单相

Samples of the equilibrium solid phase in Rb_2SO_4-PEG4000-H_2O system at 25 ℃ analyzed by TGA showed that they consisted of anhydrous salt. Six zones were observed in the complete phase diagram. They are L, L+L, L+S, 2L+S and L+2S, respectively. The binodal curves were given using a four-parameter equation y = a + bx~(0.5)+cx+dx~2. The tie lines were correlated by the Othmer-Tobias and Bancroft equations.

同时我们用热重分析仪对Rb_2SO_4—PEG 4000—H_2O三元体系在25℃时的平衡固相进行分析，发现在实验研究的温度范围内，体系的平衡固相均为无水盐，且在体系的完整相图中，观察到六个相区，分别为L，L+L，L+S，2L+S和L+2S相区，即非饱和的单液相区，非饱和的双液相区，饱和的单液相区，饱和的双液相区和两种固相(Rb_2SO_4，PEG 4000)存在的饱和单液相区。

Then detailedly introduces the principle of pole-changing modulating speed and design feature in times pole proportion and non times pole proportion in the Mixed pole-changing simplex winding multispeed asynchronous motor , carry on discuss to the main parts of electrical machinery electromagnetism computation; by using VISUAL BASIC under WINDOWS platform for computer-aided design method for the mixed pole-changing simplex winding multispeed asynchronous machine, carries on profound analysis for the computer-aided design in the following aspect such as rotor and setting flush piece size, groove shape size, the rotor and setting winding connection, and start performance.

本文在介绍了单绕组多速电动机的概况，阐述了目前多速电机的发展现状与前景；利用槽号相位图以及混相原理对变极绕组进行了研究，确定了绕组的混相方案；并详细地介绍了混相变极单绕组多速电机在倍极比与非倍极比时的变极调速原理以及设计特点；对电机电磁计算的主要几个部分进行了讨论；介绍了使用WINDOWS平台下的VISUAL BASIC对混相变极单绕组多速异步电机的计算机辅助设计方法，对混相变极单绕组多速异步电机的定转子冲片尺寸、槽形尺寸、定转子绕组接法、定转子相带、起动性能的几个方面的计算机辅助计算进行了深刻分析；最后，对混相变极单绕组多速异步电机的样机检测试验结果进行了分析。

Single phaseTiO3 powder is synthesized by self-combustion method at low temperature. The solution pH scope in self-combustion reaction is investigated and determined.

用自燃烧法低温合成了单相TiO3陶瓷粉末，研究和确定了自燃烧反应的pH值条件，分析了自燃烧反应历程。

And then the output voltage harmonic for the single-phase three-level SPWM inverter under the half triangular and half saw-tooth carrier wave is studied. It also discusses how to select the carrier ratio N and the effects to the output wave by modulation ratio M.

着重对载波为半波、三角波、半波、锯齿波的单相三阶 SPWM逆变器的输出电压的谐波处理、载波比N的数值选择、调制比M对输出波形的影响等进行了研究。

The control signals of the PWM rectifier are obtained by comparing the current of AC side with triangular wave (or saw-tooth wave) directly, which can implement the steadiness of the voltage of DC side and unit capacity factor of the system. At the same time, harmonic component of the system is abstracted through Instant Reactive Power Method, which can be smoothed by Integrated Learning Boost Converter Control.

本文采用重复学习Boost变换技术，利用滑模变结构控制技术对单相PWM整流器恒频Boost变换进行了分析，提出将交流侧电流直接与三角波相比较得到开关控制信号的方法，实现直流电压恒定不变及系统单位功率因数；同时，利用瞬时无功功率法分析系统谐波，并在谐波域内使用重复学习的控制方法，结合Boost变换技术，有效滤除系统谐波有功电流。

With the help of system mathematical model, the contradiction between increasing dynamic response of converter and decreasing the ripple of output voltage is elaborated based on the analyses of mechanism of the converter's dynamic regulation problem.

因此，借鉴交流电机理论中的空间坐标系概念，建立了该变换器的开关函数，提出了系统的数学模型，解决了用单相等效电路法分析三相PFC电路存在的问题。

The method of intelligent control based on neural network is applied in electrode current of arc furnace.The electrode current is analyzed and simulated by the BP and RBF models of neral network.

讨论了基于神经网络对电弧炉电极进行智能控制的方法，运用神经网络的BP、RBF以及双隐层BP模型，分别对电弧炉电极的单相电流及三相电流进行了分析和仿真。

First, the principle and the topologies of sin...

首先，针对单相DC/AC变换器，分析了它们的主电路拓扑结构、工作原理以及脉宽调制方式。

Two 300 hp waterwheels drove a single-phase generator, and with a capacity of 720 kw, the power was transmitted at 4000 volts to Portland.

二台300马力的水轮机驱动一台容量为720kW的单相发电机，电力以4000V电压输送到波特兰。

Firstly, the single-phase flow field of a typical NACA cascade was calculated and the predicted pressure coefficient has good agreement with the experimental data.

文中首先采用不同的壁面处理方法（标准壁面函数法和两层区域模型法）计算了一典型NACA叶栅内的单相流场，两种壁面处理方法得到的压力系数与实验数据符合很好，两层区域模型在前缘处的压力系数好于标准壁面函数法，与实验数据更接近。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。