加热了的

Some tourist hotels in Beijing and elsewhere have tried to lure tourists 引诱旅游者 looking for a taste of old China 体验中国传统风味 by installing kangs heated by electricity.

北京和其它地方的一些旅行社备置了一些用电加热的炕来引诱那些寻求中国传统风味的旅游者。

The alkaline cementitiuos properties of calcining clay which contain kaoline and quartz is studied.

研究了含高岭石和石英的粘土加热脱水后，在碱激发剂的作用下系统的胶凝性质。

So ,the temperature is quite essential for an engine to produce power .No engines can work well without suitable operating temperatures .If the engine runs too hot ,it may suffer form pre-ignition,while the air-fuel change is ignited prematurely from excessive combustion chamber temperature.Viscosity of the oil circulating in an over heating engine is reduced.Hot oil also forms varnish and carbon deposits may be drawn into the combustion chamber where it increases HC emission.This also causes poor performance and premature wear ,and may even result in engine damage.What is more,the behavior of the metals at excessively high temperature also differs from that at normal temperatures and can produce a condition in which the metal deforms slowly and continuously at a constant stress,If the engine runs too cold, the fuel will not vaporize properly.If liquid fuel reachees the cylinders,it will reduce lubrication by washing the oil from the cylinder walls and diluting the engin oil.This causes a loss ofperformance, an inrease in HC emissions, and premature engine wear.

所以，温度是很有必要的引擎来产生电力，没有引擎，可以工作，如果没有合适的操作温度，如果发动机运行太热，它可能遭受的形式预点火，而空气燃料的改变是点火过早过量燃烧室temperature.viscosity的石油流通的过度加热发动机是reduced.hot油价也构成了清漆和碳存款可能会被拖入燃烧室而增加hc的emission.this也造成业绩不佳和过早磨损，甚至可能导致发动机damage.what更重要的是，行为的研究金属在过高的温度也有不同，在正常温度下，可以达到的一个条件，其中金属变形速度缓慢，不断在恒应力，如果发动机运行太冷了，燃料价格将不会汽化properly.if液体燃料reachees气瓶，将减少润滑洗油从气缸壁和稀释器oil.this造成损失ofperformance ， inrease在hc排放，发动机过早磨损。

Very clever. And to top it off, a feature we're thankfully seeing on more and more open-top models: Heated and cooled seats that only help to extend the driving season anywhere but San Diego.

很聪明。和最重要的了，一个功能我们正在庆幸看到越来越多的敞篷车型：加热及冷却的席位，只有帮助延长驾驶季节任何地方，但圣地亚哥。

The failure mechanisms and causes of the ruptured bolts of blind plate on a coal gas heater of 350 MW gas turbine generating unit were systematically studied.

对350 MW燃气轮机发电装置煤气加热器盲板上的螺栓断裂的失效机理及其起因进行了系统性的研究。

The numerical results of flow resistance and heat transfer agree well with experimental data.

用试验的方法确定了油焦浆管内等温流动的流动阻力计算方法和在搅拌加热器中传热努歇尔数的计算方法。

Field emission scanning electron microscope, X-ray diffraction and poresizer indicate the nanotubes are formed due to the competition of tin monoxide formation and dissolution under the assistance of electric field. The formation mechanism of nanotubes agrees with the theoretic model of oxidation-dissolution.

经场发射扫描电镜、X射线衍射和孔径分析仪分析显示，阳极氧化的前聚体是氧化亚锡，通过在空气中加热转化为二氧化锡，在详细研究制备条件和氧化锡孔道形貌的基础上，提出了氧化锡纳米孔的生成机理符合氧化溶解理论模型。

In actuator unit, the demand of parameters is analyzed, and it is brought forward that electric magnet is adopted as actuator, thermal resistance thread is adopted as cutter, and 5×5 cutter matrixes work synchronously for cutting the plastic film on each seedling.

在执行单元设计上，分析了其性能参数要求，提出利用电磁铁作为执行器，通电加热的电阻丝作为切破刀具，采用5×5的刀具矩阵同时动作使得电磁铁在动作时间内能处理每株棉苗上方的地膜。

The system through the temperature examination electric circuit sensation greenhouse big awning temperature change, gives monolithic integrated circuit processing through a/d conversion, through keyboard hypothesis upper limit temperature and lower limit temperature, when the greenhouse big awning temperature is lower than the hypothesis the temperature lower limiting value, start heater unit to greenhouse warming, when the greenhouse big awning temperature is higher than the hypothesis in the temperature the limiting value, stopped heating up, has realized the greenhouse big awning observation automation.

系统通过温度检测电路感知温室大棚温度变化，通过模数转换送给单片机处理，通过键盘设定上限温度和下限温度，当温室大棚温度低于设定的温度下限值时，启动点暖风机给温室加温，当温室大棚温度高于设定的温度上限值时，停止加热，实现了温室大棚测控的自动化。

The method of regulating top suction of checker chamber combusted lean gas in coke oven was found used of formula.

利用公式推导出调节焦炉贫煤气加热蓄热室顶部吸力的方法，结合生产中测量和调节蓄热室顶部吸力存在的问题，阐述了调节顶部吸力的基本原

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。