动的

Figure 6.K=0.3,the percentage differential characteristic（the one left is superimposed differential currents algorithm;the right conventional algorithm,the same as follows

K=0.3，比率差动特性（左边的为故障分量的比率差动，右边为传统比率差动，以下相同

The basic solutions were defined based on local coordinate system, and then the coordinate transform relation between the static and dynamic characteristics of magnetic bearing with arbitrary structure and the basic solutions were deduced.

研究了电磁轴承静动特性的计算方法，定义了基于局部坐标系的电磁轴承静动特性基础解，推导了任意磁极结构的电磁轴承动力学特性与基础解之间的坐标转换关系；在此基础上提出了利用基础解计算任意磁极结构的电磁轴承静动特性的方法，该方法简捷、快速，是电磁轴承静动特性计算的一套规范化、标准化的方法。

According to the influence of the clutter to GMTD in SAR system, this paper uses a method combining elimination of the clutter with refocus of the moving targets.

基于杂波对机载SAR慢速动目标检测的影响，采用杂波对消与动目标聚焦相结合的方法完成动目标检测。

The interactions between gas and particles were considered by a two-way coupling method.The motion of particles in the spouted bed with complex geometry was solved by combining DEM and boundary element method.The minimal spoute...

通过采用BEM+DEM-CFD相结合的方法进行模拟计算，得到了喷动床的最小喷动速度，研究了不同表观气速下床内的流型，得到了二维导流管喷动床的床层压降与表观气速的关系，统计分析了喷射区、环隙区内颗粒的运动速度和相应的空隙率，全面地描述了二维导流管喷动床内的气固流动特征。

The main characteristics of moving-coil structure, is about the basic principles of moving-coil loudspeaker in the solenoid valve on the transplant applications, dynamic general use of non-magnetic materials, magnetic saturation does not appear, hysteresis, remanence and other adverse effects.

主要特点是动圈式结构，即将动圈式扬声器的基本原理在电磁阀上的移植应用，动圈一般采用非导磁材料，不会出现磁饱和，磁滞，剩磁等不利影响。

In this paper,taking microswitch as type mechanism of openable closed electromechanical components,on basis of constructing it s finite element model of the quick acting mechanism s static dynamic process and contact system s electrical contact process.

以微动开关作为机电元件的典型代表，通过构造其速动机构静态、动态全过程和接触系统全过程有限元模型，并以动态模型为桥梁，将静、动态过程与电接触过程这三类不同问题联为一体，构造了综合模型，仍以AK型微动开关为例，给出了计算机模拟的综合实

The actuator fixed by four bolts (diameter is 1.7 mm) arranged in an asymmetric rectangle (60°- 90°- 90°- 120°) along the border of a piezo buzzer denominated as "2-3-3-4 mode-shape actuator" can rotate a rotor clockwise or counter clockwise with a line speed up to 400 mm/s under 12 peak-to-peak voltage.

其设计方式有别於其他压电超音波致动器，主要系以四支直径1.7 mm的螺丝依不对称角度60°- 90°- 90°- 120°将蜂鸣片固定於致动器的基座上，称之为2-3-3-4模态致动器。

The asymptotic solutions of non-uniform conical shells under arbitrary boundary conditions are determined by double-parameter perturbation technique and transfer function method.

利用摄动方法，将微分方程进行双参量摄动，采用传递函数法对所得到的摄动方程进行求解，得到了变厚度圆锥壳在任意边界条件下的渐近传递函数解。

And we can also prevent the maloperation of the differential protection due to inrush current or TA saturation.

既可以保证区内故障动作的灵敏和速动性，又能有效防止励磁涌流和TA饱和引起的差动保护误动。

In Chapter 2, we recapitulate some fundamental definitions and propositions of topological degrees and some fundamental results about the computation of topological degrees;in Chapter 3, applying relative definitions and propositions of topological degrees, we establish product formulae of topological degrees in product space, in particular, the product formula of fixed point index on product cone, moreover, combining with the fundamental propositions and the computation of fixed point index, we obtain some fixed point theorems on product cone.

为此，在第二章中，我们给出了拓扑度的基本概念和性质以及拓扑度计算方面的基本结果；在第三章中，运用拓扑度的有关知识，我们建立了乘积空间中各类映射的拓扑度的乘积公式，特别是乘积锥上的紧连续映射的不动点指数的乘积公式，进一步，结合不动点指数的基本性质和不动点指数计算方面的基本结果，得到了乘积锥上的若干不动点定理。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。