加热的

Thus, the heat content from the waste gases from blast heating apparatus or those arising in the afterburning of waste gas flows from tunnel driers for the removal of solvent residues can be fed back into the process via a heat transfer medium circuit to preheat the fuels and fuel air or to heat up the material to be dried.

因此，来自于废气/加热设备/燃烧形成的热气流/移走废弃的隧道干燥设备等的热量可以通过一个闭路循环的导热油把热量循环利用或者用来加热需要干燥的物质。

A process for treating the sludge generated by alumina sewage treating system incldues such steps as pumping the alumina sewage in sand depositing pool then in depositing pool, mixing the bottom sludge, the sewage from sand-water separator, and the regenerated water from filter to obtain backflush water, heating in desilicating heater, washing the secondary red mud to recover Na2O and Al2O3, anjd returning the washing liquid containing Na2O and Al2O3 back to the flow of production of alumina.

本发明公开了一种氧化铝废水处理系统的污泥处置新工艺，它将氧化铝废水先进入沉砂池中进行沉砂处理后才进入沉淀池中，将虹吸泥机从沉淀池中吸出的底流污泥和砂水分离器分离出的污水以及将部分经过滤器过滤后所得的再生水作为反冲洗水一起通过污泥泵送到脱硅加热器中加热得污泥热水，然后将污泥热水用于二赤泥洗涤沉降，以回收赤泥附着的Na2O和Al2O3，将洗涤赤泥后含有Na2O和Al2O3的洗液送到氧化铝生产流程中重新使用。

Based on deep understanding on the relation between the properties of biconical fibers and the fusion temperature, a problem of fusion temperature monitoring is solved by means of a ceramic microheater and a fiber pyrometer. Effects of the fusion temperature on optical properties of biconical fibers are studied quantitatively. Biconical fiber devices with various filtering spectra are fabricated. Experimental results agree well with theoretical predictions.

根据对双锥光纤成形及光学特性与加热温度的深入理解，采用陶瓷管辐射加热和光纤高温传感新技术，解决了长期以来熔锥温度不易监测的关键技术难点，定量研究了熔锥温度对双锥光纤光学特性的影响，研制出多种具有不同滤波谱形状的双锥光纤器件，实验与理论模型预测的结果一致。

This paper puts forward a kind of non-ablative wireless stem flow sensor on ZigBee, which heats up the stalk by the enwrapped calefaction probe and decides the heat transfer quantity of stem flow by the value of the temperature probe to calculate the plant transpiration rate.

蒸腾量是反映植物生理信息最重要的因素之一，本文通过包裹式的加热探头给茎杆加热，由温度测量探头来确定茎流的热传输量以推算出植物的蒸腾量，提出了一种基于ZigBee技术的非侵入式无线茎流传感器。

The composite film appeared semitransparent and brown to yellow from optical microscopy. Results show that shorter time sol-heating results in thiner film with less surface roughness, less conglutination to base, and easily to disconnect, while longer time sol-heating results in thicker film with better conglutination to base and worse roughness. RDX distributes in the film everywhere on the whole but discretely on the scale of 2.4 μm according to EDS results. XRD curve of RDX/RF film shows the superposition of RF non-crystal bread curve and RDX crystals diffraction curve. RDX diffraction peaks are broadened and its crystal size is calculated to be lower to 43 nm.

实验所得薄膜半透明，呈棕红色至黄色；实验表明，溶胶恒温加热时间较短时，所得薄膜的单层厚度较小，较平整，但附着力小，干燥后易脱落；恒温加热时间较长时，所得薄膜的单层厚度较大，不易脱落，但表面平整性较差；能谱测试表明，薄膜中的RDX整体上分布较为均匀，但在测试点位间距为2.4μm的微观尺度上呈离散状分布；XRD测试表明，RDX/RF复合物薄膜表现为RF的非晶态馒头峰与RDX衍射峰的叠加，RDX衍射峰明显宽化，其晶粒度可低至43 nm。

Because the heated air used as cooling medium for fast cooling down,it has several strongpoints,for example,its radiative coefficient is low,it can reduce the heat impact to the metal parts of steam turbine when it is heated to a suitable temperature,this method is easy to connect to a system and convenient to operate,and so on.

通过分析比较以上几种快速冷却方式，空气快速冷却以加热后的空气作为冷却介质，由于具有低的放热系数，加热到合适的温度可减少对汽轮机金属部件的热冲击，连接系统简单，操作简便等优点。

High pressure supply water heater uses discharge steam from steam turbine to heat supply water of boiler, and makes supply water to reach required temperature so as to improve thermal efficiency of power plant and to ensure output of the unit.

高压给水加热器是利用来自汽轮机的抽汽，来加热锅炉给水，使给水达到所要求的温度，从而提高电厂的热效率和保证机组的出力。

Through the test on physical properties of snow and ice, the free-area ratio, the snow-melting velocity and the snow-melting time, the melting behavior of snow and ice under different weather conditions are obtained and compared with simulated results.

在此基础上，提出了一种有利于系统节能的折中加热方案。3道路融雪实验研究建立了一个小型道路融雪实验系统，采用基于径向热流的直接加热法获得了水泥混凝土路面的导热系数，并初步分析了含水率对路面传热过程的影响。

For the proposed project the waste gas emission locations include: preheating furnace of hard alloy parts line (when natural gas is used for heating while excess heat heating system goes wrong), melting furnace, refining furnace, heat treatment furnace for machining unit and steam boiler. The pollutants are SO2, NOx and smoke dust contained in the smoke generated from the above locations. All the above pollution generating facilities use the most clean energy, natural gas, for burning. Meanwhile, on melting furnace and refining furnace low nitrogen combustion technology such as low NOx burner is applied, and the generated smoke is discharged via chimney.

拟建项目之废气排放部位为硬质合金件生产线的预热炉（余热加热系统故障采用燃天然气加热时）、熔化炉和精炼炉及机加工机组热处理炉和蒸汽锅炉，污染物为以上部位产生的烟气中含有SO2、NOx以及烟尘，以上各产污设备均采用最清洁的能源——天然气为燃料，同时熔化炉和精炼炉采用低NOx烧嘴等低氮燃烧技术，产生的烟气由烟囱排放。

It is a kind of inside heating by means of dipole's changeable polarization and polarization of interface of the medium, which have the dielectric loss in microwave heating.

微波对物质的作用很复杂，作为加热能源，它是靠介质的偶极子转向极化和界面极化在微波场中的介电耗损而引起的体内加热。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。