压力过高

Injecting contrast medium too much or high pressure or injectingtime and again will result contrast medium into acinus, and pancreasdevelopment is discovered.

注入造影剂过多或压力过高或反复注射以致造影剂进入腺泡，出现胰腺显影，或医生技术不熟练插管不顺利等，均为ERCP后易发生AP的因素。

Tire pressure that is too high can make your ride very bumpy and out of control, as well.

轮胎压力过高，可以让你的车很颠簸，失去控制，以及。

Simulative results and analysis has shown that DFO improved on hot spot problem in CAN, can achieve the purpose of minimum global query latency and maximal transmit overload balance.

仿真结果表明：DFO算法改进了CAN中局部转发压力过高的不足，达到整体时延最低和节点压力最大平衡的目的。

Results show that the cooling capacity and the COP of the system vary with the variation of the operation conditions;system faults such as solution crystallization,overhigh working pressure, freezing of cooling water or chilled water will be caused if the variation of the operation conditions is out of range.

计算结果表明：系统的制冷量和COP随运转条件的变化而变化；运转条件的变化需要控制在一定范围内，否则将引发溶液结晶、工作压力过高、冷剂水或冷冻水结冰等系统故障。

One valve is the pressure-relief valve, which prevents pressure in the tank from rising too high.

一个是减压阀，以防止油箱中的压力过高。

The safety is guaranteed by safety valve that can decrease the pressure when it is too high.

aVF的安全是有保障的安全阀，它可以降低压力过高。

Methods 27 cases of patellofemoral pain combined with osteoarthritis of patellofemoral joint, chondromalacia of patella, malalignment of patella, sublimation of patella, or excessive lateral pressure syndrome were treated with modified tibial tubercle advancement procedure combined with removing local inflammatory synovium Results The therapeutic effect was excellent and good in 24 out of 27 cases.

分别患有髌股关节炎、髌骨力线不正、髌骨半脱有软骨软化或髌股外侧间隔压力过高综合征等的髌股间疼痛的患者27例，采用发言奶胫骨结节势高术，结合切除局部炎变的滑膜。结果 27例患者中24例疗效优良。

Single or double-acting,three position double-actingdouble direction location,auto resetetc,on which relief valva and pressurelimiting valves may be added,on each port to restrictpressure in the port and avoid the damage caused by higher impact pressure to the system..

该阀的每一工作阀片可分为三位单、双作用；三位双作用双向定位、自动复位等不同功能，可加装安全阀，并可在每一个工作油口加装过载阀，限制该油口压力及防止冲击压力过高对系统引起的损坏。

If the packing pressed tight, the wear between axle sleeve and packing will beincreased.

因为是从水泵的压水室引水，这样到达填料密封腔的轴封水的压力过高，从而造成填料处轴封水泄漏量过大。

Excessive outlet pressure on the pump diaphragm will result in increased diaphragm and bearing stress, reducing pump life and increasing service requirements.

在泵隔膜出口压力过高会导致更多的隔膜和轴承的压力，减少泵的寿命和增加的服务需求。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐