加热管

The main products are: Hammer, thermal conductivity detector, permeameter, contraction of the expansion device, hand-held strain gauge, waterproof material detector, low-bending device, slag ball content in separators, heat load tester, performance test combustion furnace, a variety of thickness, thermal expansion of graphite electrode NG, coal strength meter, electric tamping device, hydrophobicity tester, mineral wool density meter, concrete drilling sampling machines, sawing machines, removed machine, setstube machine, hydraulic bending machine, impervious tester, determination of heat resistance, heating telescopic measuring device, an extension device, penetration tester, small meter, viscometer, drying time tester, pencil hardness tester, pendulum hardness, the adhesion tester, film zoned grid, and resistant to scrubbing detector, solvent resistance detector, wearable device, flat grinding device, wear-resistant coating shakeout device, staining resistance tester, impact tester , piercing instrument, instrument bending film, film coating, and sanding machines, cone-shaped grinding, high-speed dispersion machine, three roller grinder, Scratch tester, indentation tester, gloss Miriam, white tester, fresh video of Miriam, Miriam reflectivity, iron cobalt colorimeter, paint density cup, crack resistance testing apparatus, leveling device, flow hanging device, visual color box, the minimum temperature detector into a grinding, low temperature brittleness tester, visual color boxes, electronic pull machine, Mooney Viscometer, vulcanizing device, the proportion of direct-reading, the cold compression tester, heritage wearable device, Heritage scratch device, the friction coefficient detector, coating Detect zoned grid plate , coating resistance tester, such as burning a variety of test equipment.

主要产品有：回弹仪、导热系数测定仪、渗透仪、收缩膨胀仪、手持应变仪、防水材料检测仪、低温弯折仪、渣球含量分离器、热荷重试验仪、燃烧性能试验炉、各种测厚仪、石墨电极热膨胀仪、煤强度测定仪、电动击实仪、憎水性测试仪、矿棉容重测定仪、混凝土钻孔取样机、锯切机、磨平机、套丝切管机、液压弯管机、不透水试验仪、耐热性测定具、加热伸缩测定器、延伸仪、针入度仪、细度计、粘度计、干燥时间试验器、铅笔硬度计、摆式硬度计、附着力测试仪、漆膜划格器、耐洗刷测定仪、耐溶剂测定仪、耐磨仪、平磨仪、涂层落砂耐磨仪、耐沾污测试仪、冲击试验仪、穿孔仪、漆膜弯曲仪、涂膜涂布器、砂磨机、锥形磨、高速分散机、三滚研磨机、划痕试验仪、压痕试验仪、光泽仪、白度仪、鲜映性仪、反射率仪、铁钴比色计、涂料密度杯、抗裂性试验仪、流平仪、流挂仪、目视比色箱、最低成磨温度测定仪、低温脆性试验仪、目视比色箱、电子拉力机、门尼粘度仪、硫化仪、直读比重计、压缩耐寒试验仪、文物耐磨仪、文物划痕仪、摩擦系数测定仪、涂层检测划格板、涂层耐燃烧试验仪等多种试验仪器。

Electronic evidence from this crash may be superior to any physical evidence now being recovered. The possible culprit, the Pitot tube, sometimes fails because the heaters that keep Pitot tubes ice-free do not work.

电子数据将会比现在已经找到的一切物理证据都具有说服力，空速管--这个可能的罪魁祸首，有时不能正常工作是由于防止空速管冰冻的加热器没有正常工作引起的。

Using a RF antenna,around outside a glass or a quartz tube,which is resonant with the right hand polarized wave propagating in a magnetized plasma,very high density plasma may be produced by Landau damping mechanism.

利用一种环绕于玻璃管或石英管外壁的射频天线与磁化等离子体中的右旋极化波的共振，可以非常有效地通过朗道吸收加热电子，产生高密度等离子体。

Thermal comfort and indoor air quality requirements are presented; the contents cover the following topics:(1) Concept of air-conditioning,(2) Thermal principle,(3) Psychrometry and wetted-surface heat transfer,(4) Heating and cooling-load calculations,(5) Air-conditioning systems,(6) Fan and duct system,(7) Pumps and piping,(8) Cooling and dehumidifying coils,(9) Air-conditioning controls,(10) Absorption refrigeration,(11) Heat pump,(12) Cooling towers and evaporative condensers.

课程大纲本课程将介绍空调工程与系统设计，藉由湿空气线图讨论空气调节之过程，分析人体舒适与空气品质之需求，及各种空调设备系统之设计，内容涵盖如下：(1)空调的概念(2)热原理(3)湿空气与湿表面热传(4)加热与冷却负荷估算(5)空调系统(6)风扇与风管系统(7)泵与管路配置(8)冷却与除湿盘管(9)空调自动控制(10)吸收式冷冻系统(11)热泵(12)冷却水塔与蒸发式冷却。

This new type heat pipe was applied in a puddling process. The waste flue gas from the hot blast stove was used as the hot source to heat the cold mixture of compressed air and coal powder. The observed practical performance of the heat pipe showed a good agreement with the design expectation, which verified feasibility of using the separated type heat pipe for the heat transfer of the solid powder.

这种新型的分离式热管换热器应用于一个固相粉末换热系统——利用高炉热风炉的废烟气加热高炉喷煤用的空气和煤粉的混合物，实际运行工况与设计结果具有良好的一致性，可见利用套管结构的分离式热管作为以固相粉末为换热介质时的传热元件是完全可行的。

A common heating oxidation device(fig.1)is to place a silicon plate in a quartz crystal glass reaction chamber. In the reaction chamber, a electric resistant wire heating device heat up the chamber to a certain temperature(usually, the temperature is 900～1200℃. In a special condition, it can be descended to under 600℃). When oxygen or water vapour pass through the chamber(typical gas flow speed is 1cm/s). A chemical reaction is generated on surface of the silicon plate.

常用的热氧化装置（图1）将硅片置于用石英玻璃制成的反应管中，反应管用电阻丝加热炉加热一定温度(常用的温度为900～1200℃，在特殊条件下可降到600℃以下)，氧气或水汽通过反应管（典型的气流速度为1厘米/秒）时，在硅片表面发生化学反应

Designing and founding the thermoacoustic test-bed. The structure and dimension of condenser, heater, ejector, regenerator, sound room, feedback loop, resonance forthright and pulse tube refrigerator are showed detailed.

设计并搭建了热声驱动的脉管制冷系统试验台，对系统中的冷却器、加热器、喷射泵、回热器、声容、反馈回路、谐振直路及脉管制冷机等的结构尺寸做了详细介绍。

The amphiphilic octadecylamine is attached by two different methods: one isby ways of reacting with thionyl chloride SOCl_2 the other is heating directly.

经酰氯化和直接加热反应两种方法，在单壁碳纳米管表面分别嫁接了十八烷基胺，获得了溶于有机溶剂的单壁碳纳米管。

The drift and jitter of the output pulse are important parameters of the stability.The experiments and analyses based on homemade VE-4073 thyratron show that the combined effects of DC heating thyratron and two-pulse triggering technique can greatly reduce the drift and jitter of the pulser output.

利用国产VE-4073氢闸管进行了分析和实验研究，通过采用直流加热氢闸管灯丝和氢储存器，以及精确、稳定的双脉冲触发技术，大幅减小了开关脉冲发生器触发延时的抖动和漂移，48 h内开关脉冲发生器输出漂移仅6.1 ns。

The new creative equipment consists of dehumidifying and heating system inside a washstand; there is a sterilizing device in front of intake airway, and a position adjustable and flexible tube is used as an outtake airway.

这新创意设备是将除湿和加热系统装置於洗脸台内，杀菌装置设於入风口，另可任意调整位置的可挠风管作为出风管。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。