加热了的

The coupling of heat and mass transfer of liquid desiccant regeneration in an air conditioning system was analyzed and the measures to increase the performance of regeneration were proposed. Then a liquid desiccant air-conditioning system was established which uses a counterflow packed tower as the regenerator with a heater in it and exhaust for regeneration.

分析了液体除湿空调再生过程热质交换的耦合特性，并提出了提高再生过程热质交换性能的措施，在此基础建立了液体除湿空调系统，其中再生器采用逆流式填料塔，在填料塔设置中间加热器，利用排风进行再生。

96H LC 0,96 h LC 50 ,and 96 h LC 100 of twelve chemicals of phenol ,alkyl benzene and nitrobenzene,and three water samples to sword fish(\%Xiphophorus helleri)\% and rare minnow(\%Gobiocypris rarus\%) were tested.3. The phenol ic waste water was purified through the absorption of polyvingl pyridine.

介绍了含酚废水与聚乙烯基吡啶类树脂接触，酚类会吸附在树脂上，使废水得到净化，然后将吸附了酚类的树脂加热处理回收酚，与此同时，对树脂也进行了再生处理，再生后的树脂可循环使

The mechanical properties of oil hardening and tempering spring wire were introducer in this paper, The process and system constitutes for spring wire with induction heating were proposed, The operation principle of this system was also discussed.

介绍了油回火弹簧钢丝的力学性能，给出了油回火弹簧钢丝感应加热生产工艺流程及系统组成，简述了系统各部分的技术功能及特点。

A new type of narrow-hole-plate film-former with a sprayer is put forward.

本文系统地研究了高浓料液降膜真空蒸发的分布成膜装置，进行了加热系统、分离冷凝系统的结构优化，引入变频调速控制技术，对控制系统进行了完善，提出了一些新的观点和方法，具体研究工作和创新之处摘要如下

The influence of a thin-film vaporizer on the properties of liquid rubber product was studied.

研究了薄膜蒸发器对液体橡胶产品性能的影响，考察了刮板线速度、进料速度、胶浆含水量、加热温度、系统真空度对干燥效率的影响规律，并与釜式干燥方式作了对比。

The impact inflame damage experiments with simulative fuel tanks of the cruise missile heated to the temperature of 75℃ were carried out by use of round fragments at different incidence angles accelerated by a balli.

利用弹道枪加速发射钢球破片，以不同入射角对加热至75℃的模拟巡航导弹燃油舱等效靶进行了冲击引燃毁伤作用实验，研究了模拟巡航导弹燃油舱在不同打击条件下的毁伤模式，分析了其毁伤机理，给出了模拟巡航导弹燃油舱在不同打击条件下的冲击引燃判据。

First, some critical problems in crystal growth like crystal seeding, Zn dephlegmation, geometrical selection and temperature fields are discussed in theory, and the possible kinds of defects appeared in crystal growth progress and the reasons are carefully researched. To control the concentration of Cd vacancies, a new method by which the Cd vacancies were compensated with excess Cd in the Cd rich starting materials has been developed, and a new kind of two-area tube furnace with good linear temperature distribution was designed.

首先，本文从理论上对坩埚下降法生长碲锌镉单晶体中的成核、Zn分凝、几何淘汰生长与温场等关键性问题进行了讨论，对在生长过程中可能出现的各种缺陷类型和形成原因进行了详细分析，提出了碲锌镉单晶体生长过程中Cd空位缺陷控制原理及方法，并针对坩埚下降法生长特点自行设计了两区域独立加热管式生长炉，获得具有较好线性分布的温场。

The effect of parameter upon performs, the microstructures produced from spray forming process, and the hot isostatic pressing process were studied.

研究了材料的显微组织以及沉积态合金在加热保温过程中的组织转变规律，确定了热等静压温度，进行了热等静压致密化处理。

Then the production process is generated and the closed oxygen-enriched rotary furnace heated by electromagnetic induction is chosen as the equipment for high solubility technical molybdic oxide production.

从MoO2氧化动力学过程及热力学过程入手，对MoO2氧化成MoO3可能性及各种参数分析，对生产炉窑的选型作了分析论证，制定了高溶性工业氧化钼的生产工艺并选取了采用电磁感应加热式密闭、富氧回转窑作为高溶性工业氧化钼生产设备。

In the XTMMC Group's development history,the company hadundertaken al new built.technical innovation,medium and complete overhaul projects; designed and constructed 2rollblank productionlinesforiron foundry workshop and steel foundry workshop,7rollmachining and heat-treament production lines;assembled about 4000 sets equipment;new built and innovated 180 sets melting iron, melting steel and heat-treatment kilns;finished major office building,residential quarter,hospital,school and kindergarten etc.construction projects occupied are a 1.62 million square meter,Toral invsetment in technical innovation and capital construction is 2.45 billi on Yuan.

在邢机几十年的建设史上，承担了所有新建、技改及大中修项目，先后设计和建设完成了铸钢、铸铁两条轧辊毛坯生产线；轧辊加工及热处理生产线七条；安装设备4000余台套；新建炼钢、炼铁加热及热处理等工业炉窑180余台，并全部承担其大修及改造任务。完成了办公大楼、生活住宅楼、医院、学校、幼儿园等配套设施的建设任务，累计完成建筑面积162万平方米。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。