid heating and allopatric temperaturemeasuring method were adopted in the technology in order to heat the two sides of specimen with NWAS evenly and keep the temperature difference constant, and to measure the temperature of the two sides of the specimen.

该技术创造性地采用了液流加热以及异地测温的新方法，成功地解决了对微米厚度的一维纳米线阵列结构热电材料试样两侧均匀加热并保持两侧的温差恒定，以及微米厚度的试样两侧测温的难题。

In addition, the met amorphic PTt path reflects that the thickness of oceanic crust of the Mian-Lue small ocean is thinner than that of the standard oceanic crust.

此外，变质作用PTt轨迹还反映勉略小洋盆洋壳厚度与标准大洋型洋壳厚度差异较大。

The method includes the following steps: depositing a non-magnetic layer (3) of sufficient thickness; anisotropically etching the non-magnetic layer to form a steep wall of suitable dimensions at the required position of a flux guide; depositing a magnetic material to form a magnetic layer (9) on the wall in such a manner that the magnetic layer has a thickness corresponding to the required track width; removing undesired deposits of magnetic material but maintaining the magnetic layer on the wall; depositing an insulating material (19a) to cover the magnetic layer.

该方法包括下列步骤：淀积足够厚度的一个非磁层(3)；非均质地蚀刻该非磁层以便在磁通引导的要求位置形成适宜尺寸的阶跃内壁；淀积一个磁性材料，以便在该内壁上形成一个磁层(9)，使得该磁层具有对应于该要求的磁迹宽度的一个厚度；去除不希望的淀积的磁性材料而保持在该内壁上的磁层；淀积一个绝缘材料(19a)以便覆盖该磁层。

The frictional heat energy was concentrated on the thermal effect layer with the thickness of 4 mm, The temperature gradient of contact surface is the highest, and decreased rapidly with the radius direction of the lining's groove. The temperature gradient and TEL's thickness increased with the increasing of the sliding speed. The temperature decreased rapidly with the radius direction and also with the increasing of center angle of the lining's groove. The sliding speed and distance are obtained under two sliding conditions when the lining fails, which supply the theoretical basis with the antislip design of friction hoist.

摩擦热量集中在热影响表面层，其厚度仅为4mm，接触表面温度梯度最大，沿绳槽径向迅速减小；温度梯度和热影响表面层厚度随相对滑速的增大而增大；衬垫温度沿径向急剧降低且随圆心角增大而减小；并得到了2种滑动工况下衬垫失效时的相对滑速和滑动距离，为摩擦提升防滑设计提供理论依据。

The basifacial soft tissue thickness is thicker than midface and facial superior part.Malocclusion facial soft tissue thickness difference concentrate on facial lower third .

颅面部软组织并非均匀覆盖在硬组织上的，颅面部软组织覆盖厚度在面部各个部位差别大，面下部软组织覆盖厚度比面中部和面上部厚。

The results show that the displacement of rock body may change direction in regulative distortion phase, the displacement presents periodicity according to the storing and the destroy of the energy of rock distortion, the quantity of displacement of the top is more than that of the bottom, the quantity of displacement and the destroy periodicity of the reinforced terrane infused plasm are less than that of the irreinforced terrane infused plasm, the convergence of bordroom is the displacement of certain thickness wall rock of surface layer.

得出：岩体在调整变形阶段可能改变位移方向，岩石破坏呈现周期性，洞室边墙上部比边墙脚位移大；注浆加固后的岩层比未加固岩层的位移小，破坏周期短；洞室的收敛只是表层一定厚度的围岩位移的外在表现，收敛层外岩体向山体方向移动；加固破碎围岩的关键技术是按照工程所处应力场，充分考虑加固层周围地质构造影响，设计加固层的厚度和加固闭合拱。

The average relative error between EM measurements and drill holes data was 12%.The statistic of all ice thickness profiles shows the distribution of smooth surface ice in the Bay of Bothnian was

对波西尼亚海湾海冰厚度探测剖面的统计结果表明，2007年春季该区域平整冰厚度范围在0.4-0.6m之间。

For each subject, the buccolingual bone thickness was measured by postulating that the miniscrews would be inserted at 16 positions (10, 12, 14 and 16 mm above the median sagittal planes of the interradicular spaces between the first molars and the second premolars in the maxilla, and 30°, 45°, 60°, 90° from the cortical bone surface).

在重建后的锥形线束CT影像上测量上颌第二前磨牙与第一磨牙牙根间矢状面上距离参考平面10，12，14，16 mm的4个植入高度上，以与骨皮质表面成30°，45°，60°，90°的4个方向共16个部位的颊舌侧骨质厚度，计算各植入部位触及上颌窦的危险率，在骨厚度大于6 mm的植入部位模拟植入微螺钉种植体并测量其周围骨质密度。

With the laser power and the time of irradiation increased, the sealing depth of dentinal canaliculi increased.

激光功率不变时，牙本质小管的封闭厚度随照射时间的增加而增加；照射时间相同时，牙本质小管的封闭厚度随激光功率的增加而增加，且具有显著性差异。

The results showed that fruit crispness was influenced by several factors including fruit skin thickness, thin-wall cells increasing progressively, cellulous content and fruit hardness. The relationships among those factors showed that thicker epidermal cells might mean unsuitable fruit crispness. Fruit crispness would be better if the volume of thin-wall cells very close to epidermal size increased rapidly.

对黄瓜果实脆度与组织结构和纤维素含量关系的初步研究表明，影响黄瓜脆度的因素包括果皮厚度、薄壁细胞递增情况、纤维素含量和果实硬度等，它们的基本关系表现为：表皮的厚度要适中，过厚的表皮脆度不好；近表皮的薄壁细胞由大到小递增快的，多表现为比较脆。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐