压缩的

As one of the common facilities in manufacturing enterprises, air compressors are widely used due to their capacity of producing compressed air. However , an authoritative survey shows that air compressor system consumes about 86%of the total energy cost within five years compared with purchase price that only accounts for 8% of total cost. This high volume of energy consummation invisibly increases enterprises' operational cost. However ,within the 90% of the cost for energy, main tenance and repair , 50% can be saved.

压缩机作为制造厂最常用的设备之一，其所产生的廉价适用的压缩空气能源备受许多企业家青睐，据权威机构调查，空气压缩系统在五年的总成本中，运转能源消耗费用占约86％，压缩系统初期购置费用仅占总成本的约8％，其高额的运转能源费用无形中增加了企业运营成本；然而人们却不知道这里占近90％的能源及保养修理费用却是有50％以上是可能不必支付的。

The coexistence curves and light scattering data for a critical solution of benzonitrile + octane have been reported. The critical exponents relating to the difference in the density variables between two coexisting phasesβ, the osmotic compressibilityγ, and the correlation length v have been deduced and the values were consistent with the 3D-Ising value in the range close to the critical point. The experimental results of the coexistence curves have also been analyzed to examine the Wegner correction terms and the behavior of the diameter of the coexistence curves.

用折射率法和不同角度的光散射法测量了苯甲腈+正辛烷二元体系在临界温度附近的液-液共存曲线和一相区不同温度下的渗透压缩系数及关联长度，得到与共存曲线相关的临界指数β，与渗透压缩系数相关的的临界指数γ和与关联长度相关的的临界指数γ，发现在近临界点体系符合3D-Ising模型，讨论了共存曲线直径和Wagner校正项。

For the Riemann boundary value problems for the first order elliptic systems , we translates them to equivalent singular integral equations and proves the existence of the solution to the discussed problems under some assumptions by means of generalized analytic function theory , singular integral equation theory , contract principle or generaliezed contract principle ; For the Riemann-Hilbert boundary value problems for the first order elliptic systems , we proves the problems solvable under some assumptions by means of generalized analytic function theory , Cauchy integral formula , function theoretic approaches and fixed point theorem ; the boundary element method for the Riemann-Hilbert boundary value problems for the generalized analytic function , we obtains the boundary integral equations by means of the generalized Cauchy integral formula of the generalized analytic function , introducing Cauchy principal value integration , dispersing the boundary of the area , and we obtains the solution to the problems using the boundary conditions .

对于一阶椭圆型方程组的Riemann边值问题，是通过把它们转化为与原问题等价的奇异积分方程，利用广义解析函数理论、奇异积分方程理论、压缩原理或广义压缩原理，证明在某些假设条件下所讨论问题的解的存在性；对于一阶椭圆型方程组的Riemann-Hilbert边值问题，利用广义解析函数理论、Cauchy积分公式、函数论方法和不动点原理，证明在某些假设条件下所讨论问题的可解性；广义解析函数的Riemann-Hilbert边值问题的边界元方法是利用广义解析函数的广义Cauchy积分公式，引入Cauchy主值积分，通过对区域边界的离散化，得到边界积分方程，再利用边界条件得到问题的解。

Then it proves a necessary and sufficient condition for anamalgamation of two 3-manifolds with toms boundary with no new incompressible surfaces.Lastly, with the help of the condition and the theorem about the classification of allautomorphisms of a torus, it is proveed that there exists infinitely many 3-manifolds each ofwhich contains no incompressible surfaces besides a torus.

最后，文章给出了以环面作为边界的两个3维流形在作融合积时不产生新的不可压缩曲面的一个充分必要条件，并将这个结果与关于环面到自身的自同胚类的分类的结果相结合，证明了本文的一个核心结论，即存在无穷多个互不同胚的3维流形满足除了一个环面以外不含有其他的不可压缩曲面。

The results show that the flow stress decreases with increasing deforming temperature and increases with increasing strain rate. The flow stress of the alloy during hot compression deformation can be described by constitutive equation in hyperbolic sine function with a hot deformation activation energy of 196.27 kJ/mol. Partial recystallization takes place in the alloys deformed at a high temperature or at a low strain rate, and large number of dislocations and subgrains are observed in the alloy. The elongated grains observed in the samples coarsen with increasing temperature and decreasing strain rate. Correspondingly, the subgrain size increases and the dislocation density decreases. The main soften mechanism of the alloy transforms from dynamic recovery to dynamic recrystallization.

结果表明：Al-Cu-Mg-Ag耐热铝合金在热压缩变形中的流变应力随着温度的升高而减小，随着应变速率的增大而增大；该合金的热压缩变形流变应力行为可用双曲正弦形式的本构方程来描述，其变形激活能为196.27kJ/mol；在变形温度较高或应变速率较低的合金中发生部分再结晶，并且在合金组织中存在大量的位错和亚晶；随着温度的升高和应变速率的降低，合金中拉长的晶粒发生粗化，亚晶尺寸增大，位错密度减小，合金的主要软化机制逐步由动态回复转变为动态再结晶。

This thesis contributes to geometry compression in the following aspects: Proposes a method of progressive spherical mesh parameterization based on local parameterization by directly projecting the deleted vertices to its neighborhood. Based on spherical mesh paramterization, an adaptive subdivision remeshing method by progressivly redistributing of sampling points is proposed, by this means, the main geometry information of the original mesh can be captured with only a small amount of samples, it can also be used in mesh simplification. By regarding attributes binded on mesh vertices as geometry signals and transferring them onto a uint sphere by means of spherical mesh parameterization, meshes with different attributes are compressed with spherical wavelet successfully with high compression rate. As a kind of lossy geometry compression technique, two mesh simplification algorthimes are also presented in this thesis.

归纳起来，本文的主要贡献有：提出了以直接投影局部参数化方法为基础的网格累进球面参数化方法；在网格球面参数化方法的基础之上，提出了一种基于累进优化布点方案的网格细分采样方法，该方法可以用很少的采样点就可以捕获到网格的主要特征，因此我们也将其用于后面的网格简化工作当中；通过将网格顶点上定义的各种属性看成几何信号，并以网格球面参数化为手段将几何信号迁移到单位球面上，从而成功地实现了用球面小波对各种几何信号的压缩；作为一种有损压缩方法，本文还提出了基于统一距离的网格简化算法和基于重采样的网格简化算法。

Then the finite element software ANSYS is used to simulate the orthotropic flattened Brazilian disc specimen subjected to diametrical compression, the accuracy of the approximate formula of compression displacement is checked. The formula is further modified with a semi-empirical and semi-analytical approach, and it is shown to have better accuracy than the original formula covering the whole range of orthotropic anisotropic index of rock, the error is less than 6%.

用有限元分析软件ANSYS模拟正交异性岩石的巴西圆盘试样的对径压缩实验；利用有限元分析结果对正交异性平台位移压缩公式进行精度检验，并用半经验半解析的方法，对该公式进行局部的修改，修改后的公式在岩石材料的正交异性指数的整个范围的总体评价上，误差小于6%，具有更好的计算精度。

The main objective of this project is to research and develop a novel and high efficient video codec framework based on wavelet techniques, especially to address the heterogeneousness of video networks, the fluctuation of transmission bandwidth and the diversity of video-stream receivers. The system will have some basic characteristics of the next video coding standard, such as high compression efficiency, high scalability and high error resiliency. This project will provide a software prototype of wavelet video codec with full scalability, construct a verification platform for wavelet video on demand service, and furthermore, design some VLSI IP cores of the key module in the codec system

本项目研究的主要目的就是着眼于下一代视频编解码标准的基本特征（高效压缩，高可伸缩，高容错），以小波技术为核心构建新型高效的视频编解码系统；特别针对当前视频传输网络的异构性，网络带宽的波动性以及用户视频接收终端的多样性，实现一个码流高度可伸缩同时兼顾压缩效率的小波视频编解码软件原型，并且构建基于异构IP网络的小波视频服务的技术验证平台；进一步还将基于VLSI技术，对小波视频编解码系统的关键模块进行IP核设计

For the compressible materials, in order to satisfy the higher-order compatibility equation of the rate of deformation in the centered fan sector, which is a quite difficult problem unresolved in the previous studies, a particular term must be added to the expansions of the stress components in the regular logarithmic power series adopted by many researchers before. A higher-order near tip field with tangential velocity jump ahead of the crack tip is derived first, of which the dominant terms are the solution widely accepted.

对可压缩材料，本文首先采用非规则的对数幂级数渐近展开方法，克服了过去研究中存在的中心扇形区变形率协调方程的高次渐近式不能被满足的困难，并得到了一个切向速度在裂尖前方存在间断的高阶渐近解，该解的主项就是目前被广泛接受的关于可压缩材料的尖端场解。

Conventional video compression algorithms have higher compressibility, but the output code stream still needs recoding. A selfadapting arithmetic encoder was required in practical application to produce a final code stream, which can eliminate redundancy in binary code stream to obtain higher encode efficiency. QM arithmetic encoder is a high efficiency encoder designed for the simplicity and speed.

传统的图像压缩算法有较高的压缩码率，但生成的码流仍需要再次编码，实际使用中需要通过一个自适应的算术编码器才能生成最终的码流，以消除二进制码流中的冗余，得到更高的编码效率。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。