卡环

Objective The effect of clasp on the health of abutment teeth.

目的初步探讨可摘局部义齿卡环对基牙健康的影响。

Army Regulation 600-40, paragraph 48, September 27, 1921, specified that the Citation Star would be worn above the clasp, on the ribbon of the service medal for the campaign for service in which the citations were given.

军规600-40，第48段，1921年9月27日，并规定，将引星戴卡环以上就为服务，其中引用的特定广告服务奖章剪彩。

44 SEEGER CIRCLIP RING SPAR

弹簧托架卡环 2 Nos。

Descriptive Geometry Methods for Determining the Track of Wire Incision to Embed Cut of Ring.

确定卡环嵌入式接口线切割轨迹的画法几何方法研究。

Factory main production: ring, wave washer, saddle-type flexible gasket, C-type snap ring, dish washer, single-ear binaural, round nut with washer stop, both within and outside the teeth, the bearings folder, plum gaskets, flexible cylindrical pin , card ring, DIN standard ring and all kinds of custom pieces of red stretch.

本厂主产：挡圈、波型垫圈、鞍型弹性垫圈、C型卡环、碟形垫圈、单耳双耳、圆螺母用止动垫圈、内外齿、轴承夹、梅花垫圈、弹性圆柱销、卡圈、DIN标准挡圈及各类冲拉伸件定制。

ABSTRACT: Objective To investigate the elastic limit and relevant enclasp force of the nonprecious metal wrought wire clasp.

文章正文-摘；-：目的研究非贵金属锻丝卡环的弹性极限及其相应卡抱力。

Results The elastic limit of the nonprecious metal wrought wire clasp made from 0.8, 0.9 and 1.0 mm diameter were 0.639, 0.608 and 0.482 mm, respectively, the relevant enclasp force were

结果 直径为0.8，0.9和1.0 mm的锻丝卡环弹性极限分别是0.639，0.608和0.482 mm，其相应卡抱力是0.167，0.196和

Results The elastic limit of the non-precious metal wrought wire clasp made from 0.8,0.9 and 1.0 mm diameter were 0.639,0.608 and 0.482 mm,respectively,the relevant enclasp force were 0.167,0.196,(0.335) N.

结果直径为0.8，0.9和1.0 mm的锻丝卡环弹性极限分别是0.639，0.608和0.482 mm，其相应卡抱力是0.167，0.196和0.335 N。

The analogous electric signal was converted to digital signal by digital converter and stored in a computer. The elastic limit and the relevant enclasp force were analyzed using a relative software.

应用万能材料试验机测试采集试件加载变形及其卸载回复全过程的电信号，通过A/D转换器将电信号转换成数字信号并贮存于计算机中；应用基于MATLAB平台开发的计算机绘图软件处理分析、计算锻丝卡环弹性极限及其相应卡抱力。

The process of clasp samples deflected by loading and returned by unloading was tested and electric signals were collected by an omnipotent material machine. The analogous electric signal was converted to digital signal by digital converter and stored in a computer. The elastic limit and the relevant enclasp force were analyzed using a relative software.

应用万能材料试验机测试采集试件加载变形及其卸载回复全过程的电信号，通过A/D转换器将电信号转换成数字信号并贮存于计算机中；应用基于MATLAB平台开发的计算机绘图软件处理分析、计算锻丝卡环弹性极限及其相应卡抱力。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。