升温

In march, ChengZe market into thin fabric exchanges, especially the spring up all kinds of emulation silk fabrics, auction of product exhibition charm, so now against qiao ChengZe market is described below, is three best-selling emulation silk fabrics

进入三月份，盛泽市场上的薄型面料交易有所升温，尤其是春夏各类仿真丝织物竞展风姿，群品争俏，所以现在的盛泽市场可谓是热火朝天，下面介绍三款比较畅销的仿真丝面料

The numbers stand out in white from the black background, the indicators in the traditional red colour of BMW M GmbH are particularly clear and easy to monitor A special feature typical of a BMW M Car is the rev counter with its variable warning field informing the driver while the engine is warming up of the speed range currently available as a function of engine oil temperature.

这些数字站在从白色的黑色背景，在传统的宝马M公司红色的指标特别清晰，易于监控特色的宝马汽车的典型是与它的可变转速表的警告通知外地司机而引擎的升温速度范围，目前，作为机油温度的函数可用。

The results show that the reaction of EMAL pyrolysis occurs between 150℃ and 600℃, and the kinetic model of EMAL pyrolysis can be simulated with a first-order reaction, and the obtained activation energy increases with the increase of heating rates.

研究结果表明毛竹EMAL热解反应的主要温度范围是150~600℃，其热解动力学模型可用一级反应表征，所得活化能随升温速率的增大而增加。

The relationship between the apparent viscosity and temperature can be expressed by Arrhenius Equation. But there is a flex point during heating, and the viscous flow activation energy at the low temperature is greater than that at the high temperature.

液化残渣的黏度－温度关系符合Arrhenius关系式，但在升温过程中出现了拐点，低温段的黏流活化能比高温段的要大。

The isothermal anneal at an elevated temperature of 1150℃ ramped up from a starting temperature （600-1000℃） was employed to enable the growth of the grown-in oxygen precipitates that are larger than the critical size at the starting temperature. Flourier transformation infrared spectroscopy and scanning infrared microscopy are used to measure the amount of precipitated oxygen and the oxygen precipitate density in a 300mm nitrogen-doped Czochralski silicon wafer, respectively.

文章摘要：采取从某一温度（600-1000℃）开始缓慢升温至高温（1150℃）并保温若干时间的方法，使得直拉si片中大于起始温度对应的氧沉淀临界尺寸的那一部分原生氧沉淀得以长大，然后通过傅里叶红外光谱测量氧浓度变化以及利用扫描红外显微术测量氧沉淀密度。

Desmear: Friction during drilling causes the drill to heat-up and melt the resin between copper layers.

除胶：钻孔时的磨擦使钻刀升温，使得孔内板材中的树脂熔化。

In this article, the electric resistance furnace is used to heat the carbon cathode , anode and ramming paste samples of aluminum reduction cell, the temperature regulator used to regulate heating-up of the electric resistance furnace and high temperature mixed fume is inlet into melting chamber as oxidizing atmosphere.

本文利用电阻炉来加热铝电解槽的碳阴极、阳极以及扎固糊试样，使用温度控制器来控制电阻炉的升温，用高温烟气通入炉膛内作为氧化气氛。

When the temperature and retention time reach 160 ℃and 80 minutes respectively , most of thesolid grease in the garbage is extracted out to become floatable oil which can be separated and recovered readily. Subsequently , the amount of floatable oil begins to decrease since chemical reactions such as the partial hydrolysis of the oil take place. Additionally , the extraction of solid grease from interior accords with first2order reaction dynamic model.

结果表明，湿热处理初期，垃圾脱水率下降，加热40min 后，脱水率开始上升，且温度越高，上升越快，180 ℃加热100min 达最高；随着温度的升高和加热时间的延长，餐厨垃圾脱油性能呈上升趋势，温度越高，上升趋势越明显；当温度达到160 ℃，加热时间达80min 时，垃圾固相油脂基本浸出完全，继续升温和加热，部分油脂发生水解等化学反应，可浮油量开始降低；垃圾固相脂质浸出符合一级反应动力学。

Helium was used as the carrier gas under a constant pressure of 206 kPa. The oven was programmed at a rate of 5 ℃/min from 90 ℃(held for 5 min) to 280 ℃(held for 5 min).

载气为氦气，恒压，柱前压206 kPa；进样器温度250 ℃；柱箱初始温度为90 ℃，保持5 min，以5℃/min的升温速率升至280 ℃，保持5 min。

Furthermore, the internal gettering processes appropriate for CZ and NCZ silicon wafers based on the RTP and ramping anneal in the low temperature range are proposed.

此外，提出了适用于CZ和NCZ硅片的基于高温RTP和低温缓慢升温热处理的内吸杂工艺。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。