动质

The friction performances of carbon face were investigated with an inertia friction tester. The torque curve of carbon face was ideal, the coefficient of static friction was lower than that of dynamic in 0.28 MPa, the friction coefficient of static and dynamic decreased with the braking pressure increasing. To the fiber face, the coefficient of dynamic friction of carbon face was more stable in cycle braking process, the wear rate was lower, and it was efficient to protect the couple plate not to be worn.

结果表明：碳质层的摩擦力矩在制动初期上升较快，中间过渡区平稳，尾部翘起较小；在制动压力小于0.28 MPa时静摩擦系数小于动摩擦系数，且动、静摩擦系数均随制动压力增加而减小；相对纤维层而言，采用碳质层摩擦时摩擦力矩曲线形态更好，连续制动时摩擦系数波动较小，磨损率低且能够有效保护偶件，是1种静/动摩擦系数比较低且适用于高载荷工况条件下使用的摩擦材料。

The friction performances of carbon face were investigated with an inertia friction tester.The torque curve of carbon face was ideal,the coefficient of static friction was lower than that of dynamic in 0.28 MPa,the friction coefficient of static and dynamic decreased with the braking pressure increasing.To the fiber face,the coefficient of dynamic fric...

结果表明：碳质层的摩擦力矩在制动初期上升较快，中间过渡区平稳，尾部翘起较小；在制动压力小于0.28 MPa时静摩擦系数小于动摩擦系数，且动、静摩擦系数均随制动压力增加而减小；相对纤维层而言，采用碳质层摩擦时摩擦力矩曲线形态更好，连续制动时摩擦系数波动较小，磨损率低且能够有效保护偶件，是1种静/动摩擦系数比较低且适用于高载荷工况条件下使用的摩擦材料。

The result indicates the t-BHP or diamide both cause the mass loss about the membrane protein thiol in hepatocytes, the fast oxidization about glutathione in hepatocytes, the leakage of lactate dehydrodenase, but the level of t-BHP is larger than of diamide. In the aspect of lipid peroxidation, only the t-BHP produces apparent change. As to actin and tubulin, they both find fall-off and present time-dependency effects. The result in Confocal fluorescent microscope also show these two cytoskeletal proteins are related to cell blebbing, but they don''t play the same role during the porcess. Tubulin may be more important than actin. If the study predispose dithiothreitol before adding t-BHP or diamide, then the damage by the diamide is repressed, but just partly protection for the damage by t-BHP.

结果显示t-BHP或diamide均可造成细胞膜蛋白硫醇大量流失与胞内GSH快速氧化，亦显著导致乳酸去氢□渗漏，但t-BHP诱发的渗漏程度大於diamide；在脂质过氧化方面，则仅t-BHP处理组产生明显的脂质氧化情形；至於肌动蛋白与管蛋白单体均可见减少且呈现时间依赖效应；在雷射共轭焦萤光显微镜观察中，亦显现这两种架构蛋白与细胞膜起泡有关，但两者在小泡生成的过程中扮演的角色并不完成相同，可能管蛋白较肌动蛋白重要；如果细胞在t-BHP或diamide加入前预先以dithiothreitol处理，则diamide 所造成的伤害显著的受到抑制，但DTT对t-BHP所诱发的伤害则仅有部分保护效果。

Cancellous bone from the lumbar proteomic expression analysis show that actin, keratin, enolase, ATP synthase, the expression of myosin may be related to ovarian lumbar cancellous bone after osteoporosis-related happened; Qiang Gu Bao Po on the lumbar spine osteoporosis intervention effect may be related to reduced carbonic anhydrase, actin, crystal protein, 3- phosphoglycerate dehydrogenase, serum albumin, ATP synthase, myosin, the enolase expression.

从腰椎松质骨蛋白质组表达分析可知，肌动蛋白、角蛋白、烯醇化酶、ATP合酶、肌球蛋白的表达增强可能与去卵巢后腰椎松质骨骨质疏松的发生相关；强骨宝对腰椎骨质疏松的干预效应可能与下调碳酸酐酶、肌动蛋白、αB-晶体蛋白、3-磷酸甘油醛脱氢酶、血清白蛋白、ATP合酶、肌球蛋白、烯醇化酶的表达有关。

A measuring approach of pressure oscillation has been developed and experiments are conducted in a 10 liter two-dimension air-lift loop reactor. The experimental results show that the local mass transfer parameters have close relationship with the operating conditions, the structure of ALR and the properties of the reaction systems. A series of measurements of pressure pulse indicate that a gas distribution zone exists near the gas sparger, and in this zone the responding signals of pressure pulse are different with the signals measured in other parts of the reactor.

对不同结构的环流反应器的局部流体动力学和传质动力学特性进行了研究，利用压力传感器测量了空气-水、空气-NaCl水溶液、空气-Na〓SO〓水溶液、空气-葡萄糖水溶液和空气-乙醇水溶液五种体系，在不同气速下，不同位置的压力脉动信号，通过随机信号的数学分析，得到压力脉动信号的频谱特性，并依据压力脉动信号的频谱特性的分析给出环流反应器气体分布区的范围。

M/s. The following dimensionless relationships were obtained: Sh=2+0.073Re〓Sc〓〓〓 The desulphurization process by powder injection and blowing in RH refining of molten steel and its mechanism have been considered and analyzed. Based on the tworesistance mass transfer theory and the mass balance of sulphur in the system, a kinetic model for the process has been developed. The related parameters of the model have been reasonably determined. Modeling and calculations for the process by injecting and blowing the lime based powder flux under the assumed operating modes in a RH degasser of 300t capacity have been carried out using the model.

考虑颗粒与液流的相对速度，RH—PTB条件下熔池传质特性可由下式表征： Sh=2+0.073Re〓Sc〓考虑紊流中脉动速度引起的能量耗散，RH—PTB条件下熔池传质过程服从如下关系：〓将粉剂颗粒与钢液间的传质当作刚性的气泡与钢液间的传质处理，对RH—PTB过程有：〓考察和分析了RH喷粉脱硫过程及机理，基于双重阻力传质理论和体系内硫的质量衡算，建立了RH喷粉脱硫过程的动力学模型，确定了模型各有关参数，包括各传质系数和脱硫处理过程中钢液内参与脱硫反应的粉剂量等。

In the normal uterus, Cytokeratins immunolabelling were detected in glandular cell, luminal epithelial cell, Vimentin immunolabelling were detected in stromal cell and endoblastic cell; CK7 immunolabelling were not detected in any tissue of the yak utenus.

研究结果显示：未妊娠时，泛角蛋白在子宫内膜腺上皮细胞、腔上皮细胞内表达，波形蛋白在子宫内膜基质细胞内表达，平滑肌肌动蛋白在子宫平滑肌和血管平滑肌内表达，牦牛子宫任何部位均不表达角蛋白7；妊娠30天左右时，泛角蛋白在子宫内膜腺上皮细胞、子宫内膜腔上皮细胞、滋养层细胞、内胚层细胞和尿囊细胞内表达，波形蛋白在子宫内膜基质细胞和内胚层细胞内表达，平滑肌肌动蛋白在子宫平滑肌和血管平滑肌内表达，角蛋白7在尿囊细胞内表达，偶尔在腔上皮细胞的细胞核边缘表达；消化法进行原代培养时，组织经胶原酶消化并通过100目和400目筛网组合可以有效地分离原代子宫内膜基质细胞和子宫内膜腺上皮细胞；分离得到的子宫内膜基质细胞活率达90%以上，并可在体外传代7次以上；分离得到的子宫内膜腺上皮细胞活率可达85%以上，并可在体外传代5次以上；RPMI1640培养基最适合子宫内膜基质细胞和子宫内膜腺上皮细胞的生长，维持子宫内膜基质细胞正常生长的FBS添加量为20%，维持子宫内膜腺上皮细胞正常生长的胎牛血清添加量为30%。

Postoperative pathological results revealed that 79 cases (86.8%) were low-grade gliomas, 4 cavernous hemangiomas, 4 anaplastic astrocytomas, 2 gliosis, 1 arteriovenous malformation, and 1 gliosarcoma.

术后病理结果示低级别胶质瘤79例(86.8%)，海绵状血管瘤4例，间变性星形细胞瘤4例，神经胶质增生2例，动静脉畸形1例，胶质肉瘤1例。

Planococcus can metabolize electric insulating oil.

对动性球菌代谢变压器绝缘油进行了研究，发现动性球菌能够代谢绝缘油，利用薄层层析、液-质联机等技术从变压器绝缘油的动性球菌代谢物中分离得到一种脂肪酸，用质谱、核磁共振对其结构表征。

As same as the above-mentioned reason, because theconditions at the inside straight boundary of the binarycomposite material can not be easily satisfied, here, anelastic circular inclusion with large radius is used to replacethe upper half space of the binary composite material, so the〓mary binary composite mater ial problem can be changed〓the scattering problem of a circular elastic inclusion andto the scattering problem of a circular eastic inclusion and〓circular cavity in an infinite space to the steady incident〓wave.

与前面两个问题的理由一样，同样，由于问题中双质复合材料的内部直边界上的边界条件不易解析满足，为此，本文采用了一个半径很大的弹性实夹杂来代替问题中双质复合材料的上半空间部分，而将原来的双质复合材料问题转化成了无限大空间中一圆形弹性夹杂和一圆孔对稳态P波的共同散射问题，根据该问题的特点写出了弹性夹杂内外波场中波函数的一般形式解，利用该问题中夹杂和圆孔处的位移和应力的连续条件，并采用复数傅立叶级数展开技术将其化为一个仅包含问题波函数中未知系数的无穷线性代数方程组，在满足一定计算精度的前提下，通过有限项截断进行近似求解，进而讨论了双质复合材料中圆孔边界处的动应力集中系数随不同入射角、圆孔的不同位置、以及入射波的不同无量纲波数的变化和分布情况。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。