单型

The results show that relative humidity is the most sensitive variable to ET0 in general for study area, followed by air temperature, wind speed and sunshine hours. From May to September, the highest sensitivity coefficients to air temperature and sunshine hours is in July, while the lowest sensitivity coefficients to wind speed in July. The absolute sensitivity coefficients to relative humidity increases from May to September. The absolute sensitivity coefficients to all climate variables indicate large spatial variability.

结果表明：参考作物蒸散发对相对湿度最为敏感，其次是气温，最后是风速和日照时数；5～9月，气温和日照时数的敏感系数呈单峰型分布，在7月份达到最高值，风速敏感系数呈单谷型分布，在7月份达到最低值，相对湿度敏感系数的绝对值表现为持续上升趋势；生长季气候变量敏感系数的空间差异性较大。

Methods:9 patients including 8 male and 1 female were included in this study.2 patients suffered from both side of ANFH,5 were righe side and 2 were left side.X-ray,CT and MRI were performed before the surgery.4 hips were classified as ARCO stage 1,7 hips were stage 2.All the patients were treated as follows:the area of NFH and cystis degeneration were detected and bouche decompression was done through X-ray with C-arm,and the necrotic bone was cleared for the pathologic diagnosis under the monitoring of arthroscopy.And then the non-cell based tissue engineering bone, which was the complex of autologous red bone marrow and osteoinductice absorbing material containing BMP,was transplanted into the body.

本组9例，男性8例，女性1例；双侧股骨头坏死2例，右单侧股骨头坏死5例，左单侧股骨头坏死2例；术前均行X线摄片、CT、MRI 检查，ARCO分期：Ⅰ期4髋，Ⅱ期7髋；C型臂X线透视下行股骨头坏死区和囊性变区定位、髓芯减压，关节镜监视下，刮除坏死骨送病理；植入由自体红骨髓与含BMP的骨诱导活性材料复合成的非细胞型组织工程骨，并用空心钛钉支撑股骨头软骨下骨质。

Therefore,the complicated problem is simplified into asolving procedure of a group of infinite dimensional algebra equations.In thefact,not only is a general solution of the problem obtained,but also a method tocompute the dynamic thermal stress distribution at the surface of the cavity afterthe definition of the coefficient of the dynamic thermal stress distribution isgiven.

事实上，不但得到了单连通区域或复连通区域型二维孔洞表面的动态热应力分布问题的一个一般的解析解，而且，在定义了非耦合和耦合无量纲化动态热应力分布系数后，推导出计算单连通区域或复连通区域型二维孔洞表面的动态热应力分布的方法。

In this dissertation, the optical implementations of integrated bypass-exchange switches and interconnection networks are investigated as the followings:(1) An electro-optic bypass-exchange switch integrated in a single substrate of birefringent crystal is proposed, which is polarization based, and consists of two beam splitters based on the phenomena of double refraction and inner double reflection and in-between an electro-optic modulator based on the electro-optic effect of crystal.

鉴于此，本论文从网络集成包装的角度出发，研究bypass-exchange开关和互连网络的光学实现，主要内容包括：(1)利用单轴晶体的双折射双反射原理和晶体的电光效应，设计了一种新颖的单块晶体集成的电光偏振控制型bypass-exchange光开关，将一个电光偏振控制型bypass-exchange光开关所必需的器件（两个光束分束器和一个电光调制器）集成在一块晶体上。

Positive association were still remained for two locus that MNAT1-rs973063 and PCNA-rs25406 and lung cancer risk even after 1000 times permutation test.During the stratified analysis,we revealed that that several genes in the NER pathway could interact with age,gender,family cancer history and smoking status.

在进行了多重校正后，有两个位点仍显示出关联显著性：MNAT1-rs973063(p=0.02)，PCNA-rs25406(p=0.03)；在随后进行的分层分析中，我们发现NER通路多个基因分别和年龄、性别、肿瘤家族史以及吸烟状况之间存在互作，提示该通路基因位点可能主要是通过和环境交互作用产生效应；我们还进行了单倍型的分析，结果发现PCNA和RPA1两个基因上的单倍型和肺癌易感性相关。

The result shows that multiple inlet is better than single inlet, and that inlet with buffer is better than that without buffer. Other optimal design structures are also adopted. The gas manifold with optimal structure make oxygen much evener for each cell.

结果表明多进口比单进口，有比无隔板、扩压型进口比非扩压型进口、椭圆台进口比圆台进口的进气箱结构更易实现电池堆中每个单电池进气量的均匀化。

Consisted of single, double vascular bundle, transition types between them, but given priority to double vascular bundle; the epidermal cell consisted of cutin layer; the hypodermis consisted of typical two-layer of parenchyma cells arranged continuously or discontinuously.

云南松针叶的维管束以双维管束为主，同时亦有单维管束以及介于单、双维管束之间的过渡类型；皮下层为典型的二型皮下层；表皮层的角质层明显；树脂道多为典型的外生型。

Results Eighty-eight strains of Pseudomonas aeruginosa were isolated from 3 ICU, 80 of which were serotypied, the serotyping rate was 90.91%. 52.27%, 22.73% and 9.09% was type B, C and untypied Strains respectively.

结果 3个ICU共检出铜绿假单胞菌88株，对其中80株进行了血清学分型，分型率90.91%；所占比率较大的血清型为：B型52.27%，G型22.73%，未分型菌9.09%。

For the first time, a screw pile and pile driver system for preventing flood and rushing to deal with an emergency was manufactured. The screw piles of the system is different from screw drills used to sap, and it doesn't push soils out. Analyses, including the screw pile's structural strength analysis and the screw blade's welding analysis, were done by ANSYS, which showed that the screw pile's structural strength is enough and that the distort of the screw blade is small. Testing on the screw pile and pile driver system showed that the system performed stably and could meet the need of preventing flood and rushing to deal with an emergency. A mechanics model of interaction of a screw pile and soil was built, and expressions of torque of screw pile's cylindrical part on the condition of screw pile's crew part being driven into soil fully were gained, then the relation of the torque with screw pitch and out diameter of cylinder, which shows the torque decreases with the screw pitch increasing, and that the torque increases with the out diameter of cylinder increasing, which was according with the experiments of the screw pile's being driven into soils, and thus a screw pile with the best structure was chosen. Experiments of bionic surface showed that, on the condition of certain pressure on the surface, the protruding bionic surface can not reduce adhesion and resistance and that the corrugated bionic surface can reduce adhesion and resistance. An orthogonal experiment of the corrugated bionic surface was done with the factors including the width of protrusion, the space between two protrusions, the trolley's velocity and the vertical surface pressure and with the surface frictional coefficient as the experimental target, and some inclusions were drawn that the best combination of the factors was acquired and that the width of protrusion affected the surface frictional coefficient remarkably.

研制了防汛抢险螺旋桩机系统，提高了沉桩作业效率；利用ANSYS对桩体进行整体结构强度分析以及螺旋叶片的焊接分析，表明桩体结构强度足够，焊接过程中，螺旋叶片的变形小；对整个螺旋桩机系统进行试验，表明该系统性能可靠，工作稳定，作业效率高，能够满足防汛抢险沉桩作业基本需要；建立了螺旋桩桩土作用力学模型，得出螺旋桩沉桩过程中螺旋桩螺旋部分完全进入土体时螺旋桩圆柱部分所受扭矩以及扭矩与防汛抢险螺旋桩的螺旋导程和圆柱外径的关系曲线，表明螺旋桩螺旋部分完全进入土体时螺旋桩圆柱部分所受扭矩随着螺旋导程的增大而减小，随着圆柱外径的增大而增大，这与螺旋桩沉桩试验结论相符合，据此优选出最佳结构的螺旋桩；仿生曲面试验表明，尺寸较小的球冠突起型仿生曲面在一定压力作用下未能起到减粘降阻的作用，而尺寸较大的波纹型仿生曲面相对平板具有一定的减粘降阻作用；以波纹型仿生曲面突起宽度、波纹型仿生曲面两突起之间间距、台车的牵引速度以及叶片表面垂直载荷为因素，以曲面摩擦系数试验指标进行正交试验，寻求出在一定试验条件下最佳因素水平组合；波纹型仿生曲面突起宽度在本试验条件下对曲面摩擦系数影响显著，而其它几个因素对曲面摩擦系数影响均不显著；通过波纹型仿生曲面突起宽度和台车牵引速度的单因素试验，表明曲面摩擦系数随着仿生曲面突起宽度的增大而减小，而随着台车牵引速度的变化基本保持不变，和正交试验结果保持一致。

Committed to binding equipment products: ZYH660D folding machine, JBT50/3D4D oval Adhesive Binding of the package, JBT50/3A Oval package this machine, JBT50/4A Oval package this machine, JBB51B Adhesive Binding of the package, DQ440B riding a semi-automatic Ma Ding Shuji, TD102 single wire Ding Shuji, DH11-AB Ding Shu-box set, YP-608/808-mechanical-pressure core of the machine, NB-60 automatic stick-back, small high-performance back-Nien , SX-01 line-lock, DK-2 automatic drilling machine, DK-4-drilling machine, back-pressure.

致力于装订设备系列产品：ZYH660D折页机，JBT50/3D4D椭圆胶订包本机，JBT50/3A椭圆型包本机，JBT50/4A椭圆型包本机，JBB51B胶订包本机，DQ440B半自动骑马订书机，TD102单头铁丝订书机，DH11-AB订书订盒机，YP-608/808型机械书芯压平机，NB-60型自动粘背机，小型高性能粘背机，SX-01锁线机，DK-2型自动打孔机，DK-4型打孔机，压背机。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。