压力的

Under a lower pressure, the relationship between C/H and CO adsorption quantity was a beeline and the CO adsorption quantity increases with the of C/H ratio. The relationship between C/H and CO adsorption is a concave curve with the pressure increasing, and the higher the pressure, the higher the discrete degree.

当压力较低时，C/H与吸附量呈直线关系，随着C/H的增加而增加；随着压力的升高，C/H与煤对CO吸附量之间呈凹形曲线关系，压力越高离散度越大。

Also calculated are dynamic heat transfer characteristics in the fuel rod under different pressure and it is found that we can use the temperature raising speed at x=14.5 cm to calculate helium pressure in the fuel rod.

通过用RODTRAN程序计算各种不同压力情况下的燃料棒动态传热特性，发现利用x=14.5cm处的包壳表面升温速率可以推算燃料棒内的氦气压力，氦气压力的测量精度可小于5％，也就是说可以区分1.9MPa和2.0MPa的压力差别，此时的最大温差可达0.5℃，同时也发现压紧弹簧段的温度响应比铀芯块段要快。

On the base of the hydraulic impulse testing machine model, calculate the pipeline system and other hydraulic accessories' influence on the impulse press.

首先对液压脉冲试验台的压力冲击—水锤进行探讨，了解管道系统压力冲击过程中瞬态流量和压力的变化规律。

There's mental stress from trying to accomplish a goal, emotional stress from interacting with fellow workers, and physical stress resulting from overexertion.

有心理压力，从试图完成一个目标，情感压力的相互作用与同事，和身体的压力造成过劳。

A few years back, many stress experts attributed all the talk about overstress in the workplace to people just being more aware of their stress.

几年前，许多压力专家将人们经常谈及的在工作场所压力过重归因于人们对待压力的过于敏感。

Hydraulic structure can be often damaged by ice cover and ice pressure at cold areas,and slop protection construction is easier to be damaged by ice.

在寒冷地区，水工建筑物经常会受到冰盖层冰压力的侵害和威胁，而护坡工程往往首当其冲，由于在设计时对冰压力估计不足，致使某些护坡遭受冰压力的作用而损坏。

After an analysis of the mechanisms of the effects of pressures on OMM, it is denoted that when the increase of ＂pressure＂ on the samples is the increase of effective stress, the stress acts directly on solid OM and the maturating rate will be accelerated.

综合分析结果表明，当压力的增加表现为沉积有机质受到的有效应力增加时可以促进有机质生烃；当压力的增加表现为孔隙流体压力增加时，有机质生烃过程将受到抑制；另外，这两种情况都可能使干酪根的镜质组反射率降低，易使人得出压力增加抑制有机质演化的结论。

Effects of pressure on these two absorption bands are quite different and the emission intensity may change with pressure in a different way for excitation at different band.

在压力作用下，这两个吸收带表现出不同的压力效应，并且在不同的压力下分别激发这两个吸收带时，所得到的荧光发射效率随压力的变化趋势表现出明显的不同。

The idea that the casing shoe resistance and the crushing strength of the LCM must be considered when design the density of the drilling fluids is presented. It holds that the surface pressure should be junior to the crushing strength of LCM, in order to prevent the formed bridge plug from crushing.

提出设计井内堵漏钻井液密度时，必须同时考虑套鞋处破漏压力和桥接材料的抗压强度对井内压力的限制；认为提高压力敏感性裂缝地层承压能力的堵漏作业时，井口压力应不超过桥接材料的抗压强度，以保证裂缝内已形成的堵塞隔墙不被破坏。

The conductive pole only acts for contact and conducting during welding, the pressure pole in its center forces pressure under action of compression spring, and the pressure pole is characterized by high fusing point and mechanical intensity because of the tungsten alloy material, and the life length of contact finger is prolonged.

在焊接作业时，导电杆仅起到接触导电作用，而其中心的压力杆在压簧的作用下起到施加压力的作用，由于压力杆采用钨合金材料，具有高熔点、高机械强度的特点，不会变形，导电杆压力小不易变形，从而延长了整个触头的使用寿命，并且焊点整齐美观。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。