动力的

Sediment from river is not the main source of the Rushan Bay now any more ,which leads to the change of balance of sedimentation power. Sediment will transport because of the drive of hydrodynamic elements in macroscopic view .Direction of suspended load is basicly the same as tidal current .Flood tide makes suspended load transport to tip of the inner Bay and to the Mouth in exterior Bay .The direction of longside sediment transport in two sides of the Mouth mainly focus in the Mouth .Because the coastline along the exterior Bay is very meandering and it belongs to the type of bedrock ,besides some sediment going into the inner Bay ,so actual net sediment discharge rate is less than calculation .It develops an ebb delta out of the Mouth and forms tidal sand ridge ,tidal washing canal ,barrier bar and marine physiognomy ;The result of model simulation disclosures that differences of sediment erosion and siltation between single tidal action and wave-current action are very big .From the analysis of sediment composition、sediment sources and stability of beach and ridge ,this article gets the conclusion that the channel has the possibility to silt ,though the course maybe very slow.

通过分析研究文章得出如下结论：沉积物平面分布与水动力的时空变化存在很好的相关性；口门外发育落潮流三角洲，形成潮流沙脊、潮流冲刷槽、浅滩、拦门沙等水下动力地貌；乳山湾河流来沙已不是湾内泥沙主要来源导致沉积水动力平衡发生改变，宏观上表现在泥沙受水动力驱动发生不断运移；悬沙运移方向与涨潮流方向基本一致，湾内涨潮流带来的悬移质泥沙向湾顶运移，湾外悬移质泥沙主要向口门方向运移；湾口两侧岸段沿岸输沙方向均指向口门方向，由于乳山湾外海岸线曲折，两侧岸段以基岩为主，加之部分泥沙进入湾内，实际净输沙量小于计算值；数值模拟发现潮流单独作用与波流共同作用下泥沙蚀淤模拟差别较大；从沉积物组成、泥沙来源及滩槽稳定性三个方面分析，文章认为研究区存在航道淤积的可能性，但过程相对较慢。

According to the principle of quantum mechanics, exploringly presented the possible mechanism of large-scale expansion at forepart of earth, quanta earth tectonic dynamic mechanism formed from super solid state of centrosphere material, presented the integral tectonic criterion in the process of evolution of earth system considering potential of quanta, potential energy of gravitation and heat energy as a result of special state of matter of centrosphere.③Established the evolutional model of finite nonlinear expansion to of integral tectonic dynamic of earth expansion., presumed and gived the skeleton model of original forepart earth before expanding. Applying the universal large scale finite element software, for the first time considered heat power and self gravitation in the same model of tectonic dynamic model simultaneously.

较系统地讨论了地球膨胀整体构造动力的若干基本理论问题：①分析汇总了地球演化产生、积累和以各种形式损耗的总能量，根据考虑引力势能与热能的维里定理，对现时地球整体动力状态进行判断；②根据量子力学原理，探索性地提出地球大规模膨胀的可能机制——地核物质超固态形成量子简併压强产生的动力——地球量子动力，给出了考虑地核特殊物态的量子势能、引力势能和热能的地球系统演化过程中的整体动力状态判据；③建立了地球膨胀整体构造动力的非线性有限膨胀演化模型，推测给出膨胀前早期地球的轮廓性模型。

Chapter 4 firstly analyses the generation mechanics, calculating method and interference effect of flow force in the outflowing large-capacity proportional valve. Then it not only presents a structural design to compensate the flow force according to the performance characteristic of the cone valve, but also calculates and simulates the flow field at the valve port through CFD software Fluent6.0. At last it studies the influence of compensation structure parameters and obtains better projected dimensions.

第四章主要阐述了电液大流量控制阀的液动力产生机理，计算及其对系统的干扰作用，在此基础上针对该阀的结构和工作特点提出阀芯所受液动力的补偿方法和结构，然后对阀口处的流场进行了有限元仿真计算，探索了液动力大小与补偿结构的各参数之间的关系，最后得出能实现液动力补偿的合理结构。

The function of spiritual force cant be replaced with that of material force.

通过上述分析，本文得出结论：精神动力是社会主义发展动力体系中一个重要组成部分，物质动力的作用不能代替精神动力的作用。

Introduces a method of taking the value of braking deceleration when the shaft single-rope winding cage was braking,and breaking deceleration when overfall puts forward the gravity of a cage with braking force and the deceleration degree three correlation,puts forward reasonable value characteristic index of safety catch and overfall ,thus attaining to the optimun design of braking force.

介绍了立井单绳提升罐笼在断绳时制动减速度、过放时防坠器制动力的取值方法，提出了罐笼的重力与制动力及减速度三者间相互关系，防坠器及防过放制动力特性系数的合理取值，从而达到制动力优化设计。

Ecr could promote the gastrointestinal motility, which has some dose-effect relationship. The effect on the gastrointestinal motility of Ecr has no significant difference with the domperidone and prepulsid. The mechanism may be that Ecr could affect the activity of the DVC in the spinal cord, and sequentially the activity of pneumogastric nerve were regulated.

白萝卜提取物对胃肠动力有较为明显的促进作用，这种促动力作用存在着一定的量-效关系；白萝卜提取物促进胃肠道动力的作用与经典的促胃肠动力药物对比没有显著性差异；白萝卜提取物促进胃肠动力的作用机制存在通过对支配胃运动的延髓迷走复合体的激活作用，进而调节迷走神经而实现其对胃运动的调节。

The effect of Reynolds number on rudder hydrodynamic performance is also analyzed. Up to the stall angle the computed lift and drag agree well with measurements and other author's calculations, whereas stall angle, lift and drag beyond the stall angle are slightly under-predicted. The solver is used to investigate laminar and turbulent separated flows around a 6: 1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces. The second separation flows are successfully identified in both laminar and turbulent flow simulations.

应用所开发的求解器，以6：1长椭球体为算例计算了回转体在大攻角下定常斜航运动时的三维粘性流场及水动力，对层流流动和湍流流动分别进行了计算，分析了层流与湍流分离流动和涡旋产生的特点及其对水动力的影响；计算结果与他人的试验和计算数据比较，吻合程度良好，表明应用本求解器能够正确模拟这种以层流／湍流分离流为主的复杂粘性流动，得到相当精确的水动力，检验和验证了该求解器精确模拟回转体在大攻角下的粘性分离流动和计算水动力的能力。

The solver is used to investigate laminar and turbulent separated flows around a 6:1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces. The second separation flows are successfully identified in both laminar and turbulent flow simulations. The computations are shown to agree well with available experimental and numerical data and the physics of 3D large-scale flow separations and vortex shedding are confirmed.

应用所开发的求解器，以6：1长椭球体为算例计算了回转体在大攻角下定常斜航运动时的三维粘性流场及水动力，对层流流动和湍流流动分别进行了计算，分析了层流与湍流分离流动和涡旋产生的特点及其对水动力的影响；计算结果与他人的试验和计算数据比较，吻合程度良好，表明应用本求解器能够正确模拟这种以层流/湍流分离流为主的复杂粘性流动，得到相当精确的水动力，检验和验证了该求解器精确模拟回转体在大攻角下的粘性分离流动和计算水动力的能力。

According to it's mechanical components, the rolling machine can be divided into four sections, as follows:(1) dynamic components : dynamic part is the power sources of the machine;(2) transmission parts :the transmission device part is the centre to transfer the movement and the dynam of the dynamic part to the working parts, it is the core of a machine;(3) the working part : which completes the machinery task directly;(4)control parts : the state control and regulation of the machinery.

根据机械的组成，轧车可分为如下四个部分：（1）动力部分：动力部分是机器动力的来源；（2）传动部分：传动装置部分是将动力部分的运动和动力传递给工作部分的中间环节，因此是一部机械中的核心部分之一；（3）工作部分：工作部分是直接完成机器工作任务的部分；（4）控制部分：控制部分是对机械的工作状态进行控制和调节。

In addition, it manages to anatomize its shortcomings and defects, and to explain at length, through the impetus angle of view, Chinas fantastic achievements and regretful lapsus of socialist construction under the leadership of Mao. And hence reveal the internal connection between the theoretical flaws and the practical faults.

既论述了该理论的伟大理论贡献，认为它发展了马列主义的社会发展动力理论，丰富了科学社会主义理论宝库，奠定了邓小平社会主义发展动力新学说的理论基础；也尝试着剖析了该理论的不足和偏颇之处，试图从社会主义社会发展动力的视角，科学地阐释毛泽东领导下的中国社会主义建设的突出成就和重大失误的社会主义社会发展动力根源，力求找出毛泽东在动力理论认识上的缺陷与其实践建设失误之间的内在关联。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。