压下的

It shows that if confined pressure σ3 and temperature T are constant, theeffect of axial stress σ1 on creep and creep rate is similar to that of clay stone.

通过对盐岩进行的不同温度和应力水平下的三轴蠕变试验表明，在围压σ3 和温度 T 不变时，轴压σ1 对蠕变和蠕变率的影响与泥岩相同。

Factors that affect two-phase flow pressure drop are discussed in details at first. Polynomial is used to fit the relation between property of differential pressure signal and LockhartMartinelli parameter X.

讨论了影响两相流压降的因素，用多项式拟合的方法研究了不同流型下差压信号方差与Lockhart—Martinelli参数X之间的函数关系。

In the existing buckling analysis of drill stem in horizontal condition,the drill stem is thought of as an even rod with equal diameter and sticked on the below wall of well on the action of deadweight,so it was simplified as simply supported beam compressed axially and supported evenly along its length by well wall.

在现有的水平状态下钻柱屈曲研究中，一般把钻柱看作均匀的等直径杆，认为钻柱在其自重的作用下，紧贴下井壁，因而通常把水平状态下的钻柱简化为在整个长度上受到井壁均匀支承的轴向受压的简支梁。

Transverse shear strain is introduced into the strain vector to take transverse shear deformation into account. To avoid shear lock,the one point Gauss integral method is used to compute the stiffness.

复合材料旋转壳体是航空、宇航和造船等常采用的结构形式之一，这类结构常常在轴压和侧压下工作，准确预测此类结构的屈曲临界载荷和破坏模式，具有重要的工程意义[1]。

Positive tensile stress on iron undersurface relaxes to the inner of iron and negative tensile stress on iron undersurface concentrates on the side of iron as the temperature declining, so cracks easily appear at the site where positive and negative tensile stress cross.

在冷却过程中，铸铁下表面的拉应力逐渐向铸铁内部释放；同时，压应力逐渐向铸铁的两侧端面集中。因此在拉应力和压应力的交界处，容易产生裂纹。

By comparing the dehydration methods of three catalytic esterification reactions and the catalysts used under negative pressure, the better method of synthesizing 2 ethylhexyl chloroacetate is using stannous oxide as catalyst under negative pressure.

通过对三种催化酯化反应的脱水方法及负压下使用不同催化剂的比较和选择，提出了以氧化亚锡为催化剂负压脱水合成氯乙酸2乙基己酯的方法。

Based on the functions from closed vessel experiments, the ballistic simulation results of maximum chamber pressure, muzzle velocity and p-t curves of a 105mm gun charged with LTSC nitroamine propellant at +50℃,+15℃ and -40℃ environmental temperature were in good agreement with experimental data.

在密闭爆发器实验的基础上，应用可视化程序对某105mm火炮采用低温感硝胺火药在+50℃、+15℃和-40℃环境温度下的最大膛压、初速以及膛压—时间曲线进行了弹道模拟，模拟与实验结果具有较好的一致性。

Based on the functions from closed vessel experiments, the ballistic simulation results of maximum chamber pressure, muzzle velocity and p-t curves of a 105mm gun charged with LTSC nitroamine propellant at +50C,+15C and -40℃ environmental temperature were in good agreement with experimental data.

在密闭爆发器实验的基础上，应用可视化程序对某105mm火炮采用低温感硝胺火药在+50℃、+15℃和-40℃环境温度下的最大膛压、初速以及膛压—时间曲线进行了弹道模拟，模拟与实验结果具有较好的一致性。

Flow simulation and performance analysis are conducted for the stage of a high energy head unshrouded centrifugal compressor with vaneless and tandem diffuser respectively using CFD software. The flow field distribution and performance comparison are offered in the two conditions.

使用 CFD 软件对某高能头半开式离心压缩机的级，在分别采用无叶扩压器和串列扩压器时进行了流动模拟和性能分析，给出了两种情况下的流场分布和性能比较。

The influences of forming parameters,such as specification of heat treatment,nominal reduction of blank radius,feed ratio and roller track,on multi-pass neck-spinning of aluminum exhausted pipe used in vehicle are researched,and sound exhausted pipe s are developed by selecting reasonable processing parameters and roller tracks.

以铝质汽车排气歧管为研究对象，探讨了热处理工艺规范、名义压下量、进给比、旋轮运动轨迹等对三维非轴对称偏心及倾斜件多道次缩径旋压成形工艺的影响，通过选择合理工艺参数及旋轮运动轨迹，研制出合格的汽车排气歧管样件。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。