压力

Suction superheat control system consists of electronic expansion valves, pressure sensors, temperature sensors, controller, working hours, the pressure evaporator outlet pressure sensor P1, temperature sensors compressor suction superheat will be passed to controller, controller After signal processing, followed by the output commands acting on the main electronic expansion valve stepper motor to open the valve to the desired location.

吸气过热度控制系统由电子膨胀阀、压力传感器、温度传感器、控制器组成，工作时，压力传感器将蒸发器出口压力P1、温度传感器将压缩机吸气过热度传给控制器，控制器将信号处理后，随后输出指令作用于电子膨胀主阀的步进电机，将阀开到需要的位置。

Nominal pressure: Filter pipeline that may arise in accordance with the maximum pressure level to determine the pressure filters.

公称压力：按照过滤管路可能出现的最高压力确定过滤器的压力等级。

It is not only to provide the steam turbine generating units and compressor bearings, couplings, gear boxes of different growth rate of the lubricating oil pressure, and turbine governor to provide a governor oil pressure, but also to the low and high pressure cy

它不仅提供机组的汽轮机和压缩机的轴承、联轴器、齿轮增速箱不同压力的润滑油，而且向汽轮机调速器提供一定压力的调速油，还向低、高压气缸提供不同压力的密封油。

Pressure governor valve is the use of a spring-loaded power and pressure balance theory, when the spring-loaded pressure less than atmospheric pressure and the valves closed when the pressure is greater than the spring-loaded rubber tubing stretch when the bottom of compressed air diaphragm, diaphragm the effort to promote diaphragm upward and left vavle seat blow the air flow of gas, this would piston shirking role in the pressure mobile, Selection will be emissions from valve seat, air compressors made by the then air into the gas valves and exhaust emissions is through the mouth into atmospheric air compressors idling.

调压阀的原理是利用了弹簧力与压力相平衡的原理，当弹簧的压力小于气压的时候阀关闭，当压力大于弹簧的弹力时候橡胶调压膜片下方的压缩空气对膜片的用途力，推动膜片向上拱曲离开阀座而使空气流入气腔，此时卸荷活塞在气压用途下移动，将排放阀门推离阀座，于是由空气压缩机充入气腔的空气便通过排放阀和排气口排入大气空气压缩机空转。

Therefore, by comparing particle distribution of the spraying under different water pressure, and the nozzle's outlet velocity simulation get by Ansys, which is a software for mechanical simulation, a proposal of the application of 1.5mm nozzle, 8Mpa water pressure on the spot was put forward.

在比较多种光学测粒仪的基础上，选择Winner313系统测量不同孔径喷嘴在不同供水压力下喷雾雾场的粒径分布。通过分析比较喷嘴在不同压力下喷雾雾场的粒径分布和Ansys模拟得到的喷嘴内部及出水口速度场，建议现场应用1.5mm喷嘴、供水压力为8MPa进行喷雾。

The first stage reduces inlet pressure to a preset intermediate pressure, typically 350 to 500 psig.

第一级把入口的压力降到预定的中间压力，该压力典型值为350到500 psig。

In the thermocompression bonding condition data, the pressure is set to be first pressure in a first stage in a process of the thermocompression bonding operation and second pressure, which is lower than the first pressure, in a second stage that follows the first stage.

该热压接条件数据在热压接操作的一个工序内的第一阶段设定为第一压力，在其后的第二阶段设定为比上述第一压力低的第二压力。

Assessment with a pressure wire also did not add time to the procedure, which took an average of 70 minutes using conventional angiography and 71 minutes with the pressure wire, probably because of the time saved in placing an average of one fewer stent per patient.

此外，采用压力导丝进行评价并不会延长手术时间，采用传统的血管造影术平均需要70 min，而采用压力导丝也只需要71 min，这很可能是因为采用压力导丝，每例患者可平均少用1个支架，从而节省了部分时间。

Page28of74 1026 中英版 2002 a Five times the pressure corresponding to the maximum setting of a pressure-reducing valve provided as part of the assembly, but no more than five times the marked maximum supply pressure from an external source and no more than five times the pressure setting of a pressure-relief device provided as part of the assembly.

作为装配件的减压阀的最高压力的5倍，不超过外部供应源最高压力的5倍，并且也不超过作为装配件的御压阀的压力的5倍。

In order to strengthen their products' market competitive ability and improve pressure gauge's measure accuracy and working reliability, many gauge enterprise expect to analyze and study elasticity character of sensitive elastic element so that they can solve the ineffective problem in process of Type-C spring Tube inducting and measuring stress.

近年来，随着国内外市场的竞争加剧，对压力仪表的质量参数和性能指标有了更高的要求，许多仪表企业为增强其产品的市场竞争能力，提高压力仪表的测量精度及其工作的可靠性，期望运用现代设计理论和方法对敏感弹性元件的弹性特性进行分析与研究，以解决C型弹簧管在感测压力过程中的失效问题。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。