升高

The results: the phase transferring range of TiO2 is between 600-750℃; with the doping of tourmaline, the UV-VIS adsorption spectrum of Nd/TiO2 was basically not affected, and showed a gradual Einstein shift with the increase of calcined temperature between 300-750℃; OH intensity of Nd/TiO2 could be enhanced both in irradiation and in no irradiation when tourmaline was added in it; the doping of 0.6% tourmaline led to the best photocatalytic activity of Nd/TiO2 and the best photocatalytic effect appeared when calcined at 600℃.

结果发现TiO2的相变转化区间在600~750℃范围内；电气石掺入对Nd/TiO2材料的光吸收范围基本没有影响，在300~750℃范围煅烧后，随温度升高UV-VIS图谱有逐渐红移现象；电气石的加入使得Nd/TiO2材料在光照及未光照条件下都起到增强OH强度的作用；在Nd/TiO2材料中掺入0.6%的电气石获得最好的光催化活性，600℃下煅烧光催化效果较优。

Temperature is divided into low-melting-point alloy fuse-shaped form with the trigger temperature shape memory alloy, etc. There are temperature fuse is easy to prevent heat or electrical heating appliances for the protection of high temperature, such as: hair dryer, electric iron, electric rice cookers, electric, transformers, motors, etc.; its temperature rise in response to the increased electrical power, would not care about the current size of the circuit.

温度保险丝又分为低熔点合金形与感温触发形还有记忆合金形等等（温度保险丝是防止发热电器或易发热电器温度过高而进行保护的，例如：电吹风、电熨斗、电饭锅、电炉、变压器、电动机等等；它响应于用电电器温升的升高，不会理会电路的工作电流大小。

Electrocautery in the sum of the temperature to 480 ℃, Shubin began to carefully outline, the yellow appeared on the charring wood or deep or shallow, or coarse or fine lines, brown, 10 minutes, four vivid The shrimp will be on the board ran.

在电烙笔的温度升高到480℃之后，俞彬便开始细心勾勒起来，黄色的木板上出现了炭化后或深或浅、或粗或细的棕色线条，十分钟后，四只活灵活现的虾便跃然板上。

The stress-strain curves of Cu-Zn-Al alloys at different temperatures have been plotted on the tensile machine with the aid of electrometry. The main results were as follows: 1. When specimens were deformed within the range of M_s and M_d, the critical stress for inducing martensitic transformation increased with the temperature, and there existed a linear relationship between them. 2. When specimens were deformed above Af, complete pseudoelasticity might be obtained theoretically, which might be damaged, h...

在拉力试验机上用电测法测绘了Cu-Zn-Al合金在马氏体相变点上下各温度的σ-ε曲线，所得主要结果如下：(1)试样在M_s与M_d之间加载，随着温度升高，诱发马氏体相变所需临界应力增大，且加载温度与临界应力之间存在着线性关系；(2)在A_f点以上加载，理论上可获得完全的伪弹性，但加载温度过高或应变量过大，均会损害伪弹性；(3)试样在M_s点上下温度区域变形，得到的伪弹性回复和形状记忆回复之和在80%以上，但在M_s点附近总回复量出现一极小值，且伪弹性回复在M_f点以下又有所回升。

The electromotive force of the cell was investigated at temperature between 800 and 1000℃.

由实测电动势与Nernst方程导出的理论电动势之比求得的氧离子迁移数在测量温度范围内都大于0.96，并随着温度的升高而逐渐增大。

The ALT that goes out to detecting lifts alive and HBsAg, HBeAg is electropositive person undertake visitting investigating.

对检测出的ALT活升高和HBsAg、HBeAg阳性者进行走访调查。

The main reason and solution: this is mostly because the temperature is too high, hot stamping and should be appropriate to reduce the electrothermic temperature, to play as little as possible, to reduce unnecessary empty car parking spaces, because the empty wagons, parking makes the electrothermic temperature rise.

主要原因和解决方法：这种情况多数是因为烫印温度太高，应适当降低电热板温度，要尽量少打空车，减少不必要的停车，因为空车、停车都会使电热板温度升高。

The risk to both the elevated Harrow Road and the Westway above was considered to be unacceptable in the long term and that something had to be done to ensure the safety and integrity of the structure.

这两项的风险升高哈罗道及以上被认为是西区高速路不能接受的，长期的东西有非做不可以确保安全和结构的完整性。

From Wulin Square Road elevated in later, Shi Xiang Road, traveling to the northeast, reached the North Garden consuming less than 16 minutes.

从武林广场路升高后，施希昂道，前往东北，达成北花园消费不到16分钟。

But when the pressure stays elevated over time, then it's called high blood pressure or hypertension.

但是，当压力升高停留随著时间的推移，然后它的所谓的血压高的压力或高血压。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。