加热了的

This paper puts forward a kind of non-ablative wireless stem flow sensor on ZigBee, which heats up the stalk by the enwrapped calefaction probe and decides the heat transfer quantity of stem flow by the value of the temperature probe to calculate the plant transpiration rate.

蒸腾量是反映植物生理信息最重要的因素之一，本文通过包裹式的加热探头给茎杆加热，由温度测量探头来确定茎流的热传输量以推算出植物的蒸腾量，提出了一种基于ZigBee技术的非侵入式无线茎流传感器。

2Graduate School of Chinese Academy of Sciences, Beijing 100049, ChinaAbstract: Two sets of dehydrationmelting with a natural solid amphibolite(56vol.% hornblende, 43vol.% plagioclase), collected from the DabainengLeyu profile in the southern Ailaoshan orogenic belt, Honghe County, Yunnan Province, have been carried out in multianvil apparatus(YJ3000t and JL3600t) at 1035 GPa and 950 ℃ for 20300 h. One is keeping the temperature at 950 ℃ and the annealing time of 100 h, varying the pressure (1035 GPa). The other is keeping the pressure at 30 GPa and temperature at 950 ℃, varying the annealing time (20300 h). The products are inspected with microscope and electron probe.

利用YJ3000t和JL3600t多顶砧压力机，以哀牢山造山带南部红河县大白能-乐育剖面上的天然块状斜长角闪岩为初始样品，在950 ℃、10~35 GPa、恒温20~300 h条件下进行了两个系列的斜长角闪岩块状样品脱水部分熔融实验：(1)保持温度T=950 ℃，加热时间t=100 h不变，改变压力(10~35 GPa)的实验；(2)保持温度T=950 ℃，压力p=30 GPa不变，改变加热时间(20~300 h)的实验。

Firstly, with the thermal conduction equations of second homogeneous boundary and non-homogeneous boundary condition,we gained the temperature distribution in and after the heating process of the absorbing cavity.

用第二非齐次边界条件和第二齐次边界条件的热传导方程分别建立了吸收腔在激光加热过程中和激光加热结束后的温度分布，利用模拟实验对激光照射吸收腔的过程进行模拟，得到内、外壁温度差的实验数据。

And give a close study of the smolder ing velocities of polyurethane foam under different heat fluxes.

分析对比了相同加热条件下的聚氨酯泡沫材料在有氧和无氧气氛下的升温过程，并对不同加热条件下的聚氨酯泡沫材料的阴燃传播速度进行研究。

Taking U71Mn steel as an example, the effect of heating time, protective material and rolling deformation rate on decarburization and oxidation of the slab has been studied by observing the changes of the slab's decarburized layer during the course of heating and rolling.

本文结合武钢大型厂U71Mn重轨钢，通过观察在加热和轧制过程中的钢坯脱碳层的变化，研究了加热时间、保护涂料和轧制变形率对重轨钢坯脱碳和氧化的影响。

In this paper, the heating source of large vaporizer of LNG terminal in our country is ascertained from the comparison between air-heating vaporizer and liquid-heating vaporizer on the basis of design data.

基于中国某LNG接收站内大型汽化器的设计参数，从液体加热型汽化器和空气加热型汽化器的对比入手，确定了大型LNG汽化器的热源。

Traditional Method of holocellulose content detection was improved. Waler-bath heating was replaced by microwave irradiation. By the microwave-assisted method, holocellulose and its alpha-cellulose content in straw material were detected.

将传统的造纸原料的综纤维素提取方法进行改进，使用微波加热代替传统的水浴加热，并对稻草原料进行了综纤维素含量及综纤维素中α-纤维素含量测定。

The test results indicate that T2 Cu/2A50 Al alloy must first be done by blacksmith welding, and then heated between 515℃ and 525℃ for 180 min, the sample pressure is offered by heating and insulation in the process through special fixture, the joints of T2Cu/2A50Al alloy with metallurgy bond can be obtained, and there is obvious welding seam in the interface.

试验结果表明，T2铜／2A50铝合金，采用先锻接，后加热到515~525℃之间，保温180 min，并在加热和保温过程中通过特殊的夹具提供给试样压力，能得到冶金结合的T2铜／2A50铝合金接头，接头界面处出现了明显的焊缝。

One is low valence vanadium oxide thin films were deposited by direct current facing target magnetron sputtering firstly, and then thermal oxidated; the other is high valence vanadium oxide thin films were deposited by ion beam sputtering, then thermal deoxidated. Vanadium oxide thin films with phase transition were obtained at the lower thermal process temperature 300℃, which is compatible with MEMS technologys. The composition of VO_x thin film fabricated by first method includes mainly VO_2, V2O3 and VO_, the TCR is -2.25%/K, the TCR gradually increases with phase transition temperature decreases. The composition of VO_x thin film fabricated by the second method includes mainly VO_2, V2O5 and V2O3 , and the resulting VO_x thin filmTCR is -3.0%/K. The TCR of phase transition vanadium oxide thin films made by second method is higher than that made by first method for the existance of V2O5 in thin films.

分别采用直流对靶磁控溅射制备低价态氧化钒薄膜再附加热氧化处理的方式，和射频离子束溅射制备高价氧化钒薄膜附加热还原处理的方式获得了具有相变特性的氧化钒薄膜，第一种方式获得相变特性氧化钒薄膜的热处理温度最低为300℃，克服了以往高温条件下热处理不能与MEMS工艺兼容的缺点；相变特性氧化钒薄膜的组分以VO_2为主，含有V2O3和VO_，室温TCR为-2.25%/K；室温电阻温度系数随相变温度的降低逐渐升高；采用第二种方式获得的相变氧化钒薄膜的组分以VO_2为主，含有V2O5和V2O3，室温TCR可达-3.0%/K；分析发现，具有相变特性的氧化钒薄膜中含有V2O5时，室温电阻温度系数明显增大。

Based on this, combining with q-γ-τ matrix equation, the paper constructs matrix analysis models for calculating thermal economic and conversion factor of three typical auxiliary steam-water namely: in-out system from steam side of heater, water...

在此基础上，结合 q-γ-τ矩阵方程，针对三类典型辅助汽水(从加热器汽侧进、出系统、从加热器水侧进、出系统和纯热量进、出系统)，构造了相应的热经济性局部分析模型和转换系数λ的计算模型，具有通用性较强，宜于程序化的特点。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。