加热了的

The possibility of crack healing in high-speed steel was studied using the method of vacuum heating.

研究了高速钢裂纹在真空加热条件下实现愈合的可能性。

The heated Lucite Hull Cell which accommodates standard cathodes and anodes, is constructed on a special base accommodating a teflon coated stainless steel immersion heater (100 watt, 115/220 volts AC) and thermostatic control.

激烈的有机玻璃细胞船体可容纳标准阴极和阳极，构造一个特殊基地容纳了聚四氟乙烯涂层不锈钢沉浸式加热器(100瓦特，220分之115伏特AC)和恒温控制。

Introduction to the technical properties and design methods of induction heating, quenching and tempering treatment .

介绍了PC钢棒的技术性能要求，着重讨论了PC钢棒感应加热调质处理工艺参数的设计方法。

The variation laws of microstructure and strength of 1420 Al Li alloy ingot during the heating were studied.

研究了 14 2 0铝锂合金铸锭在加热过程中组织和强度的变化规律。

On the basis of these results, the impacts of horizontal inhomogeneous heating on the circulation are discussed.

在此基础上，深入研究了水平非均匀加热对大气环流的影响。

The temperature change of knitting needle s during quenching in the mesh-belt furnace was simulated using the ANSYS software.

针对织针网带炉淬火，利用有限元分析软件ANSYS，对织针加热过程中的温度变化进行了模拟。

Using a levitation coil, you levitate a conductive object in the magnetic field and heat within that field.

太酷了。用悬浮线圈，你可以把一个导电的工件磁悬浮起来加热。

Furthermore, TiCN nanocrystals were synthesized at 420 for 8h using TiCU, CCl4 and NaN3 via chemical metathesis method.

通过TiCl_4，CCl_4和NaN_3之间的化学交换反应，在420℃加热8小时也制备出了TiCN纳米晶体。

The experimental results show that the surface area and micropore area of the active coke increases with activating time.

利用XPS等分析手段对在电加热转炉上不同活化时间下制得的活性焦性质进行了研究。

This paper studied the thermal stability of Myrica rubra juice and concentrate under different temperatures and pH values.

本文研究了杨梅澄清汁及浓缩汁内花色苷在不同pH值和不同加热温度下的热稳定性。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。