加热

Ice-dielectric heating occurs most strongly at the voltage antinodes in the standing wave pattern, whereas skin-effect heating occurs most strongly at the current antinodes.

冰介质加热时发生最强烈的电压波腹的驻波模式，而皮肤的作用最强烈加热发生在当前波腹。

Bedsides,it improves its safety even in the high drying temperature. 5.The fixed scraper device makes the cleaning quickly and easily.

用蒸汽加热时，蒸汽操作压力允许范围比传统盘式干燥机大提高，在达到较高干燥温度的同时又提高了操作的安全性（用蒸汽加热时传统盘式干燥机必须按压力容器管理）。

Considering the characteristics of coke oven, the combusting MAS control model is given combining with forward and feedback, control and operation manager.

面对焦炉加热系统的多变量、耦合特性，提出前馈与反馈相结合、控制与操作管理相融合的焦炉加热MAS控制模型。

Cabin ventilated, and warmed and demisted by air from combustion heater, which also heats passenger cabin when fitted.

机舱通风，加热及空气demisted从燃烧炉，也加热时，客舱安装。

One is low valence vanadium oxide thin films were deposited by direct current facing target magnetron sputtering firstly, and then thermal oxidated; the other is high valence vanadium oxide thin films were deposited by ion beam sputtering, then thermal deoxidated. Vanadium oxide thin films with phase transition were obtained at the lower thermal process temperature 300℃, which is compatible with MEMS technologys. The composition of VO_x thin film fabricated by first method includes mainly VO_2, V2O3 and VO_, the TCR is -2.25%/K, the TCR gradually increases with phase transition temperature decreases. The composition of VO_x thin film fabricated by the second method includes mainly VO_2, V2O5 and V2O3 , and the resulting VO_x thin filmTCR is -3.0%/K. The TCR of phase transition vanadium oxide thin films made by second method is higher than that made by first method for the existance of V2O5 in thin films.

分别采用直流对靶磁控溅射制备低价态氧化钒薄膜再附加热氧化处理的方式，和射频离子束溅射制备高价氧化钒薄膜附加热还原处理的方式获得了具有相变特性的氧化钒薄膜，第一种方式获得相变特性氧化钒薄膜的热处理温度最低为300℃，克服了以往高温条件下热处理不能与MEMS工艺兼容的缺点；相变特性氧化钒薄膜的组分以VO_2为主，含有V2O3和VO_，室温TCR为-2.25%/K；室温电阻温度系数随相变温度的降低逐渐升高；采用第二种方式获得的相变氧化钒薄膜的组分以VO_2为主，含有V2O5和V2O3，室温TCR可达-3.0%/K；分析发现，具有相变特性的氧化钒薄膜中含有V2O5时，室温电阻温度系数明显增大。

Machine work, dehumidification within the host opened the door, outside the doors closed, private environment-friendly desiccants absorb moisture inside, and then close the inner door, outer door opened, dedicated heater heating the desiccant to evaporate into water vapor outside the box, the above link automatic cycle, and gradually reduce the humidity inside.

机器工作时，除湿主机内门打开，外门关闭，专用环保型干燥剂吸取箱内水汽，之后内门关闭，外门打开，加热器加热专用干燥剂，使水汽蒸发到箱外，以上环节自动控制循环进行，逐步降低箱内湿度。

The rapid water desorption from zeolites by using microwave heating is primarily researched, the results shows that the rate of desorbing is doubled by using microwave heating than by using common heating method.

本文对微波加热使沸石快速脱水也进行了初步研究，结果表明利用微波加热比传统的传热方式可使沸石分子筛的脱水速率增加一倍。

The main results were obtained as follows:(1) The calculation results of temperature field indicate that, 6139T radiator was brazed using the stage-by-stage heating process, while 6204T radiator with a larger size was brazed using the temperature difference heating process. The uniform temperature distributions in faying faces were all obtained. And the temperatures were in the range of brazing temperature. It is proved that the finite element models established are reasonable.

取得的主要结果和结论为：(1)温度场计算结果表明，对于6139T散热器，采用分阶段加热钎焊工艺，而对于具有较大尺寸的6204T散热器，采用温差法加热钎焊工艺时，均获得了均匀的钎焊面温度分布，且在钎焊温度范围之内，证明所建立的有限元分析模型是合理的。

This furnace is supported for each kind of material drying equipment as a kind of general hot air unit, which is widely used for dehumidification of cereal, seed, feed and fruit, heating and wet extraction of vegetables, mushroom, jew's-ear, tea, tobacco, food, pharmaceutical products, chemical raw materials and light and weight industrial products, as well as for heating of various facilities and dehumidification of warehouses.

该炉为通用性热风装置，与各种物料的干燥设备配套使用。广泛用于粮食、种子、饲料、果品脱水、蔬菜、香菇、木耳、银耳、茶叶、烟叶等产品、食品、医药品、化工原料、轻重工业的产品的加热除湿，还可用于各种设施的加热以及库房除湿等。

A method of forming a glass melt including heating a glass feed material in a first melting furnace to form a glass melt, flowing the glass melt into a second melting furnace through a refractory metal connecting tube, and further heating the glass melt in the second melting furnace.

一种形成玻璃熔体的方法，包括在第一熔炉中加热玻璃进料以形成玻璃熔体，使玻璃熔体经耐火金属联结管流入第二熔炉，和在第二熔炉中进一步加热玻璃熔体。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。