加载的

You can simply start Keryx from any Internet machine, load the default project that fits your offline Ubuntu installation (karmic 32bit, karmic 64bit, etc), and you're ready to begin downloading software.

你可以很容易地在任何一台连接互联网的机器上启动Keryx，加载那些适合于你的离线Ubuntu系统（Karmic 32bit，Karmic 64bit等）的默认工程，然后开始软件下载。

A lot of experimental data have been accumulated to verify the model, including plastic damage under uniaxial tension, cyclic deformation behaviors and fatigue data for copper experimented by the author and biaxial deformation experiments done by Lamba [87] etc..

本文通过大量的试验资料对提出的模型进行了试验验证，包括黄铜单位塑性损伤、循环加载变形特性及疲劳寿命试验，另外还收集了国内外众多的试验数据对模型进行验证。

Study of multiaxial fatigue under nonproportional loading is developed in recent years.

多轴非比例循环加载下的低周疲劳研究就是在这样的背景下，在近几年发展起来的研究方向。

However, how to describe uniformly the non-proportionally multiaxial ratcheting and strain-controlled cyclic behavior is still a challenge.

但是，建立能统一描述材料的非比例应变循环、应力循环以及应力和应变组合的循环加载及其历史的本构模型仍是一个很大的挑战。

It sets up the single laneway model by combining the ides of loading the section over the point of laneway center line, solving the problem of nodical modeling by using the curve interpolation, and making the collision test came true when ramble by using the typical surround box method.

结合巷道中心线节点上加载断面的思想建立了单一巷道模型，利用曲线插值的方法解决了交点建模的问题，用经典包围盒法实现了漫游时的碰撞检测。

In the last two decades, lots of experimental and theoretic research on the hardening behavior and flow characteristics of metallic materials under nonproportional cyclic loading, and ratcheting for metallic materials has been done.

近年来，国内外不少学者对材料非比例应变循环加载下的材料循环附加硬化和流动特性进行了深入的研究，也对材料在应力循环下的棘轮行为进行了实验研究。

Present multiaxial fatigue life analysis method are discussed, and show that equivalent stress-strain approach based on uniaxial fatigue life analysis method can not predict low-cycle fatigue life under nonproportional cyclic loading.

对现有的多轴疲劳寿命分析方法进行了讨论，论证了以单轴疲劳寿命分析方法为基础的等效应变法不能预测多轴非比例加载下的低周疲劳寿命。

Third, the stress-strain and damage parameters on multiaxial fatigue damage critical planes were analyzed. A new multiaxial fatigue damage parameter was presented. This parameter can not only describe multiaxial proportional and nonproportional loading, but also uniaxial loading.

第三，对多轴疲劳损伤临界面上的应力应变及损伤参量进行了分析，在此基础上提出了一种新的多轴疲劳损伤控制参量，该参量不仅能够描述多轴比例与非比例加载下的疲劳损伤，而且可以退化成单轴的形式。

The hardening of the steel mayrelate to the shape of strain path under nonproportional cyclic straining. Experimental resultsshow that there exists a coupling between the hardening/softening induced by strainamplitude and that by the strain path.

在非比例循环加载条件下，材料的强化与路径形状密切相关实验表明，应变的幅值和路径方向的变化所造成的强化间存在耦合。

The biaxial nonproportional cyclic strap testsfor circular and rhombic strain paths, and the cyclic cachetting tests for four nonpmportinnalcyclic paths with mean stresses were conducted.

开展了圆形和菱形应变路径的双轴非比例循环加载试验；并进行了4种具有平均应力的非比例循环路径的循环棘轮试验。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷