动力学

In the fifth chapter, the theory of photocatalytic degradation and kinetic study of methyl orange is carried out. Result of kinetic study show that the degradation reaction can be expressed by the first-order reaction kinetic model.

第五章以甲基橙为研究对象，研究了光催化反应动力学及其反应机理，结果表明，该反应降解可以用一级反应动力学方程进行描述。

This model includes not only the effects on the dynamic capability of wood-working circular saw machine by the structure and installing position of each rotary components(such as saw,flange, fastening nut,principle axis,pulley,and so on)of wood-working circular saw machine,but also the effects by the structural parameter,working parameter,and the installing position of the bearing axletree.

本文通过对木工圆锯机结构、支承轴承特性及工作过程的分析，以国产MJ-90精密裁板锯转子系统(锯片、塔轮、锯轴、夹持装置和支承轴承)为研究对象，首次将木工圆锯机旋转构件作为转子系统，运用美国Rotating Machinery Analysis公司开发的大型转子系统动力学商业软件包XLROTOR，建立了木工圆锯机转子系统动力学模型。

Its rule of change was obtained. On the basis of other studies, the flocculation kinetics and flocs structure was studied. By making some assumptions, collision frequency were presented. Then the the flocculation kinetics model was established through population balance equation. Comparison of experimental data and modeling results indicate that there are the same trend between the two. So the model can predict flocs number and size during flocculation of Yellow River's loess particles without using empirical parameters. The TEM and SEM were used to obsever flocs in the study of floc structure. The flocculation was divided as flocculi, floc and floc aggregate. The flocs structure model was established by assumption that particles position in floc accords with tetrahedron. The fractal dimension of model and experimental flocs was found to be coincident. So the model can reflect the structure of flocs formed in flocculation of Yellow River's loess particles by macromolecule flocculant at a certain extent.

最后，本文还对絮凝动力学和絮体结构进行了研究，在前人研究的基础上，针对高分子絮凝黄河泥沙，对絮凝过程作了一些符合试验条件的假设，建立了颗粒碰撞频率表达式，应用了颗粒数量平衡方程，从而建立了絮凝过程的动力学生长模型，模型计算结果与试验数据对比表明，二者趋势一致，在没有使用经验参数的情况下基本上能够描述黄河泥沙絮凝过程中絮体数量和尺寸分布的变化过程；对絮体结构的研究中，应用扫描电子显微镜和透射电子显微镜对絮体进行了观察，将絮体分为絮粒、絮团和絮网三个不同的生长阶段，通过假设颗粒结合位置符合正四面体，建立了絮体结构模型，计算得到的模型絮体分形维数基本与试验中的实际絮体相符，在一定程度上能眵反映高分子絮凝黄河泥沙生成的絮体结构。

Its rule of change was obtained.On the basis of other studies,the flocculation kinetics and floes structure was studied. By making some assumptions, collision frequency were presented.Then the the flocculation kinetics model was established through population balance equation. Comparison of experimental data and modeling results indicate that there are the same trend between the two. So the model can predict floes number and size during flocculation of Yellow River's loess particles without using empirical parameters.The TEM and SEM were used to obsever floes in the study of floe structure.The flocculation was divided as flocculi,floc and floe aggregate.The floes structure model was established by assumption that particles position in floe accords with tetrahedron.The fractal dimension of model and experimental floes was found to be coincidentSo the model can reflect the structure of flocs formed in flocculation of Yellow River's loess particles by macromolecule flocculant at a certain extent

最后，本文还对絮凝动力学和絮体结构进行了研究，在前人研究的基础上，针对高分子絮凝黄河泥沙，对絮凝过程作了一些符合试验条件的假设，建立了颗粒碰撞频率表达式，应用了颗粒数量平衡方程，从而建立了絮凝过程的动力学生长模型，模型计算结果与试验数据对比表明，二者趋势一致，在没有使用经验参数的情况下基本上能够描述黄河泥沙絮凝过程中絮体数量和尺寸分布的变化过程；对絮体结构的研究中，应用扫描电子显微镜和透射电子显微镜对絮体进行了观察，将絮体分为絮粒、絮团和絮网三个不同的生长阶段，通过假设颗粒结合位置符西安建筑科技大学博士学位论文合正四面体，建立了絮体结构模型，计算得到的模型絮体分形维数基本与试验中的实际絮体相符，在一定程度上能够反映高分子絮凝黄河泥沙生成的絮体结构。

Dynamics model of four-foot robotThe dynamics model of four-foot robot has been analyzed in detail with geometry and inertia parameter of pole.

利用杆件的具体几何和惯性参数对四足机器人的动力学运动方程做了详细分析，为今后的动力学研究奠定了基础。

The clearance cause more serious effect on the response of turret than that of the rotary table. This result agrees with the experimental response of roller gear indexing cam mechanism. In addition, some problems, such as the impacts on mechanism with clearance, effect on response for preload, effect for inertia of rotary table and stiffness of output-shaft, effect on wave of velocity and torsion for motor characteristic, and so on are investigated.

通过对扭转动力学模型的计算还对以下问题进行了研究：间隙造成的横越冲击的表现；预紧的存在对响应的影响；间隙的存在对有廓形误差的凸轮机构的动力学响应的影响；分度盘轴的刚度和载荷盘惯量对含间隙分度凸轮机构响应的影响；电机特性对转速波动和扭矩波动的影响等等。

The dynamical equations for a two-gimbal dynamically tuned gyro scope with mass unbalance in both the rotor and the gimbals are put forward as a development based on ideal suspension.

本文给出了转子和平衡环质量不平衡的双平衡环挠性陀螺的动力学方程，推广了理想情况下的陀螺动力学方程。

The actual reason is that firing process of gun system is a dynamic process, and it needs to be analyzed with dynamic methods.

这是因为火炮的射击过程是一个动力学过程，需要采用动力学分析方法。

The nature of hadrons and its dynamics of interaction are described with a clue of the structure of proton and neutron in this article, and a detailed introduction to quark model and quantum chromodynamics is also provided.

本文以质子、中子结构研究为线索，描述了强子性质和相互作用动力学，对夸克模型和量子色动力学做了详细介绍。

The kinetic equation of polyesterification proposed by Tang is discussed from the view point of the medium effect on the ionization of weak acids, so that the ionization constant, Ke, of the reacting acid would not be a constant during the course of poly-condensation and consequently the 21/z order kinetic equation would not be valid.

从弱酸电离的介貭效应讨论了唐敖庆的聚酯反应动力学方程。由于在缩聚过程中介貭性貭的改变，反应体系中羧酸的电离常数K_e不可能维持恒定，因此二级半动力学方程不能确立。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。