压过

Excessive formation back pressure may be due to limited or plugged perforations; subsurface or surface chokes; undersized gas-oil separator, flowlines, tubing, or casing; or excessive back pressure on flowline, casinghead gas gathering system, or gasoil separator.

183u 译文：过高的地层回压也许是由于有限的或堵塞的射孔孔眼；井下或地面油嘴；尺寸不足的气液分离器，流动管线，油管或套管；流动管线，套管头气体集输管线或气，油分离器上过高的回压。

It basically operates the main point as follows: The left hand holds the ticket, the palm is downward, the thumb is pinned in the middle of the left end of the front of the bank note, the forefinger and middle finger are on the back of the bank note, pinch the bank note together with thumb; Left hand the third finger naturally curly, pinch, get up bank note little finger stretch to bank note front push down bank note below the Left deviation; The middle finger of left hand is exerted oneself slightly, the bank note of tight card together with the third finger, little finger; The left hand forefinger is stretched, the thumb is moved upwards, pin the side of the bank note, keep the bank note into the tile shape; Left hand wipe from tabletop bank note, bank note turn, thumb strength wiped from tabletop to borrow prop up bank note covering of a fan and oblique to oneself of WeiKai Cheng; Three fingers of right hand dip in water, rotate and move the lower right corner of the bank note downwards sharp with the thumb, the forefinger cooperates with the thumb to rotate and move on the back of the bank note; Play in one's arms, count while ordering with right hand the third finger bank note got up to rotate; Pay attention to the posture at the some paper money, the health is straight and upright, the eyes It must keep eyeball and bank note from,put dual tactics elbow at tabletop.

其基本操作要领如下：左手持票，手心向下，拇指按住钞票正面的左端中央，食指和中指在钞票背面，与拇指一起捏住钞票；左手无名指自然卷曲，捏起钞票后小拇指伸向钞票正面压住钞票左下方；左手中指稍用力，与无名指、小拇指一起紧卡钞票；左手食指伸直，拇指向上移动，按住钞票的侧面，将钞票压成瓦形；左手将钞票从桌面上擦过，钞票翻转，拇指借从桌面上擦过的力量将钞票撑成微开的扇面并斜对自己面前；右手三个指头沾水，用拇指尖向下捻动钞票右下角，食指在钞票背面配合拇指捻动；用右手无名指将捻起的钞票往怀里弹，边点边记数；点钞时注意姿式，身体挺直，眼睛和钞票保持一定距离，两手肘部放在桌面上。

In the course of the calendering, pressure bearing steel strip temperature is too high, the local Polish film flacherie it appropriate to reduce the pressure of the pressure and temperature light; or possibly finish and calendering technology conditions do not match the business card printing and membership card making products for layer on the surface cools, the same as the above band of light, laymch avulsing is poor technical condition so that it matches on, reducing the calender speed, to improve the optical layer on the light that is between the avulsing: same as above.

温度偏高，使制卡和会员卡制作品在压光过程中脱水过多，含水量降低，因而纸张纤维变脆，应降低压光的工作温度，并采取有效措施，保持制卡和会员卡制作品中—定的含水量；压光中压力过大，使制卡和会员卡制作品的延伸性和可塑性降低，韧性变性，可减少压光中的压力；若因为上光油的后加工适性不良，则应重新选择加工适性较好的上光油；后加工工艺条件选样不合适，可调整后加工工艺条件，使其与制卡和会员卡制作品压光后的适性相匹配。

Furthermore system also designed overvoltage protection, over-current protection, undervoltage protection lost pressure.

此外系统还设计了过压保护，过流保护，失压欠压保护。

Adjusting the packing 1 Pump packing (1) continue to hand tighten the squeeze cap nut;(2) after opening the pump, adjust the gland nut, this time to allow a little more leakage;(3) slowly tighten the squeeze cap nut, gradually reduce the leak until the leak to an acceptable level;(4) If the disclosure of a sudden stop, should be back to tighten the gland nut, packing re-adjustment in order to prevent overheating;(5) adjust the leakage rate can reach a steady state.

泵用盘根（1）继续用手拧紧压盖螺母；（2）开泵后，调整压盖螺母，此时截止阀允许有稍多的泄漏；（3）缓慢地拧紧压盖螺母，逐渐减少泄漏，直到泄漏达到可接受的程度；（4）如果泄露突然停止，应回拧压盖螺母，重新调节以防止盘根过热；（5）调节泄漏率达到一个稳定状态即可。

For most existing domestic vibratory compactors, only two amplitudes can be selected in operation. Under this condition, problems such as inadequate compaction, over compaction or crushed aggregate are unavoidable on compacting pavements and the operation efficiency is low.

目前国内大多数液压振动压路机在选择振幅时，只能在两个挡之间选择，这样压实的路面难免会有诸如压实不足、过压或压碎骨料等问题，且作业效率低。

Note that to prevent the Whiteboard paper pad too high, or the closing largening pressure, superficial gilding, pressure shall not be published on the site of the concaveconvex by stamping, pressure concavo-convex, makes it possible for non-blocking, pressure at the site of concavo-convex also burn effect anodized, on the picture the appearance and quality.

需要注意的是要防止把白板纸垫得过高，或者是合压加大压力，而使表面不须烫金、压凹凸的部位高出烫金、压凹凸的部位，使得非烫金、压凹凸的部位也被烫上电化铝，影响画面的美观和质量。

The new style battery charge control system with high efficiency designed in this paper has all kinds of protection measures completely, such as over- current protection, low-voltage and over-voltage protection, over-temperature protection and so on.

本文设计的这套高效光伏充电控制系统具有各种完善的保护措施，诸如过流保护、蓄电池欠压、过压保护及过热保护等。

It is also a key component that the management of accumulator in P-V system. The plan of the management of accumulator is enacted in the paper, which joints the charge and discharge characteristic of the accumulator together with P-V system's uniqueness, it takes the measures of low-voltage protection、over-voltage protection and the temperature compensation at the point of over-voltage protection.

光伏系统中对蓄电池的管理也是一个关键部分，本文结合蓄电池的充、放电特性以及光伏系统的独特性，制定了蓄电池的管理方案，采取了欠压保护、过压保护以及过压保护点的温度补偿。

An improvement on the die casting technology of aluminium hub includes drilling hole at the position of die, where the function of die is not affected, for preventing gas from coming into molten aluminium, mounting safety valve to the exhaust opening of die casting case for keeping proper pressure to save electricity and shorten die casting time, and increasing the water-flowing area of cooling disk or ring for higher cooling effect.

一在不影响模具本身功能部位钻孔增加排气通道，解决了压铸过程中产生的气体进入铝水问题。可使铝轮减少气孔。在压铸机箱体排气口部位，安装安全阀，能使压铸机箱体内保持适当的压力，工作时少进气、少排气，起到节电不堵浇口，缩短压铸时间，提高产量。冷却盘、冷却环改进后，增加了过水面积，提高了冷却效果。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。