厚壁的

The article finally through analyzing of the Zhejiang YiwuBinwang bridge temperature load, obtained the CFST arch bridge temperature stress rules with the temperature load which is including from top to bottom and from margin to core of arch-rib when the temperature value、 steel pipe wall thickness value and marking value of concrete change. The rule is that the axial force、 bending moment, as well as the shearing force elevates along with the change of temperature increases, so the control section stress which is linear relationship is. The article further proved the change of steel pipe wall thickness and marking value of concrete is not remarkable influence on temperature stress and internal force of arch ribs control section.

文章最后通过对浙江义乌宾王大桥温度荷载分析，得出了在由上至下和由周边向核心呈梯度变化的温度荷载作用下钢管混凝土拱桥结构应力随温度值、钢管壁厚值和混凝土标号值变化时的规律，即：轴力、弯矩以及剪力随着温度变化值增大而增大；钢管混凝土拱桥主拱肋的控制截面应力值亦随之增大，基本呈线性关系；并通过计算论证了拱肋各截面应力、内力值同钢管壁厚的变化、核心混凝土标号变化无关。

Results:1、Three distinct bladder mucosa patterns were seen:normal mucosa and wall,but the urine was light-echogenic;the mucosa and wall thickened with enhanced echoes and irregular mucosa;local mucosa thickened in rhomb or flat figure.2、The bladder wall diffusively thickened or somewhere,three layers of the wall clear or obscure.3、Some echoes spots floating in the urine.

结果：1、膀胱粘膜图像可分为三类：A、粘膜未见确切异常回声，但尿液有漂移光点；B、粘膜弥漫性增厚，回声增强，粗糙不光滑呈细颗粒状、断续状表现；C、粘膜局灶性增厚呈棱形或扁平状；2、膀胱壁回声可正常，弥漫性增厚或局灶性增厚，三层结构可辨，基本可辨或分辨较差；3、尿液内出现不同程度的光点透声。

Based on the in-situ measurement of temperature during freezing sinking,the influence of the temperature field of ice wall on that of outer shaft wall was studied.

通过对龙固副井冻结凿井期间外壁与冻结壁温度的现场实测，研究了冻结壁温度场对外壁水化热温度场的影响，获得了特厚冲积层冻结凿井期间外壁及冻结壁温度变化的基本规律。

There are many cross-section forms in this bridge style. The form of double thin-wall piers is popularly used among of them. The key problem is how to choose the thickness of one single pier and the distance between two single piers from center to center. Depending on technical experience or trial analogism, the conventional technical methods have some limitations.

在大跨径连续刚构桥桥墩截面形式中，双薄壁墩又是较常用的一种截面形式，其设计的关键问题是如何合理的选择双薄壁墩的墩中心距和壁厚，传统的技术方法是凭借经验或类比试算来决定墩中心距与壁厚，具有一定的片面性。

In present study, the model of the low shear stress in carotid or hypertension was established by the ligation of partial distal branches of the left common carotid or the coarctation of aorta in SD rats respectively. In some rats the low shear stress in carotid was accompanied by the hypertension. The media and intimal thickness, as well as the ratio of vessel thickness to inner diameter were determined by morphometrical approach.

本文通过腹主动脉缩窄、结扎左颈总动脉的部分分支建立了高血压、左颈总动脉低切应力、以及高血压伴有低切应力大鼠动物模型；几何形态学方法观测左颈总动脉的壁厚及壁厚/内径比的变化；金属蛋白酶谱法分析MMP-2活性；免疫印迹法检测信号通路分子p-Akt、p-38分子以及Rho GDIα的表达变化。

The results show that increasing the ball numbers and mandrel extension length may reduce the ovalization, but leads to more remarkable wall thinning; the ovalization becomes more severe with the larger bending angle; the smaller the relative bending radius, the larger the ovalization is; the ovalization and wall thinning degrees are both smaller in the case of pressure die with dry lubricant; and under the same bending condition, the ovalization of LF2M tube is larger than the one of 1Cr18Ni9Ti tube.

结果表明，增加芯头个数与芯棒伸长量都能减小弯管的截面畸变，但两者都导致弯管壁厚减薄量增大；随着弯曲角度的增加，截面畸变越严重，相对弯曲半径越小，无芯棒与芯头支撑段弯管的截面畸变愈严重；在压块无润滑情况下，弯管的截面畸变和壁厚减薄量都小，并且在同等弯曲条件下，1Cr18Ni9Ti弯管的截面畸变小于LF2M弯管。

Before ovulation, the oviducal wall is the thickest, the simple tubular glands in lamina propria are filled with the jelly substance. After ovalation, the oviducal wall is the thinnest, the cells of the tubular glands becomes smaller. During ovulation, the lamina propria is thicker. Before ovulation and after ovalation, the change of serosa is not distinct.

产卵前，输卵管管壁最厚，固有层中的单管状腺充满胶质；产卵后输卵管管壁变薄，固有层腺体细胞缩小，粘膜层在产卵时比产卵前明显增厚；产卵前和产卵后浆膜层无明显变化，产卵时厚度明显变薄。

The study reveals that the secondary xylem of 6 mangrove species of Sonneratia possesses the following characteristics:the diameter of vessel is small,the distribution frequency of vessel is high,the reperforating rate is high,the wall of vessel is thick,the wall of fibre is relatively thick and the wood parenchyma is short or sparse,whish is suitable with the environment.

应用光镜及扫描电镜对生长在热带、亚热带海岸潮间带的 6种海桑属红树植物的次生木质部进行了解剖学研究表明：海桑属 6种红树植物的次生木质部具有导管直径小，导管分布频率高，复孔率高，导管壁厚和纤维壁较厚且具次生加厚，木薄壁组织缺乏或稀少等与环境相适应的特点。

The smallest can be 0.15mm copper, iron, stainless steel and other metal parts of the bulk materials processing, and often make specifications 0.25mm ~ 15mm in diameter between the pipe wall thickness of 0.08 ~ 1.2 between the pipe wall thickness at 0.02mm Tolerance, the concentric degrees, and the appearance of bright, smooth-walled hole, tolerance control at less than 0.01mm-0.02mm.

最小可以0.15mm的铜、铁、不锈钢等金属材料零件的批量加工，常做规格直径在0.25mm~15mm之间，管壁厚0.08~1.2之间，管壁厚公差在0.02mm内，同心度好，外表光亮，内孔壁光滑，公差控制在0.01mm-0.02mm以内。

Based on the nature of Yellow River,the data of the drum thickness were figured out by this formula.

利用第三强度理论，推导出分离机转鼓壁厚计算公式，并根据黄河水的特性计算出转鼓壁厚。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。