加速度

The accelerometer error m odel can be identified and the test points are the least by using this model.

该方法可以做到以最少的测试点数完成对加速度计三元二次多项式误差模型辨识。

Fuxian Lake looks temporary good and said to be oligotrophic, however, the external loading is implicitly but steadily accelerated.

抚仙湖看起来目前情况尚好，可以说寡营养，然而，外界负荷是潜在的，且是以稳定的加速度进行的。

A new mathematical model is put forward numerically to simulate the wheel ovalization.. In the numerical simulation, the dynamic model of a half railway vehicle coupled with a tangent track is employed. Using the new numerical method investigates vehicle-track coupling system dynamic responses including lateral and vertical displacement of wheelsets and the vehicle, lateral and vertical vibration acceleration of the track at different phase angle of the two side wheels of the same wheelset, which are compared with that of the traditional model. The numerical results show that the discipline and frequency of dynamic responses are accordant, amplitude and phase of lateral dynamic responses are different. It is concluded the traditional track geometric irregularity excitation model does not simulate the effect of periodic wheels ovalization on vehicle-track coupling system dynamic behavior truly, the new model is more accurate and reasonable.

本文研究了车轮二阶周期性非圆化—椭圆化，建立了一个新的模拟车轮椭圆化的数学模型，结合车辆－轨道空间耦合动力学模型，计算了同一轮对左右车轮不同相位和车轮椭圆度下轮对和车体的横、垂向位移，钢轨横、垂向振动加速度，并与传统模型计算结果作了对比，分析表明两种模型的动力响应变化规律和频率一致，但横向动力响应幅值和相位均存在不同程度不可忽略的差异，因此传统的轨道几何不平顺激励模型不能真实模拟车轮的周期性椭圆化对车辆－轨道耦合动态行为的影响，而本文模型更能反映实际椭圆车轮与钢轨接触情形，计算方法准确而合理。

The acceleration profile of the crane motion is designed to induce minimum payload pendulation during transpo rt,while the deceleration stage is designed to ensure freed om of residual oscillation near the end of the transport,and to deliver the payload at the target point.The techniques induce payload pendulation at least one half ofan oscillation cycle or integer multiples during each of the acceleration and deceleration stages.Starr(1995)designed a symmetric two-step acceleration and deceleration profile to transfer a suspended object.The duration on the constant acceleration steps is assumed to be negligible relative to the period of the payload oscillation.A linear approximation method of the oscillation period is used to generate the two-step symmetric acceleration profile.

3.1投入成型技术，各种形式的投入shapers ， convolved参考命令，产生形投入指挥，驾驶起重机提出一套距离沿一套path.the加速度概况起重机议案旨在诱使最低载重pendulation期间transpo rt ，虽然减速阶段，目的是确保freed om残余振荡接近尾声的运输，并交付载荷到达目标point.the技巧诱使载荷pendulation至少一半ofan振荡周期或整数倍数。

The result indicated that: the amount of the excess HF formed direct ratio to the yield of phosphorus pentafluoride and the optimum amount of the excess HF used is about 35%; the trickling rate of oleum shouldnt make the temperature of hexafluorophosphoric acid exceed 25 ℃ and the amount of oleum is 110% to 125% that of stoichiometry so that the content of phosphorus pentafluoride can be achieved 90%; the time and temperature of heating hexafluorophosphoric acid influenced both the yield and the content of phosphorus pentafluoride, and the optimum time should be about 30 minutes and the proper temperature was 148 to 153℃; when alcohol used asrefrigerant, the content of phosphorus pentafluoride was 94.03%, and the content can be up to 97.38%, provided that using liquid nitrogen as refrigerant.

通过实验发现，氟化氢用量与五氟化磷的产率成正比，最佳过量百分率宜在35％左右；发烟硫酸的滴加速度不能使中间产物温度大于25℃，发烟硫酸用量大于理论量10％～25％时，得到的五氟化磷纯度高于90％；六氟磷酸的加热温度对五氟化磷的产率和纯度均有影响，宜在148～153℃的范围内，加热时间应在30分钟左右；用工业酒精做冷凝介质得到的五氟化磷纯度最高只能到达94.03％，使用液氮做冷凝介质可以使五氟化磷的纯度达97.38％以上。

This paper describes the mechanism, construction and proporties of a piezo-electric accelerometer and a piezometric sensor based on piezoelectric effect .

本文叙述利用压电现象构成压电加速度和压力传感器的原理、结构性能。

Higter Piso than those with stable bladders, but the bladder capacity and the volume while feeling the first desire to void were decreased significantly in patients with detrusor instability than those with stable bladder.

再根据是否出现DI，把59例BPH病人分为不稳定膀胱组和稳定膀胱组，不稳定膀胱组的I-PSS、尿流加速度和Piso显著高于稳定膀胱组，初次尿液和膀胱最大容量显著低于稳定膀胱组。

Figure 1-5 Accelerograms of motions recorded at rock sites in San Fransisco Placing a porous overburden over the site will produce preconsolidation and result in increased pore pressures being required before liquefaction can occur.

图1-5提案加速度在SanFransisco录岩地点放置在一个站点将复盖多孔产生固结而导致孔隙压力增加液化可发生在被要求。

Firstly, the predesign is carried out by use of the conventional analysis, and then the acceleration curve of the cam driven component is processed and revised discretely according to the requirements of dynamics performance.. The design equation based on a Refined Finite-Difference Algorithm is established and the calculating process is realized by the computer programs. Consequently, the cam profile with good performance can be attained.

该方法先用常规解析法作初步设计，根据动力性要求对从动件加速度曲线进行离散化处理和修正，再用有限差分法建立凸轮型线的设计方程式，通过计算机程序进行计算求解，因而可以获得优良性能要求的凸轮型线。

If these results are applied in the current probabilistic seismic hazard analysis, then, for the lower annual frequency of exceedance of peak ground acceleration, the predicted α from the hazard curve could reduce by 30% or more compared with the current PSHA model used in the developing of seismic hazard map in the USA.

如果将所得的研究结果应用于概率地震危险性分析中，对于较低的年超越频度，近断层附近的地表峰值加速度的估算值可下降15%~30%。

She gently rebuff ed him, but agreed that they could be friends

她婉言拒绝了，但同意作为朋友相处。

If in the penal farm, you were sure to be criticized.

要是在劳改农场，你等着挨绳子吧！