动力学条件

This paper mainly introduces experimental methods and basic principle about gelled acid reaction kinetics. Through the reaction kinetics experiment of straight acid and gelled acid, the reaction parameters of acid - rock reaction and kinetic equation in different conditions were achieved.

介绍了胶凝酸反应动力学的试验方法及基本原理，进行了普通酸和胶凝酸与灰岩的反应动力学试验，得到不同条件下的酸岩反应动力学参数及反应动力学方程，对优化碳酸盐岩油藏酸压设计有一定的指导作用。

In this topic, the dynamic analysis methods for piezoelectric vibrator are studied systematically based on the theoretical model, FEM numerical experimentation and FEM governing equation for given compound-mode vibrator, and some valuable conclusions are obtained. The main work accomplished is summarized as follows: 1.Elaborate the main modeling methods for piezoelectric vibrator and the significance and necessity to study the dynamic characteristics of piezoelectric vibrator which emphasize the urgency of this paper. 2.Take the bending deformation induced by piezoelectric ceramic as example, the energy transfer mechanism of electric energy to mechanical energy are analyzed; the motion and force transfer mechanism are analyzed for the longitudinal-bending vibrator. 3.Based on mode assumption and Hamilton principle, the coupling model of piezoelectric vibrator of linear USM is built; moreover, the equivalent circuit model is obtained and a coupling equation represents the relation between electric parameters and mechanical parameters is derived which provides foundation to match the vibrator and driving circuit. 4.Combine the constitutive equation of piezoelectric ceramic with elastic-dynamical equation, geometric equation in force field and the Maxwell equation in electric field and the corresponding boundary condition equation, the FEM control equation for piezoelectric vibrator of USM to solve dynamic electro-mechanical coupling field is established by employing the principle of virtual displacement. The equation lays the foundation to study the non-linear constitutive equation of piezoelectric ceramic driven by high-power. 5.Define the dynamic indexes of characteristic of vibrator and carry out variable parameters simulation by calculating the model parameters and the electric characteristics of vibrator are simulated according to the equivalent circuit model. By numerical experimentation, the working mode of vibration of vibrator and the shock excitation results of the working frequency band which provides the mode frequency to realize bimodal are analyzed. Detailed calculation of the electro-mechanical coupling field parameters is made by programming the FEM control equation.

本课题从理论模型、有限元数值试验、有限元控制模型等方面以复合振动模式振子为例对超声电机压电振子的动力学特性及其分析方法进行了全面系统地研究，得出了许多有价值的结论，主要概括如下： 1、阐述了目前针对超声电机压电振子的主要建模方法，对压电振子动态特性的研究意义和必要性进行了论述，突出了本文研究内容的迫切性； 2、以压电陶瓷诱发弹性体发生弯曲变形为例，分析了压电陶瓷通过诱发应变来实现机电能量转换的机理；对基于纵弯模式的压电振子的运动及动力传递机理进行了分析； 3、基于模态假定，利用分析动力学的Hamilton原理，建立了面向直线超声电机压电振子的机电耦合动力学模型，并据此建立了压电振子的等效电路模型，导出了电参量与动力学特性参量的耦合方程，为压电振子与驱动电路的匹配提供了依据； 4、从压电陶瓷的本构方程出发，综合力场的弹性动力学方程、几何方程、电场的麦克斯韦方程以及相应的边界条件方程，采用虚位移原理，建立了压电振子动态问题机电耦合场求解的有限元控制方程，为研究其大功率驱动下的非线性本构模型奠定了基础； 5、界定压电振子的动力学特性指标，对压电振子的机电耦合动力学模型参数进行计算及变参数仿真；依据等效电路模型，对压电振子的电学特性进行了仿真分析；通过有限元数值实验，对压电振子工作模态附近的模态振型及工作频率附近的频段进行了激振效果分析，找出了实现模态简并的激振频率；利用有限元控制方程，通过编程计算，对压电振子的力电耦合场参数进行了详细计算，得出了一些有价值的结论。

Similarly, if the strong shear, which could suppress all the scattering in the quiescent two phase region, stopped, the follow-up phase separation also displayed characteristics of anisotropism and relaxation, In this dissertation, the transposed"butterfly'and"streakpattern were observed for the first time within the shear-history-influenced phase separation, which is found closely relevant to the anisotropical relaxation behavior of macromolecules. 5. The phase separation kinetics of PS/PVME under oscillatory shear was further studied on the base of that done under simple shear. It is found that, under specific temperature and strain amplitude, the occurrence of phase separation is strongly contingent on oscillatory frequency and only intermediate frequency could effectively induce phase separation; If all considered oscillatory shear could stimulate phase separation, a fixed frequency can maintain specific most probable phase size and higher frequency yields smaller phase, which makes a higher elasticity but weaker stress relaxation; Furthermore, higher frequency can produces stronger compulsory oscillation on the MPPS but won't change the mean of the MPPS. Under given frequency and strain amplitude, the phase separation kinetics dramatically depends on the phase angle of oscillation and the phase separation corresponding to different phase angle follows different dynamical process.

在简单剪切场下相分离动力学研究的基础上进一步对振动剪切场下PS／PVME的相分离动力力学进行了尝试性的研究，发现：在一定温度和振幅条件下，相分离的发生强烈的依赖于振动频率，只有中等频率的振动剪切才能有效地促进相分离的发生；在都能使相分离发生的前提下，一定频率的剪切能够使体系维持一定的最可几相尺寸，较高频率的剪切导致体系形成的相区尺寸较小，因而体系的弹性效应较强而应力松弛效应较弱；同时，更高频率的剪切对最可几相尺寸的强迫振动效应越强，但不会使最可几相尺寸的平均值发生改变；在一定的振幅和频率条件下，相分离的动力学过程会强烈地依赖于相位角，不同相位角对应的相分离遵循不同的动力学过程但机理一样。

In Chapter 4, Short-time dynamic behavior of two-dimensional fully frustrated XY model near the Ising-like phase-transition temperature is studied with resistively shunted junction dynamics. The transition temperature and the dynamic and static critical exponents are estimated under both a periodic boundary condition and a fluctuating twist boundary condition using the short-time dynamic scaling analysis.

第四章应用电阻分流结动力学方法研究了完全阻挫XY模型在Ising型相变温度附近的短时动力学行为，运用短时动力学标度分析方法，我们得出了该模型在周期性边界条件下和涨落扭转边界条件下Ising型相变的临界温度和各种临界指数。

This paper mainly introduces experimental methods and basic principle about gelled acid reaction kinetics.

介绍了胶凝酸反应动力学的试验方法及基本原理，进行了普通酸和胶凝酸与灰岩的反应动力学试验，得到不同条件下的酸岩反应动力学参数及反应动力学方程，对优化碳酸盐岩油藏酸压设计有一定的指导作用。

The main contents include the kinematic and dynamic characteristics of floating body and concept about large body; the kinematic and dynamic conditions and governing equations for constrained floating body; illumination of simple harmonic by decomposition into diffraction and radiation; introduction of relevant effect forces; the formula of velocity potential in waters with constant depth; the scattering by a vertical cylinder with circular cross section.

简述浮体的运动及动力特征、大尺度物体的概念；受约束浮体的运动学及动力学条件及其控制方程；通过分解为绕射和辐射问题讲解简谐运动及有关的作用力；等水深地形上速度势的表达式；铅垂圆柱产生的散射。

The isothermal kinetics of nanogram obtained by MA has been studied in section three. The grain growth of α solid solution of Fe〓CuNb〓Si〓B〓 powders is controlled by a single kinetics within the experimental temperature range, the activation energy for grain growth is 80.3kJ/mol, magnetic properties of powders at different annealing and milling conditions are measured, a preliminary effort has been given to the consolidation of Fe〓CuNb〓Si〓B〓 powders.

第三部分研究了机械纳米晶化粉末的等温晶粒长大动力学，在实验研究的温度范围内，Fe〓CuNb〓Si〓B〓纳米晶α固溶体的晶粒长大由单一的动力学过程所控制，其晶粒长大激活能为80.3kJ/mol，研究了不同球磨条件及热处理条件下纳米晶粉末的磁性，对纳米晶粉末的成型进行了初步的尝试。

At first, the rought C〓F〓 mixed gases are obtained by pyrolysis process of R22. A experimental pyrolysis device is designed and made by ourself. The optimum operating conditions are offered in the paper. Secondly, the much efforts is on the synthesis of R134. After through the discussion of basic thermodynamics and kinetics, selecting and preparating catalyst, it is possible that the synthesis of R134 by pyrolyzed gases hydrogenation. Base on the character of catalytic process, the kinetics equation about C〓F〓 catalytic hydrogenation is established. The rate constant of the reaction is obtained through experiment data regression. In order to achieve higher yield of R134, some optimum technological conditions is determined.

论文首先对R22裂解制成四氟乙烯混合原料气的裂解过程进行了讨论，自行设计和制作裂解反应装置，并确定裂解反应的最佳操作条件；然后，重点对R134的合成进行基础研究，分别从热力学和动力学的角度探讨以含四氟乙烯的R22裂解混合气为原料合成R134这一全新工艺的可能性，选择和制备加氢催化剂，根据催化过程特点建立四氟乙烯催化加氢反应的总包动力学方程，并在此基础上自行设计和制作中试合成装置，获得了以裂解混合气为原料合成R134的最佳工艺条件，为R134的工业化生产提供了必要的理论依据和实验基础。

In this dissertation, according to the theory of Mechanical Dynamics and Multi-body Dynamics, a simulation model of NJ2046 light off-road vehicle including suspension system, steering system and tires is built with the software CarSim and so the vehicle steering characteristics are analyzed with the step angle input of steering wheel.

摘要本文根据机械系统动力学、多体动力学理论，运用动力学仿真软件CarSim建立了包括悬架系统、转向系统和轮胎等模型的NJ2046越野汽车整车仿真模型，在此基础上分析了NJ2046越野汽车在方向盘转角阶跃输入时的转向特性，通过对不同车速、不同载荷条件下的仿真计算，得出了在这些条件下该车具有的不同表现特征，揭示了转向特性与车速、载荷和轮胎的内在关系。

In the paper, adsorption equilibrium and kinetics of water in the solvents of benzene series and low-carbon alcohol on 3A zeolite molecular sieve were studied including effective pore size of zeolite, adsorbate concentration and temperature. The mechanism and characteristics of water adsorption in such systems, the effect of solvents to adsorption equilibrium and kinetics of water were discussed, and diffusivities of water under different conditions were obtained.

论文研究了苯系列物质—水体系、低碳醇—水体系中水在3A沸石上的吸附动力学，考察了沸石晶格窗口大小、吸附质浓度、温度等因素对吸附动力学的影响规律；分析了吸附机理以及两类体系的特点；通过数学模型对实验数据的拟合，求取了各种条件下的动力学参数；研究了两类体系的溶剂对吸附平衡和动力学的影响。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。