加热的

In this thesis, we use "Two-Step CVD Technique " to solve this problem, that is to carbonize Si substrate in carbide gas atmosphere first in order to form a Sio-rtd 0

将原先的热丝CVD法加热改为独创的石墨-碘钨灯加热，把衬底温度从900℃提高到1200℃；将手动控温改为PID自动控稳，大大提高了控制精度，实验中温度偏差小于1℃(衬底温度1200℃时)。

Give with ignition candle add heat heat, make two connect are put in difference in temperature, the finger of acute galvanometer will be apparent deflexion, this explained to electricity produces in loop.

用点燃的蜡烛给加热点加热，使两接头存在温差，灵敏电流计的指针会明显偏转，这说明回路中产生了电流。

As a matter of fact, the previous ways belong to resistance-heated method. Because of uneven heating and some other causes, these methods have a great harm to the life-span of electrolyzer.

这些方法从本质上来讲均属于电阻加热法，由于加热不均等原因，对铝电解槽的寿命都有致命的影响。

The efficiency of chemical heating with ferrosilicon and its effect on steel quality and erosion of ladle lining were studied.

研究了用硅系铁合金作发热剂加热钢液的加热效果以及对钢质量和炉衬耐火材料侵蚀的影响。

Air is heated in electric heater through the fan, then goes through the gas distributor into the fluidized bed dryer; and material enters the fluidized through the top. Materials keep fluidized in virtue of the flotage effect of the hot air. Energy and mass exchange in the fluid bed dryer.

流化床干燥过程：空气由鼓风机引入电加热器，加热后经布风板进入流化床，物料由流化床顶部预先加入，通过调整进风量，使物料在热空气的作用下保持流化状态，实现物料的流化干燥。

The character of heating distribution near the front and the action of diabetic heating frontogenesis on the frontal maintenance and movement are estimated by using the objective data.

利用锋面客观分析资料计算分析了南岭准静止锋锋面附近加热场的分布特征及非绝热加热锋生对锋面维持和锋面移动的作用。

To the flask and Condenser Horizontal and water, and ground magnetic float coat the mouth, steaming water connector and catheter installed, tightened their set screws tight, the rubber hose and gasket sets of quartz heating tube inserted mode of distillation, the fastening nut, the heating tube sign power supply cord into the outlet in the apparatus.

把各横式烧瓶和冷凝管及水位器、磨口外套磁性浮子，蒸水接头和导管安装好，拧紧各自的紧定螺丝，把橡胶管及垫片套在石英加热管分别插入模式蒸馏中，拧紧螺母，把加热管电源线插入仪器标志的插座中。

The originality of this design is that the hair drier and the electric iron have the same heating up system.

本设计基于电吹风和电熨斗的加热原理相通，加热功率相近的特点进行创新。

The effect of piston heating temperature on the piston assembling of 4125 diesel engine has been studied.

试验研究4125柴油机活塞加热温度对装配性的影响，从而降低了装配活塞的加热温度，节约了电能，改善了装配性。

The experiment indicated that the impact toughness is 2. 25 times as higher as MoSi〓 heating element.

测试结果表明，复合高温加热元件的冲击韧度是MoSi〓加热元件材料的2.25倍，提高了125%。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。