压点

Bending fatigue test of small-specimen and ISO rolling test of full size of bamboo wood composite container floorings and apitong plywood floorings are carried through respectively, the test results show the fatigue-resistant properties of bamboo wood composite container floorings are better than those of apitong plywood floorings.

进行了竹木复合集装箱底板和阿必东胶合板底板的小试件的三点弯曲疲劳试验以及装箱后底板ISO小车滚压疲劳试验，结果显示出，竹木复合集装箱底板的抗疲劳性能更佳。

Test the properties of bamboo wood composite container floorings and apitong plywood floorings by ISO1496, square block test and bending test of small species respectively, and analyze the relativities among the three test methods. Test and analysis results demonstrate the deformation of container floorings during ISO1496 test take relative with MOE and MOR of the floorings, moreover take significant relativity with limit proportion strength of floorings.

采用ISO标准检测程序、模拟装箱试验的压块试验、小试件的三点弯曲试验等三种方法分别检测了竹木复合集装箱底板和阿必东胶合板底板的性能，分析了三种方法之间的相关性，认为集装箱底板的装箱试验结果除了与底板的静曲强度和弹性模量有关以外，还与底板的比例极限强度密切相关。

Seeds arillate, compressed, testa pitted; endosperm oily, abundant; embryo straight; cotyledons elliptic or oblong-elliptic; germination epigeal.

种子具假种皮，压扁，具洼点；胚乳油性，丰富；胚直立；子叶椭圆形或长圆状椭圆形；发芽时子叶出土。

The hydraulic in this design is a general beam-column type one, which is made up by the mainframe, electrical system and hydraulic system. It can be operated by autoloading fashion, manual fashion or spot moving fashion, to achieve the following process: sliding down rapid; sliding down slowly; adding pressure; keeping pressure; removing pressure; the low hydraulic tank work out; the low hydraulic tank untreading.

本设计中的液压机属于梁柱式一般用途液压机，主要由主机、电气系统和液压系统等三部分组成，采用半自动、手动和点动三种操作方式，能实现以下几个工作过程：滑块快速下行；滑块慢速工进；加压成型；保压延时；卸压回程；顶出缸顶出；顶出缸退回。

Regarding the thermobaric explosive further tests, the research showed that the compressive stress was 6.699MPa; The tensile stress was 0.716MPa; Heat sensitivity was 288℃(5s); The anti-overload capacity may withstand 1.0×104g launch overloads and smaller than 2×105g the impact deceleration overload; first decomposition temperature was 251.9 ℃, highest exothermic peak temperature was 286.9 ℃; In the compatibility, except the ceresin and Oxidant, the ceresin and the F rubber, the ceresin and Al compatible rank could reach to second level of compatibility, the others could reach to the first level of compatibility.

对此粘结-钝感体系包覆的温压炸药样品进一步测试研究显示：抗压强度为6.699MPa；抗拉强度为0.716 MPa；热感度为288℃（5s爆发点）；抗过载能力为可承受1.0×104g的发射过载和小于2×105g的撞击减速过载；安定性为分解温度251.9℃，最高放热峰温度286.9℃；内相容性为除蜡类钝感剂+氧化剂，蜡类钝感剂+F橡胶，蜡类钝感剂+Al相容性等级为2级相容性较好外，其他组分间相容性均为1级，相容性很好。

The types of failure in diamond thin films materials and the relationship between the failure and the applied stress have been investigated by means of soft impressor technique .

本文利用软压头技术，探讨了金刚石薄膜材料在点接触加载条件下的破坏形式以及外加应力与薄膜破坏之间的关系。

The angle might impact material feeding, and hydraulic cylinder was too big, so the structure was incompactly. Against those shortcomings, a new mechanism was designed to actualize the function. The new scheme adopted crank and rocker mechanism for lock and unlock the covering. This mechanism was powered by hydraulic cylinder. The covering would be more stable when the dead point appeared.

论文对生物质压块机盖体开合机构进行改进设计，采用液压缸驱动曲柄摇杆机构实现盖体的开启、闭合，利用机构死点提高盖体闭合时的稳定性，使盖体开合平稳，运动可靠。

Then it studied a method called intertrace sequence regulation suppressing multiple in detail, which advanced by Bruland. Through thoroughly analyzing its algorithm, researching actual processing effect, after making great improvement, this paper raised a new suppressing method called Seismic Trace Sequence Regulation.

然后详细研究了由 Bruland 等人提出的以样点空间调序方式压制多次波的方法，通过深入剖析其算法，研究实际处理效果，对原方法作了较大改进，提出了道序调整多次波压制法。

All cases were examined using FFDM(Senographe2000D,GE).Craniocaudal view and mediolateral oblique were conducted for each patient.

钼靶采用美国GE公司Senographe2000D全数字化乳腺X线摄影机进行头尾位和中侧斜位进行双乳摄影，必要时加照中侧位和局部点压放大及其他特殊体位摄影。

The decrease of the sub-pressure of kerosene when the content of noncondensable gas increase, and the

实验结果表明了不凝气体的加入使得煤油的分压降低，泡点温度

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。