压下的

A narrow strip of wood used to fasten down the edges of the material that covers hatch es in foul weather.

压板条：一种用来固定在恶劣天气下遮盖船舱口材料边缘的窄木条。

If the unit does not respond to your fingernail , again place two separated fingers against it.

假如这个装置对指甲毫无反应，你的下一步还是用两根手指分别轻压荧幕上两点。

In this variant, as in the footbridge dilemma, you would use someone's body to stop the trolley from killing the five.

在这种情况下，是否应该把电车引向站着一个人的轨道去压死他？

With the stress of pressure and heat, excess graphitization can be introduced in the frictional face.

在压应力和热应力的作用下，摩擦表面存在额外石墨化现象。

When gear-driven, the suction chamber side gear teeth withdraw mutually place the space between teeth volume increases gradually, pressure drop, the liquid enters the space between teeth under the differential pressure function.

齿轮转动时，吸入腔侧轮齿相互脱开处的齿间容积逐渐增大，压力降低，液体在压差作用下进入齿间。

The DC power supply wire and connector wire drawn from power supply box should wiring buried wire as possible, exposed wire must be fixed by holding latch; Notch on the ground between transmitting antenna support and receiving antenna support, so that bury power supply wire and connector wire, geosyncline's surface need be covered with stainless steel bead.

从电源盒引出的直流电源线及连机线，应尽可能布暗线，明线须用卡固定；发射天线架与接收天线架之间须在地面开槽，以便埋下电源线及连机线，地槽表面需用不锈钢压条封盖。

Posteroinferior cerebellar artery traced in a crook course and usually formed three loops, which got in touch with glossopharyngeal nerve with a shallow pressed mark.

小脑后下动脉行程弯曲，通常形成3个袢，这些袢接触舌咽神经根并有浅的压痕。

An experiment of water-rock interaction in the packed bed reactor between granodiorite and pure water under the condition of stable pressure of 22 MPa and continuous current has been performed to study the formation process of the Hucun skarn copper deposit in Tongling, Anhui.

以铜陵胡村矽卡岩型铜矿为研究对象，选择与成矿关系密切的花岗闪长岩，在22 MPa恒压、不间断流动条件下，与纯水在叠层反应器中进行水-岩反应动力学实验研究。

A calculation of ideal gas under the saturated vapor pressure at different temperatures a small program.

详细说明：一种计算理想气体在不同温度下饱和蒸汽压的小程序。

Finally, the contact zone and contact stresses can be determined when a couple of contact loading and indenter's curvature are specified.

最后，利用所得直线族，在已知接触压力与压头半径的前提下确定接触区尺寸与接触应力。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。