压下

Then, soil structure was destroyed and formed erodible particles with size 0.154 to 0.18 mm in the soil surface. Under the impact of strong winds and vehicle wheels, soil erosion by wind and vehicle wheels in soil surface was severe, and some fine particles (≤0.063mm) disappeared gradually, so soil structure would evolve to be coarse.

在车轮的碾压作用下草原土壤表面形成易风蚀粒子（0.154~0.18 mm），受强风和车轮的携带作用后表土风蚀严重，很多细颗粒（粒径≤0.063 mm）在车轮的携带和强风的作用下会逐渐消失，土壤表面进一步向粗粒化发展。

Experiment result demonstrates that its surface isn't oxidized by contrast with the stainless steel at 1 000 ℃. Under the single pulse high voltage, the film shows feeblish discharging characteristic after the bombardment of the high energy microparticles at hundreds times. This can increase the voltage holding capability and reduce the dynamic load of pulse power.

实验证明：在高达 10 0 0℃的温度下，相比不锈钢材料，薄膜表面几乎不被氧化；在单次脉冲高压作用下和在经受数百次高能微粒子轰击后，仍呈现出弱放电特征，既提高了耐压能力，又降低了脉冲电源的动态负载

A series of P-T tests in field and model bin were carried out,through controlling initial pressure upper limit P and gastight degree,The results showed that gastightness not only relates to airtight degree,structure material and technological quality,but also relate to pressure upper limit,temperature and so on.

文章通过控制初始压力上限P和气密程度，进行了一系列P -T试验，对室内模拟仓和实仓进行测试，通过试验和对实验结果数据的处理分析，发现气密性不仅与环境密闭程度、结构材料及工艺质量有关，而且与测压上限及温度等环境条件有关；并且，在相同气密条件下，容器不同初始压力下的半衰期之间存在很好的线性相关性。

Thus, on the reservoir conditions of the seventh middle area of JiaMuHe and eighth area of XiaWuErHeZu, the qualities of blocking agent such as gelatification time, the gel strength, the salt resistance, the temperature resistance, the stability, the compressive strength, the selection of injection, the improvement ratio of water entry profile and the sweeping efficiency were evaluated.

评价了堵剂在七中区佳木河组和八区下乌尔禾组两种油藏条件下的成胶时间、成胶强度、抗盐性、抗温性、时间稳定性、耐压强度、选择注入性、吸水剖面改善率和驱油效率。

The activities in different sections of the Gaoqing fault in the Huagou gas field were analyzed using 3D seismic data. The activities of the fault segment associated with the Huagou gas field were strong during the Guantao\|Minghuazhen period, while the activities on east and west sides of the gas field were weak at that time. The Huagou gas field is well corresponding to the strong activity segment of the Gaoqing fault on the plane. The process of gas migration in the Huagou reservoir is divided into two phases:(1)After mantle\|derived magmatogenetic gas including CO2, N2, and He entered the Gaoqing fault, the gas migrated to the top of the fault by the action of buoyancy or pressure, then the gravitative differentiation occurred. For the top of the fault is closed and both sides of fault is sealed, the gas assembled to some degree in the Gaoqing fault;(2)When gas was accumulated at a large scale in the Gaoqing fault, the gas migrated towards the reservoirs along the two sides of the fault and was accumulated in sandstone.

利用三维地震资料，对济阳坳陷花沟CO2气藏区高青断裂走向上不同区段的活动性进行了分析，指出：花沟CO2气藏所对应的高青断裂区段，在馆陶组—明化镇组沉积时期活动性强，而气藏的东、西两侧，馆陶组—明化镇组沉积时期断裂基本上不活动；花沟CO2气藏与馆陶组—明化镇组沉积时期高青断裂活动性强的区段在平面上有着良好的对应关系；花沟CO2气藏的运聚过程分为2个阶段，在第1阶段，幔源岩浆成因的CO2、N2和He等气体进入高青断裂后，在浮力或压差作用下向断裂顶端运移，并发生重力分异，由于断裂顶端封闭、两侧封堵，CO2、N2和He等气体在高青断裂中实现了一定程度的聚集，而在第2阶段，当CO2、N2和He等气体在断裂中聚集到一定程度，便在压力驱动下向断裂两侧砂岩储层运移，并在其中聚集成藏。

The results show that, for the first with no headwall, when there is no crosswind, it has small front face areas, so the aerodynamic resistance is the least. Since the second and the third have headwall, the front face areas are large, so they have bigger aerodynamic resistance. Under the condition of crosswind, as the third design option has the highest side beam, the area of positive pressure at the upwind is bigger, and the area of negative pressure is smaller when the bigger eddy area appears, so the side forces become larger. The first has the least side forces; the overturning moment of the first is the least.

研究结果表明：在无横风情况下，方案一中没有端墙，迎风面积较小，受到的气动阻力最小，方案二和三中平车有端墙，迎风面积较大，受到的气动阻力也较大；有横风情况下，方案三中平车侧梁较高，车体迎风面正压区较大，而背风侧产生较大的涡流区，在此区域内压力较小，故其横向力较大，方案一中平车侧梁没有加高，受到的横向力最小；方案一中平车倾覆力矩最小，稳定性最好。

The mass extends inferiorly into the infratemporal fossa and left retropharyngeal space.

肿块向下扩展到颞下窝和左侧咽后间隙，左侧颞前叶受压，病变无明显水肿。

It exhibited a well-situated property at morphotropic phase boundary when Zr content is 0.52 and PbO·WO_3 content is 0.5mol%.

研究发现：PbO·WO_3最佳掺杂量为0.5%， Zr含量为52%时材料处于准同型相界内；Pb_(1.05)Zr_(0.52Ti_(0.48)O_3- 0.5mol%(5PbO·WO_3)压电陶瓷在1100℃保温时间为2小时条件下烧结而成，在120℃硅油中，2500V/mm场强下持续极化30分钟，样品达最佳性能。

The results show that increasing the ball numbers and mandrel extension length may reduce the ovalization, but leads to more remarkable wall thinning; the ovalization becomes more severe with the larger bending angle; the smaller the relative bending radius, the larger the ovalization is; the ovalization and wall thinning degrees are both smaller in the case of pressure die with dry lubricant; and under the same bending condition, the ovalization of LF2M tube is larger than the one of 1Cr18Ni9Ti tube.

结果表明，增加芯头个数与芯棒伸长量都能减小弯管的截面畸变，但两者都导致弯管壁厚减薄量增大；随着弯曲角度的增加，截面畸变越严重，相对弯曲半径越小，无芯棒与芯头支撑段弯管的截面畸变愈严重；在压块无润滑情况下，弯管的截面畸变和壁厚减薄量都小，并且在同等弯曲条件下，1Cr18Ni9Ti弯管的截面畸变小于LF2M弯管。

The criterion is similar to hyperbolic strength criterion including uniaxial compression strength and uniaxial tensile strength, which is an extended form of Griffith-Murrell criterion essentially under the condition of polyaxial stress when hydrostatic pressure is lower, and it represents the first failure type. However, the criterion is similar to generalized Mises criterion when hydrostatic pressure is higher, and it represents the second failure type. The transition part between the two criteria represents the third failure type when hydrostatic pressure is high.

该准则包含单轴抗压和抗拉强度，在静水压力较低时，实质上它是Griffith-Murrell准则在多轴应力状态下的一种扩展形式，反映脆性岩石破坏类型1；在很高静水压力下该准则可转化为广义Mises准则，反映脆性岩石破坏类型2；而当静水压力较高时，该准则处于上述两种准则的过渡阶段，反映脆性岩石破坏类型3。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。