压力的

Main research contents as follows:(1) The four destruction models and respective stability analysis methods are discribed in this paper, whose working mechnism and calculating methods are given. In addition, some defects of every method are also discussed ;(2) On the basis of traditional active soil pressure method and expirical siol pressure method , the calculating model of the laternal earth pressure which is a tetragon with the largest value in the center side is addressed.

主要工作如下：(1)本文给出了复合土钉墙的稳定性分析方法，该方法介绍了复合土钉墙的四种破坏类型，分析了每种破坏类型的受力机理，并给出了相应的计算方法和计算方法中的一些不足；(2)在传统的主动土压力和经验土压力的基础上，建立了土钉墙中间大、上下小的四边形状分布的侧向土压力的计算模式。

In addition, some defects of every method are also discussed ;(2) On the basis of traditional active soil pressure method and expirical siol pressure method , the calculating model of the laternal earth pressure which is a tetragon with the largest value in the center side is addressed.

主要工作如下：（1）本文给出了复合土钉墙的稳定性分析方法，该方法介绍了复合土钉墙的四种破坏类型，分析了每种破坏类型的受力机理，并给出了相应的计算方法和计算方法中的一些不足；（2）在传统的主动土压力和经验土压力的基础上，建立了土钉墙中间大、上下小的四边形状分布的侧向土压力的计算模式。

Flexo business card printing and membership card making pressure adjustments is the crucial step of product quality, direct impact prints fine is good or bad, as printed on the roll and the spacing between the embossing roll is the same, you can choose to use 2.08mm (1.7 printing plate + 0.38 doubleside Strip) standard thickness of Feller gauge, so that both ends of the respective Feller gauge the same pulling resistance, at which point the amount of space is business card printing and membership card to make the best pressure value (but in actual production, you need to fine-tune your carefully at the operative level, it is necessary to the practical experience of technical personnel to obtain the best pressure value).

柔性版制卡和会员卡制作压力的调节，是产品质量的关键步骤，直接影响印品的精美好坏，印版辊与压印辊之间的间距是一样的，可选用2.08mm(1.7印版+0.38双面胶带)厚度的标准塞尺，使两端各自的塞尺拉动阻力相同，此时的间距就是制卡和会员卡制作最理想的压力值(但是在实际生产中，需要操作人员的仔细微调，那就需要技术人员的实际经验来获得最佳的压力值)。

In another cadaveric study, Adams and Hutton58found that the lumbar facet joints resist approximately16% of the intervertebral compressive force when standing erect versus near 0% when sitting, which helps explain the high intra discal pressures during unsupported sitting.59 Finally, after conducting in vitro experiments measuring induced loads on cadaveric lumbar facets, Lorenz et al.60 concluded that with increasing compressive loads, the absolute facet loads increases only slightly, so that the proportion of the axial burden borne by the l-z joints actually decreases with increasing stress.

另一项尸体标本的研究中，Adam和Hutton发现，当直立站立时，小关节承担了逐渐压力的近16%，而坐位时进0%，这解释了为什么在无支持的坐位时椎间的压力非常高。最后，Lorenz在尸体标本加载负荷后测量小关节的应力后，认为增加压力负荷时，小关节间的应力仅轻微增加，因此在轴向负荷中，小关节承担的比例实际随着应力的增加而减少。

It show that interstitial fluid pressure changes its sig n twice within one arteriolar vasomotion period and it is therefor not important that interstitial fluid pressure is a little higher or lower than atmospheric p ressure; arteriolar vasomotion can periodically result in lymph formation and in terstitial total pressure plays an important role in this procedure; local regu l ation of microcirculation can meet metabolic need to some extent in the form of dynamic equilibrium.

利用解析法与有限元法相结合的&影响线算法&，求解了第一部分中建立的数学模型，分析了微循环系统动力学的若干重要问题，表明在微动脉自律运动周期内，间质流体压力将两次改变符号，因而某些理论中十分强调的间质流体压力是略高于或略低于大气压力的问题显得并不重要；微动脉自律运动能导致周期性的淋巴形成，间质总应力在这一过程中起着重要作用；微循环局部调节可以以动态平衡的方式在一定范围内满足代谢的需要。

The method of finite element discrete and optimal parameter back analysis is adopted.(3) Concentrated on the question of high external water pressure of the deep-lying tunnel, the basic theory and method calculating external water pressure are systematically studied.(4) Based on Jinping cascade 2 hydropower station, numerical simulation rain infiltration of seepage field under different drainage pattern and grouting pattern are studied, also, the high external water pressure is analyzed and studied and some seepage control measures are put forward.

2采用有限元离散—优化法进行参数的反演分析；(3)针对深埋隧洞的高外水压力问题，进一步分析和研究了衬砌水荷载及外水压力的作用机理和计算方法；(4)以锦屏二级水电站深埋长引水隧洞作为本文的主要研究对象，采用考虑降雨入渗渗流场分析的方法对排水方案和灌浆封堵方案不同情况下的渗流场的水头分布进行了数值模拟，并对其外水压力进行了分析和研究，提出了渗流控制的具体措施。

The model is solved using finite difference method. The profiles of water saturation, pore pressure and gas pressure were plotted.

采用有限差分法对所建模型进行了求解，并绘制了含水饱和度、孔隙水压力和孔隙气压力的时空分布曲线。

In order to calculate the high external water pressure, the rock seepage field and external water pressure coefficient should be treated in detail.

对于外水压力的计算方法主要有渗流场分析方法和外水压力作用系数法。

The work pressure of the nurses was closely related with the mental health. It is very important to find the way to ease the pressure and improve the ability of selfcomfort and selfdefence.

护士工作压力与护士心理健康密切相关，需寻求缓解护士工作压力的有效措施，以提高护士心理防卫能力。

The reason is used to control the hydraulic oil pressure of compressed air pressure is too low.

原因是用于控制液压油压力的压缩空气压力太低。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。