单参数的
- 与 单参数的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
And then we consider the manner in which the Bennett linkage is related to the hyperboloid defined by its joint axes and the one defined by its links. We go on to algebraically inter-relate these and an equivalent screw of the overall instantaneous motion, which help us understand its kinetic property.
然后进一步研究了它的四个轴线所组成的单叶双曲面和它本身的几何参数的关系,使Bennett机构的瞬时运动和某个单叶双曲面结合起来,有利于我们对其运动属性的了解。
-
The results indicate that, in either single or double blowing, larger erosion rate is mainly found in the slag line and near purging plug area of ladle lining; erosion is accelerated when gas flow rate increases; the erosion rate of ladle lining with double blowing is larger than that of single blowing; erosion rate distribution is obviously different as gas flow rate increases; in heavy blowing, serious erosion centers around slag line area and expands gradually outwards; as purging plug gets close to lining wall, malconformation of erosion rate in ladle lining becomes more prominent and the erosion rate of lining near purging plug increases.
结果表明,无论单吹还是复吹,较大的蚀损速率主要分布在钢包渣线及近透气砖区域,吹气量的增大会加速钢包内衬的蚀损。采用复吹时,钢包内衬的蚀损较单吹时更快。随着吹气参数的改变,钢包内衬蚀损速率的分布状况差异明显。大吹气量下,较大的蚀损集中在渣线区域且呈环向扩展;透气砖安装距包壁越近,钢包内衬蚀损不均衡性也越突出,近透气砖内衬蚀损加重。
-
The basic steps of this method are as follows.The firststep is to derive a necessary condition such that the families of quasipolynomials withone parameter,corresponding to the edges of the polytope,have pure imaginary rootsby using the Dixon's resultant for polynomials.Then to check that the casescorresponding to the parameters obtained in the first step are in fact impossible byusing the generalized Sturm criterion and some stability criteria.
其基本思路是先利用多项式方程组的Dixon结式理论导出使各棱边对应的单参数特征拟多项式有纯虚根时,参数值应满足的一个等式条件,即所谓的Dixon结式等于零,然后由广义Sturm判别法验证对所有参数值,Dixon结式不等于零,或使结式等于零的解不产生特征拟多项式的纯虚根。
-
Using the result for non-restricted model, we transform the restricted model to common model, and multi collectivity model to single collectivity model, thus, the necessary and sufficient conditions that nonhomogeneous linear estimators for Sβ are admissible in the class of nonhomogeneous linear estimators are obtained which filled the blank for admissibility for restricted linear model.
对线性等式约束的共同均值线性模型,利用无约束单总体模型的现有结果,通过适当变换,把等式约束模型向无约束转换,并把多总体转换为单总体,在矩阵损失下找到了均值参数β的条件可估函数Sβ的线性估计∑mAiyi+a在非齐次线性估计类中可容许的充要条件,填补了等式约束的共同均值线性模型可容许性方i=1面的空白。
-
In this paper, taking one 1900t/h supercritical pressure once—through boiler installed in East boiler company as subject investigated, analyzing the structure and characteristic of unit, from the mechanism of units, based on the law of quality conservation, energy conservation and momentum conservation, having Lagrange fluid particle tracing idea in hydrodynamics field application in analyzing of unit operational characteristic, author build up the nonlinear distributed parameter general dynamic mathematical model of single-phase heating surface or diphase heating surface in the steam-water system for supercritical pressure once—through boiler, which is suitable numerical calculation and simulation for large scale disturbance and full working conditions change, and enough materializing distributed characteristic of thermodynamic parameter in process and time lag characteristic of energy transportation in tache. The transient responses curve of the system main variables under several disturbance are computed by Computer Simulation for the model, and theoretical analysis shows that the simulation results are reasonable.
本文以东方锅炉集团公司的一台1900 t /h超临界压力直流锅炉为研究对象,在分析机组结构和特性的基础上,从机组的工作机理出发,以质量、能量、动量守恒定律为依据,将流体力学领域中的Lagrange流体质点追踪思想用于机组运行特性的分析上,建立了适用于超临界压力直流锅炉汽水系统单相、双相受热面的非线性分布参数通用动态数学模型,该模型适合于大扰动全工况变化的数值仿真计算,充分体现了过程热力参数的分布特性和环节中能量输送过程的时滞特性,并对模型通过计算机仿真得出各种扰动下系统主要变量的响应曲线,从理论上分析了仿真结果的合理性。
-
The propagation of elegant cosh-squared-Gaussian beams has been investigated and the analytic solutions have been obtained by means of an angular spectrum technique in uniaxially anisotropic crystals.
基于光束在单轴晶体中传输的角谱理论,对复宗量双曲余弦平方-高斯光束在单轴各向异性晶体中的传输作了研究,得到了一般的解析传输公式,并用数值的方法讨论了晶体内源于复宗量双曲余弦平方-高斯光束的两偏振分量的传输特性,结果表明,在适当参数的条件下,两偏振分量在晶体中的传输波形结构基本保持不变。
-
A multi-distance measurements method is employed in this paper. A single parameter fitting method and a double parameters (reduced scattering coefficient and amplitude factor) fitting method on the basis of the least square Newton fitting algorithm is used to derive the optical parameters respectively. For the finite-thickness homogenous tissue, it can be concluded that the rest terms in expressions of diffusion reflectance and transmittance for the corresponding tissue geometries that subtract the exponential term contained source-detector distance depend on the detected position weakly.
在多程测量的基础上,使用单参数最小二乘牛顿法拟合方法和双参数(约化散射系数、幅度因子)最小二乘牛顿法拟合方法,得到有限厚均匀组织的反射率分布和透射率分布公式中除去包含测量位置的指数项的其它部分对测量位置皆具有弱依赖性的结论,并对拟合结果进行了分析讨论;而对于有限厚平板状双层组织,可根据对反射测量结果及透射测量结果进行拟合所得的约化散射系数间的差异及常数因子的正负判断双层组织的可能结构分布。
-
Taking the friction into account and based on the empirical relation for flow friction in circular tube, the paper developed a correlation for the friction factor of gas-solid flow in riser.
参照圆管中的单相流动,考虑提升管几何参数和操作参数的影响,通过定量分析提升管内气固悬浮物与管壁间的摩擦,提出了对表观颗粒浓度的修正式,修正浓度与实际浓度吻合良好。
-
First, the conception of wet compression is defined. A calculation method of moist air and wet gas thermodynamics properties is set up, which treat them as real gas and can give out the results of any water-air/gas ratio. Second, the thesis build the simulation model of water injection between compressor stages of a single shaft gas turbine, based on which the stable analysis is processed and the characteristics of key performance parameters are given out, such as the variation of air flow, pressure ratio, turbine inlet temperature with the water quantities. Results showed that enhancement of power output is outstanding.
文中定义了湿压缩概念,研究适用于计算机计算的湿空气,湿燃气等实际气体的热物性计算方法,利用此法可较准确地计算任意水气比下湿空气,湿燃气的各热物性参数,建立并推导单轴燃气轮机级间喷水热力循环的数学模型,用此模型进行稳态循环分析,并得出级间喷水时燃气轮机各主要性能参数的变化规律,如随喷水量变化,空气流量、压比、燃气初温等的变化规律。
-
A layout was designed to fabricate InGaP/GaAs HBTs with different scale and passive components including thin film resistors, overlay capacitors, spiral inductors and varactors. Their equivalent models were given and the process was discussed.
设计了一套包括叉指型、马蹄型、多指单胞等不同参数的InGaP/GaAs HBT器件和集成在GaAs衬底上的不同规格的电感、电容、电阻、变容二极管等无源器件,研究了无源器件的等效电路和计算方法,为微波单片集成电路的设计和制备打下了一定基础。
- 推荐网络例句
-
I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""
客人们在卡罗利娜·埃凯家里,举止就文雅一些,因为卡罗利娜的母亲治家很严厉。
-
Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.
由著名品牌 Herm è s 设计,这件高贵的制服是香港本土制造,是我们第一套不配帽子的制服。
-
Do not 'inflate' your achievements and/or qualifications or skills .
不要 '夸大' 你的业绩或成果,条件或者技能。